Low temperature amorphous to anatase phase transition of titanium oxide nanotubes

2019 ◽  
Vol 680 ◽  
pp. 68-74 ◽  
Author(s):  
Aaron Kirkey ◽  
Jun Li ◽  
T.K. Sham
RSC Advances ◽  
2016 ◽  
Vol 6 (84) ◽  
pp. 81426-81435 ◽  
Author(s):  
Ermias Libnedengel Tsege ◽  
Gyu Han Kim ◽  
Venkateswarlu Annapureddy ◽  
Beomkeun Kim ◽  
Hyung-Kook Kim ◽  
...  

A novel, flexible lead-free piezoelectric nanogenerator was developed using a uniform BaTiO3 film; synthesized by in situ conversion of titanium oxide nanotubes in a low temperature hydrothermal process.


2004 ◽  
Vol 52 (4) ◽  
pp. 479-487 ◽  
Author(s):  
Cs. Pribenszky ◽  
M. Molnár ◽  
S. Cseh ◽  
L. Solti

Cryoinjuries are almost inevitable during the freezing of embryos. The present study examines the possibility of using high hydrostatic pressure to reduce substantially the freezing point of the embryo-holding solution, in order to preserve embryos at subzero temperatures, thus avoiding all the disadvantages of freezing. The pressure of 210 MPa lowers the phase transition temperature of water to -21°C. According to the results of this study, embryos can survive in high hydrostatic pressure environment at room temperature; the time embryos spend under pressure without significant loss in their survival could be lengthened by gradual decompression. Pressurisation at 0°C significantly reduced the survival capacity of the embryos; gradual decompression had no beneficial effect on survival at that stage. Based on the findings, the use of the phenomena is not applicable in this form, since pressure and low temperature together proved to be lethal to the embryos in these experiments. The application of hydrostatic pressure in embryo cryopreservation requires more detailed research, although the experience gained in this study can be applied usefully in different circumstances.


JETP Letters ◽  
2020 ◽  
Vol 112 (8) ◽  
pp. 471-477
Author(s):  
V. S. Krivobok ◽  
A. V. Kolobov ◽  
S. E. Dimitrieva ◽  
D. F. Aminev ◽  
S. I. Chentsov ◽  
...  

Materials ◽  
2019 ◽  
Vol 12 (4) ◽  
pp. 566 ◽  
Author(s):  
M. Akhtar ◽  
Ahmad Umar ◽  
Swati Sood ◽  
InSung Jung ◽  
H. Hegazy ◽  
...  

This paper reports the rapid synthesis, characterization, and photovoltaic and sensing applications of TiO2 nanoflowers prepared by a facile low-temperature solution process. The morphological characterizations clearly reveal the high-density growth of a three-dimensional flower-shaped structure composed of small petal-like rods. The detailed properties confirmed that the synthesized nanoflowers exhibited high crystallinity with anatase phase and possessed an energy bandgap of 3.2 eV. The synthesized TiO2 nanoflowers were utilized as photo-anode and electron-mediating materials to fabricate dye-sensitized solar cell (DSSC) and liquid nitroaniline sensor applications. The fabricated DSSC demonstrated a moderate conversion efficiency of ~3.64% with a maximum incident photon to current efficiency (IPCE) of ~41% at 540 nm. The fabricated liquid nitroaniline sensor demonstrated a good sensitivity of ~268.9 μA mM−1 cm−2 with a low detection limit of 1.05 mM in a short response time of 10 s.


Sign in / Sign up

Export Citation Format

Share Document