Abstract
Martensitic stainless steels are suitable for diverse structural applications but degrade when subjected to wear-prone activities in service. To enhance their service life, the densification of high Cr, martensitic, X190CrVMo20-4-1 tool steel powder on two different martensitic stainless steel substrates via supersolidus liquid-phase sinter (SLPS) cladding was investigated. The objective was to assess the influence of the difference in compositions of the martensitic stainless steels employed as substrates on the interfacial diffusion, microstructure, hardness and bonding strength of the steel-to-steel claddings. Computational thermodynamics and diffusion simulations were employed to supplement experimental findings. Owing to interdiffusion, a M7C3 carbide-free, banded region exists in the X190 adjacent to the interface with the width dictated by chemical potential gradient of carbon. The hardness of the substrate was lower near the interface region because of carbon enrichment, which promoted the presence of retained austenite. An interfacial strength of 798 MPa was achieved with fairly ductile X190 matrix near the cladding interface as the fracture surface was characterized by mixed fracture modes of dimple rupture and cleavage with localized quasi-cleavage features. Experimental observations and computational simulations are in agreement. The implications of the SLPS cladding technique are discussed in the context of tool development.
Improvement of mechanical properties of liquid phase sintered low alloy steel powder compacts by addition of TiC.