Aeolian silt contribution to soils on mountain slopes (Mt. Ślęża, southwest Poland)

2017 ◽  
Vol 89 (3) ◽  
pp. 702-717 ◽  
Author(s):  
Jaroslaw Waroszewski ◽  
Tobias Sprafke ◽  
Cezary Kabala ◽  
Elżbieta Musztyfaga ◽  
Beata Łabaz ◽  
...  

AbstractThis paper evaluates the possible contribution of aeolian silt to soils of Mt. Ślęża (southwest Poland). Silt loam textures are common across Lower Silesia and are often confused with silt clay loam, especially at the outer boundaries with thin loess deposits. Eight study sites with different thicknesses of silt loam mantles that are covered and/or mixed with underlying sediments were examined in the field. To test our hypothesis, we analyzed the particle size and geochemistry of representative horizons. Concentrations of major and trace elements as well as their cross ratios confirmed the aeolian origin of silt loam materials and clearly distinguished them from basal sediments. There is a clear relationship between the presence and depth of aeolian mantles and mixing zones with the type of underlying material. Furthermore, the incorporation of aeolian silt to regoliths/soils was a main agent initiating and stimulating clay translocation leading to the formation of an argic horizon below the silt mantles. Mixing aeolian silt with acid granite regoliths and further illuviation resulted in the formation of alisols, while silt contributions to serpentine sediments resulted in development of skeletic luvisols. Soils receiving very weak input of aeolian silts remain as leptosols/cambisols.

2009 ◽  
Vol 89 (4) ◽  
pp. 413-419 ◽  
Author(s):  
X M Yang ◽  
C F Drury ◽  
W D Reynolds ◽  
D C MacTavish

Applying ultrasound energy to soil-water suspensions (sonication) is an established method of determining the size distributions of soil primary mineral particles and associated organic matter. The size distributions may vary, however, with sonication input energy and soil type. The objective of this study was to determine the effects of sonication input energy on the size distributions of soil mineral particles and organic matter for a range of soil textures and carbon contents typical of agricultural soils in southwestern Ontario. The soils included a Brookston clay loam, a Brookston clay, a Huron silt loam, a Perth silt loam and a Harrow sandy loam. All soils were under no-tillage management. Nine sonication energies ranging from 50 to 1500 J mL–1 were applied to soil-water suspensions (1:4 mass ratio), and the soil particle size distribution results were compared with those obtained using the standard chemical dispersion (pipette) method. The three medium- and coarse-textured soils (Huron, Perth, Harrow) required about 250 J mL–1 for complete dissociation of soil aggregates, while the two fine-textured soils (Brookston) required sonication energies of 600-750 J mL–1. Increasing sonication energy increased the amount of soil organic carbon (SOC) measured in the clay-size fraction and decreased the amounts in the sand and silt fractions. Therefore, accurate determinations of particle size distribution and SOC contents require an initial assessment of the amount of sonication energy required for the complete dispersion of the particle size fractions. For the Brookston clay loam and Brookston clay soils, 40–52% less particulate SOC was found in the sand fraction at 750 J mL–1 sonication energy than that obtained using the standard pipette method, indicating particle size reduction by sonication of particle organic matter. It should be noted that the sand-size SOC typically represents a small fraction. Furthermore, sonication had a minor effect on the SOC content of the clay fraction. It was concluded that sonication is a viable technique for determining the size distribution of soil primary mineral particles, as well as the amount of SOC associated with the silt and clay fractions. Key words: Sonication, ultrasound energy, particle size distribution, organic carbon fractionation, clay soil


2018 ◽  
Author(s):  
Zoltán Kis ◽  
Katalin Gméling ◽  
Tímea Kocsis ◽  
János Osán ◽  
Mihály András Pocsai ◽  
...  

We present precise analysis of major and trace elements of the humic acid. We used three different element analytical techniques in our investigations as prompt-gamma activation analysis (PGAA), neutron activation analysis (NAA) and X-ray fluorescence (XRF) analysis was carried out. We identified 42 elements in our sample.


2021 ◽  
Vol 170 ◽  
pp. 109595
Author(s):  
Wael M. Badawy ◽  
Octavian G. Duliu ◽  
Hussein El Samman ◽  
Atef El-Taher ◽  
Marina V. Frontasyeva

Data in Brief ◽  
2020 ◽  
Vol 30 ◽  
pp. 105438
Author(s):  
Karina L. Lecomte ◽  
Cecilia V. Echegoyen ◽  
Paula A. Vignoni ◽  
Kateřina Kopalová ◽  
Tyler J. Kohler ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document