Energy and exergy efficiency analysis of solar driven ejector–compressor heat pump cycle

Solar Energy ◽  
2016 ◽  
Vol 125 ◽  
pp. 243-255 ◽  
Author(s):  
Gang Yan ◽  
Tao Bai ◽  
Jianlin Yu
2019 ◽  
Vol 111 ◽  
pp. 04028
Author(s):  
Milan Gojak ◽  
Tamara Bajc

More than one third of the world’s primary energy demand refers to residential sector. Heating is considered as one of the main part of the energy consumption in buildings. In this study, a thermodynamic sustainability assessment analysis of different energy sources for heating of residential building, with net floor heated area of 162 m2, for Belgrade weather data, was presented. Five options of energy sources were studied, namely: coal, natural gas, electricity, district heating and air-water heat pump. Energy and exergy analyses were conducted and appropriate efficiencies were determined. Energy and exergy flows in boundaries of the building and in the whole chain from primary to final values were analyzed. The environmental impact factor and exergetic sustainability index were determined for all considered energy sources. The exergy efficiency is very low in all analyzed cases, which further implies poor thermodynamic compatibility of energy quality from the supplied side and the energy used for building heating. It was shown that the highest exergy efficiency is for the case of heat pump utilization (about 6%), due to the energy used from environment. The minimum environmental impact factor (15.37) and maximum exergetic sustainability index (0.065) were found for the case of heat pump utilization.


Author(s):  
Mohammed El Hadi Attia ◽  
Abd Elnaby Kabeel ◽  
Abdelkader Bellila ◽  
Athikesavan Muthu Manokar ◽  
Ravishankar Sathyamurthy ◽  
...  

2020 ◽  
Vol 5 (1) ◽  
pp. 563-572
Author(s):  
Iman Golpour ◽  
Mohammad Kaveh ◽  
Reza Amiri Chayjan ◽  
Raquel P. F. Guiné

AbstractThis research work focused on the evaluation of energy and exergy in the convective drying of potato slices. Experiments were conducted at four air temperatures (40, 50, 60 and 70°C) and three air velocities (0.5, 1.0 and 1.5 m/s) in a convective dryer, with circulating heated air. Freshly harvested potatoes with initial moisture content (MC) of 79.9% wet basis were used in this research. The influence of temperature and air velocity was investigated in terms of energy and exergy (energy utilization [EU], energy utilization ratio [EUR], exergy losses and exergy efficiency). The calculations for energy and exergy were based on the first and second laws of thermodynamics. Results indicated that EU, EUR and exergy losses decreased along drying time, while exergy efficiency increased. The specific energy consumption (SEC) varied from 1.94 × 105 to 3.14 × 105 kJ/kg. The exergy loss varied in the range of 0.006 to 0.036 kJ/s and the maximum exergy efficiency obtained was 85.85% at 70°C and 0.5 m/s, while minimum exergy efficiency was 57.07% at 40°C and 1.5 m/s. Moreover, the values of exergetic improvement potential (IP) rate changed between 0.0016 and 0.0046 kJ/s and the highest value occurred for drying at 70°C and 1.5 m/s, whereas the lowest value was for 70°C and 0.5 m/s. As a result, this knowledge will allow the optimization of convective dryers, when operating for the drying of this food product or others, as well as choosing the most appropriate operating conditions that cause the reduction of energy consumption, irreversibilities and losses in the industrial convective drying processes.


Author(s):  
Mohammed El Hadi Attia ◽  
Abd Elnaby Kabeel ◽  
Abdelkader Bellila ◽  
Athikesavan Muthu Manokar ◽  
Ravishankar Sathyamurthy ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document