Performance of solar photovoltaic modules under arid climatic conditions: A review

Solar Energy ◽  
2018 ◽  
Vol 174 ◽  
pp. 409-421 ◽  
Author(s):  
Maxime Mussard ◽  
Mohamed Amara
2015 ◽  
Vol 725-726 ◽  
pp. 1512-1518 ◽  
Author(s):  
Meri Cvetkovska ◽  
Vera Murgul ◽  
Ekaterina Aronova ◽  
Nikolay Vatin ◽  
Maxim Shvarts

In this paper the Energy-plus house project, functioning under the climate conditions of Macedonia, was presented. On the basis of previous studies carried out for a single-family house, the concept of a fully non-volatile home using solar photovoltaic modules for the operation of the electrical equipment was designed according to "Passive house". The estimates of solar resources of the territory, defined energy input of solar radiation on differently oriented surfaces and selected the optimum tilt angle of PV modules to the horizon were presented for this article. It is shown that the solar modules generated enough electricity to meet the needs of the considered house. At the same time in the summer there is surplus electricity. The calculations presented in this paper were based on the methods of thermodynamics, using MKS EN and DIN standards, the program packages PHPP 2007, as well as the algorithm developed for calculating the amount of solar radiation on differently oriented surfaces.


2021 ◽  
Author(s):  
Madhura Yeligeti ◽  
Wenxuan Hu ◽  
Yvonne Scholz ◽  
Kai von Krbek

<p>Solar photovoltaic (PV) systems will foreseeably be an integral part of future energy systems. Land cover area analysis has a large influence on estimatiin of long-term solar photovoltaic potential of the world in high spatial detail. In this regard, it is often seen in contemporary works, that the suitability of various land cover categories for PV installation is considered in a yes/no binary response. While some areas like natural parks, sanctuaries, forests are usually completely exempted from PV potential calculations, other land over categories like urban settlements, bare, sparsely vegetated areas, and even cropland can principally support PV installations to varying degrees. This depends on the specific land use competition, social, economic and climatic conditions, etc. In this study, we attempt to evaluate these ‘factors of suitability’ of different land cover types for PV installations.</p><p>As a basis, the openly available global land cover datasets from the Copernicus Land Monitoring Service were used to identify major land cover types like cropland, shrubland, bare, wetlands, urban settlements, forests, moss and snow etc. For open area PV installations, with a focus on cropland, we incorporated the promising technology of ‘Agri-voltaics’ in our investigation. Different crops have shown to respond positively or negatively, so far, to growing under PV panels according to various experimental and commercial sources. Hence, we considered 18 major crops of the world (covering 85% of world cropland) individually and consequently, evaluated a weighted overall suitability factor of cropland cover for PV, for three acceptance scenarios of future.</p><p>For rooftop PV installations in urban areas, various socio-economic and geographical influences come in play. The rooftop area available and further usable for PV depends on housing patterns (roof type, housing density) which vary with climate, population density and socio-economic lifestyle. We classified global urban areas into several clusters based on combinations of these factors. For each cluster, rooftop area suitability is evaluated at a representative location using the land cover maps, the Open Street Map and specific characteristics of the cluster.</p><p>Overall, we present an interdisciplinary approach to integrate technological, social and economic aspects in land cover analysis to estimate PV potentials. While the intricacies may still be insufficient for planning small localized energy systems, this can reasonably benefit energy system modelling from a regional to international scale.</p>


Author(s):  
Mansour Zegrar ◽  
M’hamed Houari Zerhouni ◽  
Mohamed Tarik Benmessaoud ◽  
Fatima Zohra Zerhouni

In recent years, solar photovoltaic energy is becoming very important in the generation of green electricity. Solar photovoltaic effect directly converts solar radiation into electricity. The output of the photovoltaic module MPV depends on several factors as solar irradiation and cell temperature. A curve tracer is a system used to acquire the PV current-voltage characteristics, in real time, in an efficient manner. The shape of the I-V curve gives useful information about the possible anomalies of a PV device. This paper describes an experimental system developed to measure the current–voltage curve of a MPV under real conditions. The measurement is performed in an automated way. This present paper presents the design, and the construction of I-V simple curve tracer for photovoltaic modules. This device is important for photovoltaic (PV) performance assessment for the measurement, extraction, elaboration and diagnose of entire current-voltage I-V curves for several photovoltaic modules. This system permits to sweep the entire I-V curve, in short time, with different climatic and loads conditions. An experimental test bench is described. This tracer is simple and the experimental results present good performance. Simulation and experimental tests have been carried out. Experimental results presented good performance.


2020 ◽  
Vol 5 (1) ◽  
pp. 46-52
Author(s):  
Nguyen Viet Linh Le ◽  
Tri Hieu Le ◽  
Thi Minh Hao Dong ◽  
Van Vang Le ◽  
Dinh Tung

Recently, due to global warming and urbanization, there are many major cities that may face the challenge of day zero next decades. Obviously, water is an indispensable component for maintaining life on the earth. Although portable water is required of the hour, the quantity of available freshwater is impacted significantly by sea-level rise and pollution from industrialization. As a consequence of the global water crisis, different methods for clean water production from brackish water have been studied and developed in practice, however, the solar distillation of water is the most economical and desirable approach due to this method utilize solar energy that is the environmentally friendly and economical resource. Over the last 15 years, the impressive price drop of the photovoltaic solar collector (PV/T) makes them popular and easy to access. As a result, the employment of PV/T in solar stills is emerging as a potential device for water distillation. Therefore, in this paper, an active solar distiller combined with a photovoltaic panel has been reviewed for improvement of the distillate yield and effectiveness of solar photovoltaic. This review work presents a variety of studies on various types of solar still (for example conventional solar still (CSS), double slope solar still (DSSS), stepped solar distiller, and cascade solar still) couples with different solar water collectors (such as flat plate collector (FPC) and evacuated tubes collector (ETC)) and solar photovoltaic modules. It is obtained that the hybrid PV/T active solar still improves the distillate yield, energy efficiency, and exergy efficiency as compared to passive mode. The cooling method enhances the performance of the photovoltaic solar collector as well as the productivity of solar still. Moreover, the environmental economic estimation reveals that the solar still coupled with the PV/T mitigated considerably the amount of CO2. It can be stated that it is suitable to commercialize the hybrid PV/T active solar still for supplying not only electricity but drinking water also. Finally, this review paper also suggests the scope for the research in the future.


Sign in / Sign up

Export Citation Format

Share Document