Influence of annealed ITO on PLD CZTS thin film solar cell

2019 ◽  
Vol 358 ◽  
pp. 762-764 ◽  
Author(s):  
Guang-Xing Liang ◽  
Yan-Di Luo ◽  
Ju-Guang Hu ◽  
Xing-Ye Chen ◽  
Yang Zeng ◽  
...  
2014 ◽  
Vol 1638 ◽  
Author(s):  
Hongtao Cui ◽  
Xiaolei Liu ◽  
Xiaojing Hao ◽  
Fangyang Liu ◽  
Ning Song ◽  
...  

ABSTRACTThe focus of this work is on back contact improvement for sputtered CZTS thin film solar cells. Three methods have been investigated including a thin Ag coating, a thin ZnO coating on the Mo back contact and rapid thermal annealing of the back contact. All of these methods have been found to reduce defects such as voids as well as secondary phases at the back contact region and inhibit the formation of MoS2. Consequently all the mothods effectively enhances Voc, Jsc, FF and therefore efficiency significantly.


Solar Energy ◽  
2014 ◽  
Vol 100 ◽  
pp. 23-30 ◽  
Author(s):  
Tara P. Dhakal ◽  
Chien–Yi Peng ◽  
R. Reid Tobias ◽  
Ramesh Dasharathy ◽  
Charles R. Westgate

2013 ◽  
Vol 716 ◽  
pp. 328-331 ◽  
Author(s):  
Min Yao ◽  
Cheng Wu Shi ◽  
Yan Ru Zhang ◽  
Xiao Yan Dai

Cu2ZnSnS4(CZTS) thin film was successfully prepared by pulsed laser deposition using CZTS nanocrystal as a source and the thin film solar cell with the novel structure of FTO/CdS/CZTS/Mo was assembled. At the laser incident energy of 6 J·cm-2, the chemical composition of the CZTS thin film was Cu1.74Zn0.80Sn1.00S4.04,near to stoichiometric ratio. The thin film solar cell with the novel structure of FTO/CdS/CZTS/Mo gave short circuit photocurrent density of 1.01 mA·cm-2, open circuit voltage of 0.39 V, and fill factor of 0.485, corresponding to the photoelectric conversion efficiency of 0.19% at the illumination (Air Mass 1.5, 100 mW·cm-2).


Sign in / Sign up

Export Citation Format

Share Document