Reinterpretation of adcoh and cocorp seismic reflection data with constraints from detailed forward modeling of potential field data — Implications for Laurentia-Peri-Gondwana suture

2017 ◽  
Vol 712-713 ◽  
pp. 426-437 ◽  
Author(s):  
Patrick D. Duff ◽  
James N. Kellogg
1994 ◽  
Vol 31 (4) ◽  
pp. 619-628 ◽  
Author(s):  
John Mariano ◽  
William J. Hinze

Integrated interpretations of potential-field and GLIMPCE and industry seismic reflection data in eastern Lake Superior reveal the structural and stratigraphic complexity of the Midcontinent Rift in this region. Projection of the Keweenaw fault into southeastern Lake Superior suggested by early potential-field studies is confirmed by seismic reflection data. Analysis of seismic data in conjunction with aeromagnetic anomalies and regional gravity data also reveals a continuous section of basalt in the footwall of the Keweenaw fault. The lateral dimensions of this section vary along the strike of the rift from the center of the basin towards the southern flank. Spatially extensive anticlinal and synclinal features, reverse faults and related drag folds imaged by the reflection and enhanced potential-field data attest to the influence of a late-stage compressional event in this region. East-northeast trending gradients and displacements associated with observed potential-field anomalies and fault traces mapped at the surface also indicate a degree of accommodation perpendicular to the strike of the rift. These trends parallel the prevalent tectonic grain in the adjacent Archean basement rocks, perhaps suggesting that structures within the rift were in part controlled by preexisting crustal features.


Geophysics ◽  
2011 ◽  
Vol 76 (1) ◽  
pp. SA19-SA34 ◽  
Author(s):  
Shohei Minato ◽  
Toshifumi Matsuoka ◽  
Takeshi Tsuji ◽  
Deyan Draganov ◽  
Jürg Hunziker ◽  
...  

Crosswell reflection method is a high-resolution seismic imaging method that uses recordings between boreholes. The need for downhole sources is a restrictive factor in its application, for example, to time-lapse surveys. An alternative is to use surface sources in combination with seismic interferometry. Seismic interferometry (SI) could retrieve the reflection response at one of the boreholes as if from a source inside the other borehole. We investigate the applicability of SI for the retrieval of the reflection response between two boreholes using numerically modeled field data. We compare two SI approaches — crosscorrelation (CC) and multidimensional deconvolution (MDD). SI by MDD is less sensitive to underillumination from the source distribution, but requires inversion of the recordings at one of the receiver arrays from all the available sources. We find that the inversion problem is ill-posed, and propose to stabilize it using singular-value decomposition. The results show that the reflections from deep boundaries are retrieved very well using both the CC and MDD methods. Furthermore, the MDD results exhibit more realistic amplitudes than those from the CC method for downgoing reflections from shallow boundaries. We find that the results retrieved from the application of both methods to field data agree well with crosswell seismic-reflection data using borehole sources and with the logged P-wave velocity.


2016 ◽  
Vol 4 (3) ◽  
pp. SH1-SH9
Author(s):  
Steven D. Sloan ◽  
J. Tyler Schwenk ◽  
Robert H. Stevens

Variability of material properties in the shallow subsurface presents challenges for near-surface geophysical methods and exploration-scale applications. As the depth of investigation decreases, denser sampling is required, especially of the near offsets, to accurately characterize the shallow subsurface. We have developed a field data example using high-resolution shallow seismic reflection data to demonstrate how quickly near-surface properties can change over short distances and the effects on field data and processed sections. The addition of a relatively thin, 20 cm thick, low-velocity layer can lead to masked reflections and an inability to map shallow reflectors. Short receiver intervals, on the order of 10 cm, were necessary to identify the cause of the diminished data quality and would have gone unknown using larger, more conventional station spacing. Combined analysis of first arrivals, surface waves, and reflections aided in determining the effects and extent of a low-velocity layer that inhibited the identification and constructive stacking of the reflection from a shallow water table using normal-moveout-based processing methods. Our results also highlight the benefits of using unprocessed gathers to pragmatically guide processing and interpretation of seismic data.


Geophysics ◽  
2011 ◽  
Vol 76 (2) ◽  
pp. B55-B70 ◽  
Author(s):  
E. M. Takam Takougang ◽  
A. J. Calvert

To obtain a higher resolution quantitative P-wave velocity model, 2D waveform tomography was applied to seismic reflection data from the Queen Charlotte sedimentary basin off the west coast of Canada. The forward modeling and inversion were implemented in the frequency domain using the visco-acoustic wave equation. Field data preconditioning consisted of f-k filtering, 2D amplitude scaling, shot-to-shot amplitude balancing, and time windowing. The field data were inverted between 7 and 13.66 Hz, with attenuation introduced for frequencies ≥ 10.5 Hz to improve the final velocity model; two different approaches to sampling the frequencies were evaluated. The limited maximum offset of the marine data (3770 m) and the relatively high starting frequency (7 Hz) were the main challenges encountered during the inversion. An inversion strategy that successively recovered shallow-to-deep structures was designed to mitigate these issues. The inclusion of later arrivals in the waveform tomography resulted in a velocity model that extends to a depth of approximately 1200 m, twice the maximum depth of ray coverage in the ray-based tomography. Overall, there is a good agreement between the velocity model and a sonic log from a well on the seismic line, as well as between modeled shot gathers and field data. Anomalous zones of low velocity in the model correspond to previously identified faults or their upward continuation into the shallow Pliocene section where they are not readily identifiable in the conventional migration.


2020 ◽  
Author(s):  
Pei Yang ◽  
J.Kim Welford

<p>In past years, a good understanding of the structure and tectonics of the Flemish Cap and the Goban Spur margin has been obtained based on seismic data, potential field data, and borehole data. However, due to limited data coverage and quality, the rift-related domains along the margin pair have remained poorly defined and their architecture has been primarily delineated on the basis of a small number of co-located 2-D seismic profiles. In addition, according to previous studies, the geophysical characteristics (e.g. velocity structure, crustal thickness, seismic patterns, etc.) across both the margins are strikingly different. Furthermore, from restored models of the southern North Atlantic, some scholars argue against the linkage of the Goban Spur and the Flemish Cap, questioning the widely-accepted “conjugate” relationship of the two margins. However, these restored models are mainly dependent on potential field data analysis, lacking seismic constraints, particularly for the Irish Atlantic Margin.</p><p>In this study, new long offset 2D multichannel seismic data, acquired in 2013 and 2014 by Eni Ireland for the Department of Communications, Climate Action & Environment of Ireland, cover the shelf, slope, and deepwater regions of the offshore Irish Altlantic margin. Combining these with seismic reflection data at the NE Flemish Cap, seismic refraction data, DSDP drilling sites, gravity and magnetic maps, crustal thickness maps, and oceanic isochrones, we integrate all constraints together to characterize the structure and evolution of both margins. These geophysical data reveal significant along-strike structural variations along both margins, and aid to delimit five distinct crustal zones related to different rifting stages and their regional extents. The geometries of each crustal domain are variable along the margin strike, probably suggestive of different extension rates during the evolution of the margin and/or inherited variations in crustal composition and rheology. Particularly, the along-strike exhumed serpentinized mantle domain of the Goban Spur margin spans a much wider (~ 42 - 60 km) area while it is much narrower (~25 km) at the NE Flemish Cap margin. In the exhumed domain, only peridotite ridges are observed at the Flemish Cap, while both peridotite ridges and a wide region of exhumed mantle with deeper basement are observed at the Goban Spur, indicative of a more complex evolutionary model than previously thought for both margins. Plate reconstruction of the Goban Spur and the Flemish Cap using GPlates reveals asymmetry in their crustal architectures, likely due to rift evolution involving more 3-D complexity than can be explained by simple 2-D extensional kinematics. In spite of uncertainties, the crustal architecture comparison between the two margins provides 3D seismic evidence related to the temporal and spatial rifting evolution on both sides.</p>


2016 ◽  
Vol 106 (3) ◽  
pp. 899-915 ◽  
Author(s):  
João Carvalho ◽  
Carlos Inverno ◽  
João Xavier Matos ◽  
Carlos Rosa ◽  
Isabel Granado ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document