Use of sonication to determine the size distributions of soil particles and organic matter

2009 ◽  
Vol 89 (4) ◽  
pp. 413-419 ◽  
Author(s):  
X M Yang ◽  
C F Drury ◽  
W D Reynolds ◽  
D C MacTavish

Applying ultrasound energy to soil-water suspensions (sonication) is an established method of determining the size distributions of soil primary mineral particles and associated organic matter. The size distributions may vary, however, with sonication input energy and soil type. The objective of this study was to determine the effects of sonication input energy on the size distributions of soil mineral particles and organic matter for a range of soil textures and carbon contents typical of agricultural soils in southwestern Ontario. The soils included a Brookston clay loam, a Brookston clay, a Huron silt loam, a Perth silt loam and a Harrow sandy loam. All soils were under no-tillage management. Nine sonication energies ranging from 50 to 1500 J mL–1 were applied to soil-water suspensions (1:4 mass ratio), and the soil particle size distribution results were compared with those obtained using the standard chemical dispersion (pipette) method. The three medium- and coarse-textured soils (Huron, Perth, Harrow) required about 250 J mL–1 for complete dissociation of soil aggregates, while the two fine-textured soils (Brookston) required sonication energies of 600-750 J mL–1. Increasing sonication energy increased the amount of soil organic carbon (SOC) measured in the clay-size fraction and decreased the amounts in the sand and silt fractions. Therefore, accurate determinations of particle size distribution and SOC contents require an initial assessment of the amount of sonication energy required for the complete dispersion of the particle size fractions. For the Brookston clay loam and Brookston clay soils, 40–52% less particulate SOC was found in the sand fraction at 750 J mL–1 sonication energy than that obtained using the standard pipette method, indicating particle size reduction by sonication of particle organic matter. It should be noted that the sand-size SOC typically represents a small fraction. Furthermore, sonication had a minor effect on the SOC content of the clay fraction. It was concluded that sonication is a viable technique for determining the size distribution of soil primary mineral particles, as well as the amount of SOC associated with the silt and clay fractions. Key words: Sonication, ultrasound energy, particle size distribution, organic carbon fractionation, clay soil

1991 ◽  
Vol 113 (4) ◽  
pp. 402-411 ◽  
Author(s):  
T. J. Labus ◽  
K. F. Neusen ◽  
D. G. Alberts ◽  
T. J. Gores

A basic investigation of the factors which influence the abrasive jet mixing process was conducted. Particle size analysis was performed on abrasive samples for the “as-received” condition, at the exit of the mixing tube, and after cutting a target material. Grit size distributions were obtained through sieve analysis for both water and air collectors. Two different mixing chamber geometries were evaluated, as well as the effects of pressure, abrasive feed rate, cutting speed, and target material properties on particle size distributions. An analysis of the particle size distribution shows that the main particle breakdown is from 180 microns directly to 63 microns or less, for a nominal 80 grit garnet. This selective breakdown occurs during the cutting process, but not during the mixing process.


1982 ◽  
Vol 60 (8) ◽  
pp. 1101-1107
Author(s):  
C. V. Mathai ◽  
A. W. Harrison

As part of an ongoing general research program on the effects of atmospheric aerosols on visibility and its dependence on aerosol size distributions in Calgary, this paper presents the results of a comparative study of particle size distribution and visibility in residential (NW) and industrial (SE) sections of the city using a mobile laboratory. The study was conducted in the period October–December, 1979. An active scattering aerosol spectrometer measured the size distributions and the corresponding visibilities were deduced from scattering coefficients measured with an integrating nephelometer.The results of this transit study show significantly higher suspended particle concentrations and reduced visibilities in the SE than in the NW. The mean values of the visibilities are 44 and 97 km for the SE and the NW respectively. The exponent of R (particle radius) in the power law aerosol size distribution has a mean value of −3.36 ± 0.24 in the SE compared with the corresponding value of −3.89 ± 0.39 for the NW. These results arc in good agreement with the observations of Alberta Environment; however, they are in contradiction with a recent report published by the City of Calgary.


2010 ◽  
Vol 177 ◽  
pp. 22-24
Author(s):  
Zheng Min Li ◽  
Zhi Wei Chen ◽  
Min Tan ◽  
Ke Jing Xu ◽  
Bing Jiang

Nano-TiO2 coating film is one of the efficient photocatalysts. The particle size distribution of TiO2 has important influence on photocatalytic activity. A new method to determine the particle size distribution of TiO2 nano-film coated on ceramic was developed, by which the images of film acquired by Atom force microscope (AFM) were processed, and TiO2 particles contacted with others were separated and detected. The particle size distributions of two TiO2 nano-films were determined.


1994 ◽  
Vol 74 (2) ◽  
pp. 383-385 ◽  
Author(s):  
R. Soofi-Siawash ◽  
G. W. Mathison

Two studies were conducted to assess the possibility of using particle size distribution following grinding as a routine procedure of forage evaluation. It was concluded that although differences in particle size distribution could be detected when different feeds were ground, it would be difficult to standardize the technique since particle size distributions were influenced by type of mill used for grinding, particle size of forage before grinding, and moisture content of the forage. Key words: Forages, grinding, particle size, moisture, mill


2020 ◽  
Author(s):  
Cristina Contreras ◽  
Sara Acevedo ◽  
Sofía Martínez ◽  
Carlos Bonilla

<p>Typical information in soil databases is the soil texture and particle size distribution. These properties are used for soil description or predicting other soil properties such as bulk density or hydraulic conductivity. Measuring particle size distribution with standards methods such as the pipette or hydrometer is time-consuming because of the sample pre-treatment used to remove organic matter or iron and the sample post-treatment. Nowadays, there are new methodologies for determining soil particle size distribution, such as the Integral Suspension Pressure (ISP) method, which measures the silt content in a semi-automatized process. Thus, the main objective of this study was to evaluate the suitability of the ISP method compared to standard techniques used in soil analysis and evaluate the effect of organic matter content in the ISP measurements. The main results showed that the ISP method is equivalent in accuracy to the pipette, especially for soils rich in silt or sand content. Also, the results demonstrate the convenience of removing the soil organic matter when using the ISP for soils with more than 1.5% organic matter.</p>


1982 ◽  
Vol 62 (4) ◽  
pp. 631-639 ◽  
Author(s):  
G. T. PATTERSON ◽  
G. J. WALL

Replicate soil samples (2–20) from the A, B and C horizons of 41 pedons were collected to measure within-pedon variability of particle size distribution, organic matter content, calcium carbonate equivalent and pH. Variability in soil properties was examined in relation to the mode of origin of the soil material, soil horizonation and soil drainage. Variance in particle size distribution was significantly influenced by mode of deposition as well as by soil horizons, while soil drainage had no significant influence on the variation in particle size distribution. Variance in calcium carbonate equivalent and organic matter content was not influenced by soil drainage or mode of deposition. The number of replicate samples required for statistically reliable evaluation of a pedon at given confidence limits was determined for the soil properties studied. The results of these calculations indicate the need for up to five replicate samples to achieve satisfactory levels of accuracy at the 95% confidence level for some of the soil properties studied.


Sign in / Sign up

Export Citation Format

Share Document