Flow in two-sided lid-driven cavities: non-uniqueness, instabilities, and cellular structures

1997 ◽  
Vol 336 ◽  
pp. 267-299 ◽  
Author(s):  
H. C. KUHLMANN ◽  
M. WANSCHURA ◽  
H. J. RATH
Keyword(s):  
Three Dimensional ◽  
Reynolds Numbers ◽  
Two Dimensional ◽  
Single Vortex ◽  
Low Reynolds Numbers ◽  
Dimensional Flow ◽  
Two Dimensional Flow ◽  
The Difference ◽  
Convective Cells ◽  
Highly Strained

The steady flow in rectangular cavities is investigated both numerically and experimentally. The flow is driven by moving two facing walls tangentially in opposite directions. It is found that the basic two-dimensional flow is not always unique. For low Reynolds numbers it consists of two separate co-rotating vortices adjacent to the moving walls. If the difference in the sidewall Reynolds numbers is large this flow becomes unstable to a stationary three-dimensional mode with a long wavelength. When the aspect ratio is larger than two and both Reynolds numbers are large, but comparable in magnitude, a second two-dimensional flow exists. It takes the form of a single vortex occupying the whole cavity. This flow is the preferred state in the present experiment. It becomes unstable to a three-dimensional mode that subdivides the basic streched vortex flow into rectangular convective cells. The instability is supercritical when both sidewall Reynolds numbers are the same. When they differ the instability is subcritical. From an energy analysis and from the salient features of the three-dimensional flow it is concluded that the mechanism of destabilization is identical to the destabilization mechanism operative in the elliptical instability of highly strained vortices.

Cellular flow in a partially filled rotating drum: regular and chaotic advection

2017 ◽  
Vol 825 ◽  
pp. 631-650 ◽  
Author(s):  
Francesco Romanò ◽  
Arash Hajisharifi ◽  
Hendrik C. Kuhlmann
Keyword(s):  
Three Dimensional ◽  
Reynolds Numbers ◽  
Chaotic Advection ◽  
Two Dimensional ◽  
Rotating Drum ◽  
Three Dimensional Flow ◽  
Dimensional Flow ◽  
Heteroclinic Connection ◽  
Two Dimensional Flow ◽  
Chaotic Streamlines

The topology of the incompressible steady three-dimensional flow in a partially filled cylindrical rotating drum, infinitely extended along its axis, is investigated numerically for a ratio of pool depth to radius of 0.2. In the limit of vanishing Froude and capillary numbers, the liquid–gas interface remains flat and the two-dimensional flow becomes unstable to steady three-dimensional convection cells. The Lagrangian transport in the cellular flow is organised by periodic spiralling-in and spiralling-out saddle foci, and by saddle limit cycles. Chaotic advection is caused by a breakup of a degenerate heteroclinic connection between the two saddle foci when the flow becomes three-dimensional. On increasing the Reynolds number, chaotic streamlines invade the cells from the cell boundary and from the interior along the broken heteroclinic connection. This trend is made evident by computing the Kolmogorov–Arnold–Moser tori for five supercritical Reynolds numbers.

scholarly journals Vorticity forces on an impulsively started finite plate

2012 ◽  
Vol 694 ◽  
pp. 464-492 ◽  
Author(s):  
Jian-Jhih Lee ◽  
Cheng-Ta Hsieh ◽  
Chien C. Chang ◽  
Chin-Chou Chu
Keyword(s):  
Aspect Ratio ◽  
Three Dimensional ◽  
Longitudinal Component ◽  
Spanwise Direction ◽  
Two Dimensional ◽  
Force Analysis ◽  
Finite Plate ◽  
Dimensional Flow ◽  
Two Dimensional Flow ◽  
The Difference

AbstractIn this study, we consider various contributions to the forces on an impulsively started finite plate from the perspective of a diagnostic vorticity force theory. The wing plate has an aspect ratio (AR) between 1 and 3, and is placed at low and high angles of attack ($\ensuremath{\alpha} \leq $ and ${\gt }2{0}^{\ensuremath{\circ} } $), while the Reynolds number is either 100 or 300. The theory enables us to quantify the contributions to the forces exerted on the plate in terms of all of the fluid elements with non-zero vorticity, such as in the tip vortices (TiVs), leading- and trailing-edge vortices (LEV and TEV) as well on the plate surface. This line of force analysis has been pursued for two-dimensional flow in our previous studies. In contrast to the pressure force analysis (PFA), the vorticity force analysis (VFA) reveals new salient features in its applications to three-dimensional flow by examining sectional force contributions along the spanwise direction. In particular, at a large aspect ratio ($\mathit{AR}= 3$), the force distributions of PFA and VFA show close agreements with each other in the middle sections, while at a lower aspect ratio ($\mathit{AR}= 1$), the force distribution of PFA is substantially larger than that of VFA in most of the sections. The difference is compensated for by the contributions partly by the edge sections and mainly by the vortices in the outer regions. Further investigation is made fruitful by decomposing the vorticity into the spanwise (longitudinal) component (the only one in two-dimensional flow) and the other two orthogonal (transverse) components. The relative importance of the force contributions credited to the transverse components in the entire flow regions as well as in the two outer regions signifies the three-dimensional nature of the flow over a finite plate. The interplay between the LEV and the TiVs at various time stages is shown to play a key role in distinguishing the force contributions for the plate with a smaller aspect ratio and that with a larger aspect ratio. The present VFA provides a better perspective for flow control by relating the forces directly to the various sources of vorticity (or vortex structures) on or near the wing plate.

scholarly journals Two- and three-dimensional wake transitions of an impulsively started uniformly rolling circular cylinder

2017 ◽  
Vol 826 ◽  
pp. 32-59 ◽  
Author(s):  
F. Y. Houdroge ◽  
T. Leweke ◽  
K. Hourigan ◽  
M. C. Thompson
Keyword(s):  
Stability Analysis ◽  
Circular Cylinder ◽  
Rapid Development ◽  
Three Dimensional ◽  
Reynolds Numbers ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Instability Modes ◽  
Two Dimensional Flow ◽  
Lift And Drag

This paper presents the characteristics of the different stages in the evolution of the wake of a circular cylinder rolling without slipping along a wall at constant speed, acquired through numerical stability analysis and two- and three-dimensional numerical simulations. Reynolds numbers between 30 and 300 are considered. Of importance in this study is the transition to three-dimensionality from the underlying two-dimensional periodic flow and, in particular, the way that the associated transitions influence the fluid forces exerted on the cylinder and the development and the structure of the wake. It is found that the steady two-dimensional flow becomes unstable to three-dimensional perturbations at $Re_{c,3D}=37$, and that the transition to unsteady two-dimensional flow – or periodic vortex shedding – occurs at $Re_{c,2D}=88$, thus validating and refining the results of Stewart et al. (J. Fluid Mech. vol. 648, 2010, pp. 225–256). The main focus here is on Reynolds numbers beyond the transition to unsteady flow at $Re_{c,2D}=88$. From impulsive start up, the wake almost immediately undergoes transition to a periodic two-dimensional wake state, which, in turn, is three-dimensionally unstable. Thus, the previous three-dimensional stability analysis based on the two-dimensional steady flow provides only an element of the full story. Floquet analysis based on the periodic two-dimensional flow was undertaken and new three-dimensional instability modes were revealed. The results suggest that an impulsively started cylinder rolling along a surface at constant velocity for $Re\gtrsim 90$ will result in the rapid development of a periodic two-dimensional wake that will be maintained for a considerable time prior to the wake undergoing three-dimensional transition. Of interest, the mean lift and drag coefficients obtained from full three-dimensional simulations match predictions from two-dimensional simulations to within a few per cent.

Contracting ducts of finite length

1951 ◽  
Vol 2 (4) ◽  
pp. 254-271 ◽  
Author(s):  
L. G. Whitehead ◽  
L. Y. Wu ◽  
M. H. L. Waters
Keyword(s):  
Stream Function ◽  
Finite Length ◽  
Velocity Potential ◽  
Three Dimensional ◽  
Relaxation Method ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Hodograph Plane ◽  
Two Dimensional Flow ◽  
Working Section

SummmaryA method of design is given for wind tunnel contractions for two-dimensional flow and for flow with axial symmetry. The two-dimensional designs are based on a boundary chosen in the hodograph plane for which the flow is found by the method of images. The three-dimensional method uses the velocity potential and the stream function of the two-dimensional flow as independent variables and the equation for the three-dimensional stream function is solved approximately. The accuracy of the approximate method is checked by comparison with a solution obtained by Southwell's relaxation method.In both the two and the three-dimensional designs the curved wall is of finite length with parallel sections upstream and downstream. The effects of the parallel parts of the channel on the rise of pressure near the wall at the start of the contraction and on the velocity distribution across the working section can therefore be estimated.

Three-dimensional flow in cavities

1963 ◽  
Vol 16 (4) ◽  
pp. 620-632 ◽  
Author(s):  
D. J. Maull ◽  
L. F. East
Keyword(s):  
Static Pressure ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Three Dimensional Flow ◽  
Large Span ◽  
Dimensional Flow ◽  
Pressure Distributions ◽  
Oil Flow ◽  
Two Dimensional Flow

The flow inside rectangular and other cavities in a wall has been investigated at low subsonic velocities using oil flow and surface static-pressure distributions. Evidence has been found of regular three-dimensional flows in cavities with large span-to-chord ratios which would normally be considered to have two-dimensional flow near their centre-lines. The dependence of the steadiness of the flow upon the cavity's span as well as its chord and depth has also been observed.

Theoretical Aspects of Thrust Vector Control by Secondary Gas Injection in Rocket Nozzles

1968 ◽  
Vol 72 (686) ◽  
pp. 171-177 ◽  
Author(s):  
John H. Neilson ◽  
Alastair Gilchrist ◽  
Chee K. Lee
Keyword(s):  
Vector Control ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Three Dimensional Flow ◽  
Side Force ◽  
Thrust Vector Control ◽  
Dimensional Flow ◽  
Two Dimensional Flow ◽  
Thrust Vector ◽  
Secondary Injection

This work deals with theoretical aspects of thrust vector control in rocket nozzles by the injection of secondary gas into the supersonic region of the nozzle. The work is concerned mainly with two-dimensional flow, though some aspects of three-dimensional flow in axisymmetric nozzles are considered. The subject matter is divided into three parts. In Part I, the side force produced when a physical wedge is placed into the exit of a two-dimensional nozzle is considered. In Parts 2 and 3, the physical wedge is replaced by a wedge-shaped “dead water” region produced by the separation of the boundary layer upstream of a secondary injection port. The modifications which then have to be made to the theoretical relationships, given in Part 1, are enumerated. Theoretical relationships for side force, thrust augmentation and magnification parameter for two- and three-dimensional flow are given for secondary injection normal to the main nozzle axis. In addition, the advantages to be gained by secondary injection in an upstream direction are clearly illustrated. The theoretical results are compared with experimental work and a comparison is made with the theories of other workers.

scholarly journals Volumetric imaging of shark tail hydrodynamics reveals a three-dimensional dual-ring vortex wake structure

2011 ◽  
Vol 278 (1725) ◽  
pp. 3670-3678 ◽  
Author(s):  
Brooke E. Flammang ◽  
George V. Lauder ◽  
Daniel R. Troolin ◽  
Tyson Strand
Keyword(s):  
Three Dimensional ◽  
Flow Patterns ◽  
Wake Flow ◽  
Ring Vortex ◽  
Vortex Wake ◽  
Two Dimensional ◽  
Volumetric Imaging ◽  
Dimensional Flow ◽  
Classic Problem ◽  
Two Dimensional Flow

Understanding how moving organisms generate locomotor forces is fundamental to the analysis of aerodynamic and hydrodynamic flow patterns that are generated during body and appendage oscillation. In the past, this has been accomplished using two-dimensional planar techniques that require reconstruction of three-dimensional flow patterns. We have applied a new, fully three-dimensional, volumetric imaging technique that allows instantaneous capture of wake flow patterns, to a classic problem in functional vertebrate biology: the function of the asymmetrical (heterocercal) tail of swimming sharks to capture the vorticity field within the volume swept by the tail. These data were used to test a previous three-dimensional reconstruction of the shark vortex wake estimated from two-dimensional flow analyses, and show that the volumetric approach reveals a different vortex wake not previously reconstructed from two-dimensional slices. The hydrodynamic wake consists of one set of dual-linked vortex rings produced per half tail beat. In addition, we use a simple passive shark-tail model under robotic control to show that the three-dimensional wake flows of the robotic tail differ from the active tail motion of a live shark, suggesting that active control of kinematics and tail stiffness plays a substantial role in the production of wake vortical patterns.

Sign in / Sign up

Export Citation Format

Share Document