A method for determining quantum yields for solid-state photochemical reactions

1971 ◽  
Vol 53 (1) ◽  
pp. 81-85 ◽  
Author(s):  
E.Lynn Simmons ◽  
W.W. Wendlandt
ChemInform ◽  
2007 ◽  
Vol 38 (1) ◽  
Author(s):  
Lyubov S. Klimenko ◽  
Soltan Z. Kusov ◽  
Vladislav M. Vlasov ◽  
Elena N. Tchabueva ◽  
Vladimir V. Boldyrev

2016 ◽  
Vol 12 ◽  
pp. 825-834 ◽  
Author(s):  
Andreea Petronela Diac ◽  
Ana-Maria Ţepeş ◽  
Albert Soran ◽  
Ion Grosu ◽  
Anamaria Terec ◽  
...  

New indeno[1,2-c]pyran-3-ones bearing different substituents at the pyran moiety were synthesized and their photophysical properties were investigated. In solution all compounds were found to be blue emitters and the trans isomers exhibited significantly higher fluorescence quantum yields (relative to 9,10-diphenylanthracene) as compared to the corresponding cis isomers. The solid-state fluorescence spectra revealed an important red shift of λmax due to intermolecular interactions in the lattice, along with an emission-band broadening, as compared to the solution fluorescence spectra.


2018 ◽  
Vol 5 (7) ◽  
pp. 180245 ◽  
Author(s):  
Tingting Yu ◽  
Haijiao Wang ◽  
Chongzheng Guo ◽  
Yanli Zhai ◽  
Jianzhou Yang ◽  
...  

The emerging carbon quantum dots (CQDs) have been attracting significant attention for their prominent fluorescence, excellent stability and outstanding biocompatibility. Here, we report a facile one-step synthesis of highly fluorescent CQDs by using phthalic acid and triethylenediamine hexahydrate as precursors through a simple microwave-assisted method. The reaction time needed is only 60 s, which is less time-consuming than most previous reports. The phthalic acid with a benzene ring can improve the photoluminescence properties of CQDs as it can provide foreign sp 2 conjugating units, and then finally result in long-wavelength emission. The synthesized CQDs were fully characterized by transmission electron microscopy, X-ray photoelectron spectroscopy and Fourier transform infrared spectroscopy. Besides, the impacts of different freed ratio on physical and chemical properties of CQDs were investigated in detail. The prepared CQDs exhibited strong green fluorescence with a broad maximum emission wavelength. The quantum yields of the CQDs can reach 16.1% in aqueous solution and they were successfully used in cell imaging with good biocompatibility. Moreover, in solid state, the CQDs with the feed ratio of 1 : 0.5 showed a strong green–yellow fluorescence which may have great potential to fabricate optoelectronic devices. Furthermore, the prepared CQDs also showed high pH sensitivity and can act as a fluorescence nanosensor for pH sensing.


2020 ◽  
Author(s):  
Dominik Göbel ◽  
Daniel Duvinage ◽  
Tim Stauch ◽  
Boris Nachtsheim

Herein, we present minimalistic single-benzene, excited-state intramolecular proton transfer (ESIPT) based fluorophores as powerful solid state emitters. The very simple synthesis gave access to all four regioisomers of nitrile-substituted 2(oxazolinyl)phenols (MW = 216.1). In respect of their emission properties they can be divided into aggregation-induced emission enhancement (AIEE) luminophores (1-CN and 2-CN), dual state emission (DSE) emitters (3-CN) and aggregation-caused quenching (ACQ) fluorophores (4‐CN). Remarkably, with compound 1-CN we discovered a minimalistic ESIPT based fluorophore with extremely high quantum yield in the solid state ΦF = 87.3% at λem = 491 nm. Furthermore, quantum yields in solution were determined up to ΦF = 63.0%, combined with Stokes shifts up till 11.300 cm–1. Temperature dependent emission mapping, crystal structure analysis and time-dependent density functional theory (TDDFT) calculations gave deep insight into the origin of the emission properties.<br>


Molecules ◽  
2020 ◽  
Vol 25 (3) ◽  
pp. 445 ◽  
Author(s):  
Monika Cekaviciute ◽  
Aina Petrauskaite ◽  
Sohrab Nasiri ◽  
Jurate Simokaitiene ◽  
Dmytro Volyniuk ◽  
...  

Aiming to design blue fluorescent emitters with high photoluminescence quantum yields in solid-state, nitrogen-containing heteroaromatic 9,9-dimethylacridine was refined by tetraphenylethene and triphenylethene. Six tetra-/triphenylethene-substituted 9,9-dimethylacridines were synthesized by the Buchwald-Hartwig method with relatively high yields. Showing effects of substitution patterns, all emitters demonstrated high fluorescence quantum yields of 26–53% in non-doped films and 52–88% in doped films due to the aggregation induced/enhanced emission (AIE/AIEE) phenomena. In solid-state, the emitters emitted blue (451–481 nm) without doping and deep-blue (438–445 nm) with doping while greenish-yellow emission was detected for two compounds with additionally attached cyano-groups. The ionization potentials of the derivatives were found to be in the relatively wide range of 5.43–5.81 eV since cyano-groups were used in their design. Possible applications of the emitters were demonstrated in non-doped and doped organic light-emitting diodes with up to 2.3 % external quantum efficiencies for simple fluorescent devices. In the best case, deep-blue electroluminescence with chromaticity coordinates of (0.16, 0.10) was close to blue color standard (0.14, 0.08) of the National Television System Committee.


1995 ◽  
Vol 413 ◽  
Author(s):  
Christoph Weder ◽  
Michael J. Wagner ◽  
Mark S. Wrighton

ABSTRACTIn an effort to better understand the relationship between molecular structure and photophysical properties, we have prepared and investigated a series of novel poly(2,5-dialkoxy-p-phenyleneethynylene)s. Wide angle X-ray diffraction measurements show that the supramolecular structure can be easily and significantly influenced by the nature of substituents covalently linked to the rigid-rod polymer main chains. Polymers which have sterically hindered side chains are essentially amorphous, while those with only linear side chains can form lamellar structures with a significant degree of long-range order. High photoluminescence quantum yields, up to 0.86 in solution and 0.36 in the solid state, have been measured. While the solution quantum yields are independent of the functionalization, solid state quantum efficiencies were found to be related to the degree of long-range order in the samples. In samples with a high degree of long-range order, the close proximity of the coplanar oriented polymer backbones is assumed to lead to the formation of eximer complexes which provide non emissive decay channels and, hence, result in comparable low photoluminescence quantum yields. In samples that adopt only a small extent of long-range order, the rigid-rod conjugated polymer backbones behave as if they were ‘dissolved’ in a hydrocarbon solvent and consequently high quantum efficiencies are obtained. Preliminary results indicate the suitability of these polymers as the emitting layer in electroluminescent devices.


2020 ◽  
Vol 56 (68) ◽  
pp. 9775-9778 ◽  
Author(s):  
Isabel-Maria Ramirez y Medina ◽  
Markus Rohdenburg ◽  
Enno Lork ◽  
Anne Staubitz

For the first time, six classical stannoles with photoluminescence quantum yields of up to 11.1% in the crystalline state and 24.4% in the thin film state are presented.


Sign in / Sign up

Export Citation Format

Share Document