scholarly journals Two- and three-dimensional wake transitions of an impulsively started uniformly rolling circular cylinder

2017 ◽  
Vol 826 ◽  
pp. 32-59 ◽  
Author(s):  
F. Y. Houdroge ◽  
T. Leweke ◽  
K. Hourigan ◽  
M. C. Thompson
Keyword(s):  
Stability Analysis ◽  
Circular Cylinder ◽  
Rapid Development ◽  
Three Dimensional ◽  
Reynolds Numbers ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Instability Modes ◽  
Two Dimensional Flow ◽  
Lift And Drag

This paper presents the characteristics of the different stages in the evolution of the wake of a circular cylinder rolling without slipping along a wall at constant speed, acquired through numerical stability analysis and two- and three-dimensional numerical simulations. Reynolds numbers between 30 and 300 are considered. Of importance in this study is the transition to three-dimensionality from the underlying two-dimensional periodic flow and, in particular, the way that the associated transitions influence the fluid forces exerted on the cylinder and the development and the structure of the wake. It is found that the steady two-dimensional flow becomes unstable to three-dimensional perturbations at $Re_{c,3D}=37$, and that the transition to unsteady two-dimensional flow – or periodic vortex shedding – occurs at $Re_{c,2D}=88$, thus validating and refining the results of Stewart et al. (J. Fluid Mech. vol. 648, 2010, pp. 225–256). The main focus here is on Reynolds numbers beyond the transition to unsteady flow at $Re_{c,2D}=88$. From impulsive start up, the wake almost immediately undergoes transition to a periodic two-dimensional wake state, which, in turn, is three-dimensionally unstable. Thus, the previous three-dimensional stability analysis based on the two-dimensional steady flow provides only an element of the full story. Floquet analysis based on the periodic two-dimensional flow was undertaken and new three-dimensional instability modes were revealed. The results suggest that an impulsively started cylinder rolling along a surface at constant velocity for $Re\gtrsim 90$ will result in the rapid development of a periodic two-dimensional wake that will be maintained for a considerable time prior to the wake undergoing three-dimensional transition. Of interest, the mean lift and drag coefficients obtained from full three-dimensional simulations match predictions from two-dimensional simulations to within a few per cent.

Cellular flow in a partially filled rotating drum: regular and chaotic advection

2017 ◽  
Vol 825 ◽  
pp. 631-650 ◽  
Author(s):  
Francesco Romanò ◽  
Arash Hajisharifi ◽  
Hendrik C. Kuhlmann
Keyword(s):  
Three Dimensional ◽  
Reynolds Numbers ◽  
Chaotic Advection ◽  
Two Dimensional ◽  
Rotating Drum ◽  
Three Dimensional Flow ◽  
Dimensional Flow ◽  
Heteroclinic Connection ◽  
Two Dimensional Flow ◽  
Chaotic Streamlines

The topology of the incompressible steady three-dimensional flow in a partially filled cylindrical rotating drum, infinitely extended along its axis, is investigated numerically for a ratio of pool depth to radius of 0.2. In the limit of vanishing Froude and capillary numbers, the liquid–gas interface remains flat and the two-dimensional flow becomes unstable to steady three-dimensional convection cells. The Lagrangian transport in the cellular flow is organised by periodic spiralling-in and spiralling-out saddle foci, and by saddle limit cycles. Chaotic advection is caused by a breakup of a degenerate heteroclinic connection between the two saddle foci when the flow becomes three-dimensional. On increasing the Reynolds number, chaotic streamlines invade the cells from the cell boundary and from the interior along the broken heteroclinic connection. This trend is made evident by computing the Kolmogorov–Arnold–Moser tori for five supercritical Reynolds numbers.

scholarly journals Three-dimensional Floquet stability analysis of the wake of a circular cylinder

1996 ◽  
Vol 322 ◽  
pp. 215-241 ◽  
Author(s):  
Dwight Barkley ◽  
Ronald D. Henderson
Keyword(s):  
Reynolds Number ◽  
Stability Analysis ◽  
Circular Cylinder ◽  
Critical Reynolds Number ◽  
Three Dimensional ◽  
Reynolds Numbers ◽  
Neutral Stability ◽  
Two Dimensional ◽  
Numerical Stability Analysis ◽  
Mode A

Results are reported from a highly accurate, global numerical stability analysis of the periodic wake of a circular cylinder for Reynolds numbers between 140 and 300. The analysis shows that the two-dimensional wake becomes (absolutely) linearly unstable to three-dimensional perturbations at a critical Reynolds number of 188.5±1.0. The critical spanwise wavelength is 3.96 ± 0.02 diameters and the critical Floquet mode corresponds to a ‘Mode A’ instability. At Reynolds number 259 the two-dimensional wake becomes linearly unstable to a second branch of modes with wavelength 0.822 diameters at onset. Stability spectra and corresponding neutral stability curves are presented for Reynolds numbers up to 300.

Flow in two-sided lid-driven cavities: non-uniqueness, instabilities, and cellular structures

1997 ◽  
Vol 336 ◽  
pp. 267-299 ◽  
Author(s):  
H. C. KUHLMANN ◽  
M. WANSCHURA ◽  
H. J. RATH
Keyword(s):  
Three Dimensional ◽  
Reynolds Numbers ◽  
Two Dimensional ◽  
Single Vortex ◽  
Low Reynolds Numbers ◽  
Dimensional Flow ◽  
Two Dimensional Flow ◽  
The Difference ◽  
Convective Cells ◽  
Highly Strained

The steady flow in rectangular cavities is investigated both numerically and experimentally. The flow is driven by moving two facing walls tangentially in opposite directions. It is found that the basic two-dimensional flow is not always unique. For low Reynolds numbers it consists of two separate co-rotating vortices adjacent to the moving walls. If the difference in the sidewall Reynolds numbers is large this flow becomes unstable to a stationary three-dimensional mode with a long wavelength. When the aspect ratio is larger than two and both Reynolds numbers are large, but comparable in magnitude, a second two-dimensional flow exists. It takes the form of a single vortex occupying the whole cavity. This flow is the preferred state in the present experiment. It becomes unstable to a three-dimensional mode that subdivides the basic streched vortex flow into rectangular convective cells. The instability is supercritical when both sidewall Reynolds numbers are the same. When they differ the instability is subcritical. From an energy analysis and from the salient features of the three-dimensional flow it is concluded that the mechanism of destabilization is identical to the destabilization mechanism operative in the elliptical instability of highly strained vortices.

scholarly journals Two-dimensional flow field distribution characteristics of flocking drainage pipes in tunnel

Open Physics ◽  
2020 ◽  
Vol 18 (1) ◽  
pp. 139-148
Author(s):  
Shiyang Liu ◽  
Xuefu Zhang ◽  
Feng Gao ◽  
Liangwen Wei ◽  
Qiang Liu ◽  
...  
Keyword(s):  
Flow Field ◽  
Field Distribution ◽  
Rapid Development ◽  
Maximum Velocity ◽  
Distribution Characteristics ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Laboratory Test Results ◽  
Transverse Distance ◽  
Two Dimensional Flow

AbstractWith the rapid development of traffic infrastructure in China, the problem of crystal plugging of tunnel drainage pipes becomes increasingly salient. In order to build a mechanism that is resilient to the crystal plugging of flocking drainage pipes, the present study used the numerical simulation to analyze the two-dimensional flow field distribution characteristics of flocking drainage pipes under different flocking spacings. Then, the results were compared with the laboratory test results. According to the results, the maximum velocity distribution in the flow field of flocking drainage pipes is closely related to the transverse distance h of the fluff, while the longitudinal distance h of the fluff causes little effect; when the transverse distance h of the fluff is less than 6.25D (D refers to the diameter of the fluff), the velocity between the adjacent transverse fluffs will be increased by more than 10%. Moreover, the velocity of the upstream and downstream fluffs will be decreased by 90% compared with that of the inlet; the crystal distribution can be more obvious in the place with larger velocity while it is less at the lower flow rate. The results can provide theoretical support for building a mechanism to deal with and remove the crystallization of flocking drainage pipes.

Contracting ducts of finite length

1951 ◽  
Vol 2 (4) ◽  
pp. 254-271 ◽  
Author(s):  
L. G. Whitehead ◽  
L. Y. Wu ◽  
M. H. L. Waters
Keyword(s):  
Stream Function ◽  
Finite Length ◽  
Velocity Potential ◽  
Three Dimensional ◽  
Relaxation Method ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Hodograph Plane ◽  
Two Dimensional Flow ◽  
Working Section

SummmaryA method of design is given for wind tunnel contractions for two-dimensional flow and for flow with axial symmetry. The two-dimensional designs are based on a boundary chosen in the hodograph plane for which the flow is found by the method of images. The three-dimensional method uses the velocity potential and the stream function of the two-dimensional flow as independent variables and the equation for the three-dimensional stream function is solved approximately. The accuracy of the approximate method is checked by comparison with a solution obtained by Southwell's relaxation method.In both the two and the three-dimensional designs the curved wall is of finite length with parallel sections upstream and downstream. The effects of the parallel parts of the channel on the rise of pressure near the wall at the start of the contraction and on the velocity distribution across the working section can therefore be estimated.

Three-dimensional flow in cavities

1963 ◽  
Vol 16 (4) ◽  
pp. 620-632 ◽  
Author(s):  
D. J. Maull ◽  
L. F. East
Keyword(s):  
Static Pressure ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Three Dimensional Flow ◽  
Large Span ◽  
Dimensional Flow ◽  
Pressure Distributions ◽  
Oil Flow ◽  
Two Dimensional Flow

The flow inside rectangular and other cavities in a wall has been investigated at low subsonic velocities using oil flow and surface static-pressure distributions. Evidence has been found of regular three-dimensional flows in cavities with large span-to-chord ratios which would normally be considered to have two-dimensional flow near their centre-lines. The dependence of the steadiness of the flow upon the cavity's span as well as its chord and depth has also been observed.

Theoretical Aspects of Thrust Vector Control by Secondary Gas Injection in Rocket Nozzles

1968 ◽  
Vol 72 (686) ◽  
pp. 171-177 ◽  
Author(s):  
John H. Neilson ◽  
Alastair Gilchrist ◽  
Chee K. Lee
Keyword(s):  
Vector Control ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Three Dimensional Flow ◽  
Side Force ◽  
Thrust Vector Control ◽  
Dimensional Flow ◽  
Two Dimensional Flow ◽  
Thrust Vector ◽  
Secondary Injection

This work deals with theoretical aspects of thrust vector control in rocket nozzles by the injection of secondary gas into the supersonic region of the nozzle. The work is concerned mainly with two-dimensional flow, though some aspects of three-dimensional flow in axisymmetric nozzles are considered. The subject matter is divided into three parts. In Part I, the side force produced when a physical wedge is placed into the exit of a two-dimensional nozzle is considered. In Parts 2 and 3, the physical wedge is replaced by a wedge-shaped “dead water” region produced by the separation of the boundary layer upstream of a secondary injection port. The modifications which then have to be made to the theoretical relationships, given in Part 1, are enumerated. Theoretical relationships for side force, thrust augmentation and magnification parameter for two- and three-dimensional flow are given for secondary injection normal to the main nozzle axis. In addition, the advantages to be gained by secondary injection in an upstream direction are clearly illustrated. The theoretical results are compared with experimental work and a comparison is made with the theories of other workers.

scholarly journals Linear stability of confined flow around a 180-degree sharp bend

2017 ◽  
Vol 822 ◽  
pp. 813-847 ◽  
Author(s):  
Azan M. Sapardi ◽  
Wisam K. Hussam ◽  
Alban Pothérat ◽  
Gregory J. Sheard
Keyword(s):  
Reynolds Number ◽  
Stability Analysis ◽  
Linear Stability ◽  
Linear Stability Analysis ◽  
Critical Reynolds Number ◽  
Three Dimensional ◽  
Base Flow ◽  
Two Dimensional ◽  
Two Dimensional Flow ◽  
The Stability

This study seeks to characterise the breakdown of the steady two-dimensional solution in the flow around a 180-degree sharp bend to infinitesimal three-dimensional disturbances using a linear stability analysis. The stability analysis predicts that three-dimensional transition is via a synchronous instability of the steady flows. A highly accurate global linear stability analysis of the flow was conducted with Reynolds number $\mathit{Re}<1150$ and bend opening ratio (ratio of bend width to inlet height) $0.2\leqslant \unicode[STIX]{x1D6FD}\leqslant 5$. This range of $\mathit{Re}$ and $\unicode[STIX]{x1D6FD}$ captures both steady-state two-dimensional flow solutions and the inception of unsteady two-dimensional flow. For $0.2\leqslant \unicode[STIX]{x1D6FD}\leqslant 1$, the two-dimensional base flow transitions from steady to unsteady at higher Reynolds number as $\unicode[STIX]{x1D6FD}$ increases. The stability analysis shows that at the onset of instability, the base flow becomes three-dimensionally unstable in two different modes, namely a spanwise oscillating mode for $\unicode[STIX]{x1D6FD}=0.2$ and a spanwise synchronous mode for $\unicode[STIX]{x1D6FD}\geqslant 0.3$. The critical Reynolds number and the spanwise wavelength of perturbations increase as $\unicode[STIX]{x1D6FD}$ increases. For $1<\unicode[STIX]{x1D6FD}\leqslant 2$ both the critical Reynolds number for onset of unsteadiness and the spanwise wavelength decrease as $\unicode[STIX]{x1D6FD}$ increases. Finally, for $2<\unicode[STIX]{x1D6FD}\leqslant 5$, the critical Reynolds number and spanwise wavelength remain almost constant. The linear stability analysis also shows that the base flow becomes unstable to different three-dimensional modes depending on the opening ratio. The modes are found to be localised near the reattachment point of the first recirculation bubble.

Sign in / Sign up

Export Citation Format

Share Document