Nyquist plots under frequency transformations

2019 ◽  
Vol 125 ◽  
pp. 16-21
Author(s):  
Arturo Buscarino ◽  
Luigi Fortuna ◽  
Mattia Frasca
2021 ◽  
pp. 1-1
Author(s):  
Maide Bucolo ◽  
Arturo Buscarino ◽  
Luigi Fortuna ◽  
Mattia Frasca

Materials ◽  
2021 ◽  
Vol 14 (15) ◽  
pp. 4215
Author(s):  
Roxana E. Patru ◽  
Hamidreza Khassaf ◽  
Iuliana Pasuk ◽  
Mihaela Botea ◽  
Lucian Trupina ◽  
...  

The frequency and temperature dependence of dielectric properties of CH3NH3PbI3 (MAPI) crystals have been studied and analyzed in connection with temperature-dependent structural studies. The obtained results bring arguments for the existence of ferroelectricity and aim to complete the current knowledge on the thermally activated conduction mechanisms, in dark equilibrium and in the presence of a small external a.c. electric field. The study correlates the frequency-dispersive dielectric spectra with the conduction mechanisms and their relaxation processes, as well as with the different transport regimes indicated by the Nyquist plots. The different energy barriers revealed by the impedance spectroscopy highlight the dominant transport mechanisms in different frequency and temperature ranges, being associated with the bulk of the grains, their boundaries, and/or the electrodes’ interfaces.


2008 ◽  
Vol 13 (11) ◽  
pp. 1715-1722 ◽  
Author(s):  
D. Colorado-Garrido ◽  
D. M. Ortega-Toledo ◽  
J. A. Hernández ◽  
J. G. González-Rodríguez ◽  
J. Uruchurtu

Author(s):  
L. I. Menegbo ◽  
J. L. Konne ◽  
N. Boisa

The Electrochemical Impedance Spectroscopy (EIS) measurements of Sol-gel synthesized ZnO, CuO and their respective hydrogenated phases (ZnO:H and CuO:H) for  a proton-type battery model has been reported for the first time. The XRD patterns confirmed that CuO and ZnO were phase pure with minor impurities. However, that of CuO:H showed mixed phases of CuO and Cu2O with the later  appearing prominent. The estimated particle sizes of ZnO, ZnO:H, CuO and CuO:H obtained using Scherrers’ equation were 17.83, 17.75, 21.63 and 15.42 nm respectively, showing remarkable particle size reductions upon hydrogenation as oxygen vacancies were substituted with smaller hydrogen ions. Nyquist plots from the EIS experimental data recorded over a frequency range of 100 kHz – 5 mHz showed expected flat semicircles at the high frequency region and straight lines at the low frequency regions while resistance estimations from the intercepts of the Bode plots were 12.10, 7.80, 16.00 and 10.80 Ω for ZnO, ZnO:H, CuO and CuO:H respectively. It also indicated high gain margins suggesting impressive electrochemical properties for battery applications.


2021 ◽  
Author(s):  
Indrajit Dey ◽  
Pallabi Manna ◽  
Muralidhar Yadav ◽  
Nisith Kumar Tewary ◽  
Jayanta Kumar Saha ◽  
...  

In the present research, the effects of various alloying elements and microstructural constituents on the mechanical properties and corrosion behaviour have been studied for four different rebars. The microstructures of stainless steel and plain rebar primarily reveal equiaxed ferrite grains and ferrite-pearlite microstructures, respectively, with no evidence of transition zone, whereas tempered martensite at the outer rim, followed by a narrow bainitic transition zone with an internal core of ferrite-pearlite, has been observed for the thermomechanically treated (TMT) rebars. The hardness profiles obtained from this study display maximum hardness at the periphery, which decreases gradually towards the centre, thereby providing the classical U-shaped hardness profile for TMT rebars. The tensile test results confirm that stainless steel rebar exhibits the highest combination of strength (≈755 MPa) and ductility (≈27%). It has been witnessed that in Tafel plots, the corrosion rate increases for all the experimental rebars in 1% HCl solution, which is well expected because the acid solutions generally possess a higher corrosive environment than seawater (3.5% NaCl) due to their acidic nature and lower pH values. However, all the experimental results obtained from Tafel and Nyquist plots correlate well for both 1% HCl and 3.5% NaCl solutions.


2020 ◽  
Vol 28 (14) ◽  
pp. 20379
Author(s):  
Hsuan-Hao Lu ◽  
Bing Qi ◽  
Brian P. Williams ◽  
Pavel Lougovski ◽  
Andrew M. Weiner ◽  
...  

2021 ◽  
pp. 377-403
Author(s):  
Geoffrey Brooker

“Stability of negative feedback” discusses the measures that must be taken to guarantee that a negative-feedback system is stable. Examples are given of frequency dependences using Bode and Nyquist plots. Safety margins are quantified by means of gain margins and phase margins; the desirability of a minimum-phase-lag network. A design procedure is formulated. There is discussion of Nyquist (conditional) stability, and how it may be achieved by judicious introduction of a non-linearity. A demonstration circuit shows that these measures can yield Nyquist stability with safety.


Sign in / Sign up

Export Citation Format

Share Document