scholarly journals Rendering a subcritical Hopf bifurcation supercritical

1996 ◽  
Vol 317 ◽  
pp. 91-109 ◽  
Author(s):  
Po Ki Yuen ◽  
Haim H. Bau

It is demonstrated experimentally and theoretically that through the use of a nonlinear feedback controller, one can render a subcritical Hopf bifurcation supercritical and thus dramatically modify the nature of the flow in a thermal convection loop heated from below and cooled from above. In particular, we show that the controller can replace the naturally occurring chaotic motion with a stable, periodic limit cycle. The control strategy consists of sensing the deviation of fluid temperatures from desired values at a number of locations inside the loop and then altering the wall heating to counteract such deviations.

1992 ◽  
Vol 237 ◽  
pp. 479-498 ◽  
Author(s):  
Yuzhou Wang ◽  
Jonathan Singer ◽  
Haim H. Bau

It is demonstrated experimentally and theoretically that through the use of an active (feedback) controller one can dramatically modify the nature of the flow in a toroidal thermal convection loop heated from below and cooled from above. In particular, we show how a simple control strategy can be used to suppress (laminarize) the naturally occurring chaotic motion or induce chaos in otherwise time-independent flow. The control strategy consists of sensing the deviation of fluid temperatures from desired values at a number of locations inside the loop and then altering the wall heating to either counteract or enhance such deviations.


2014 ◽  
Vol 11 (101) ◽  
pp. 20140958 ◽  
Author(s):  
Chunjiang Fu ◽  
Yasuyuki Suzuki ◽  
Ken Kiyono ◽  
Pietro Morasso ◽  
Taishin Nomura

Stability of human gait is the ability to maintain upright posture during walking against external perturbations. It is a complex process determined by a number of cross-related factors, including gait trajectory, joint impedance and neural control strategies. Here, we consider a control strategy that can achieve stable steady-state periodic gait while maintaining joint flexibility with the lowest possible joint impedance. To this end, we carried out a simulation study of a heel-toe footed biped model with hip, knee and ankle joints and a heavy head-arms-trunk element, working in the sagittal plane. For simplicity, the model assumes a periodic desired joint angle trajectory and joint torques generated by a set of feed-forward and proportional-derivative feedback controllers, whereby the joint impedance is parametrized by the feedback gains. We could show that a desired steady-state gait accompanied by the desired joint angle trajectory can be established as a stable limit cycle (LC) for the feedback controller with an appropriate set of large feedback gains. Moreover, as the feedback gains are decreased for lowering the joint stiffness, stability of the LC is lost only in a few dimensions, while leaving the remaining large number of dimensions quite stable: this means that the LC becomes saddle-type, with a low-dimensional unstable manifold and a high-dimensional stable manifold. Remarkably, the unstable manifold remains of low dimensionality even when the feedback gains are decreased far below the instability point. We then developed an intermittent neural feedback controller that is activated only for short periods of time at an optimal phase of each gait stride. We characterized the robustness of this design by showing that it can better stabilize the unstable LC with small feedback gains, leading to a flexible gait, and in particular we demonstrated that such an intermittent controller performs better if it drives the state point to the stable manifold, rather than directly to the LC. The proposed intermittent control strategy might have a high affinity for the inverted pendulum analogy of biped gait, providing a dynamic view of how the step-to-step transition from one pendular stance to the next can be achieved stably in a robust manner by a well-timed neural intervention that exploits the stable modes embedded in the unstable dynamics.


2019 ◽  
Vol 29 (03) ◽  
pp. 1950038 ◽  
Author(s):  
Yonghui Xia ◽  
Mateja Grašič ◽  
Wentao Huang ◽  
Valery G. Romanovski

We propose an approach to study small limit cycle bifurcations on a center manifold in analytic or smooth systems depending on parameters. We then apply it to the investigation of limit cycle bifurcations in a model of calcium oscillations in the cilia of olfactory sensory neurons and show that it can have two limit cycles: a stable cycle appearing after a Bautin (generalized Hopf) bifurcation and an unstable cycle appearing after a subcritical Hopf bifurcation.


2010 ◽  
Vol 2010 ◽  
pp. 1-13 ◽  
Author(s):  
M. Ghommem ◽  
A. H. Nayfeh ◽  
M. R. Hajj

Linear and nonlinear static feedback controls are implemented on a nonlinear aeroelastic system that consists of a rigid airfoil supported by nonlinear springs in the pitch and plunge directions and subjected to nonlinear aerodynamic loads. The normal form is used to investigate the Hopf bifurcation that occurs as the freestream velocity is increased and to analytically predict the amplitude and frequency of the ensuing limit cycle oscillations (LCO). It is shown that linear control can be used to delay the flutter onset and reduce the LCO amplitude. Yet, its required gains remain a function of the speed. On the other hand, nonlinear control can be effciently implemented to convert any subcritical Hopf bifurcation into a supercritical one and to significantly reduce the LCO amplitude.


1990 ◽  
Vol 43 (10) ◽  
pp. 251-260
Author(s):  
D. P. Atherton

The paper examines in depth two approaches, namely the describing function and Tsypkin methods, for predicting the autonomous behaviour of simple nonlinear feedback systems. Both procedures are supported by software which, in the case of the describing function method, allows iteration to the exact limit cycle solution and, for both methods, enables display of resulting limit cycle waveforms. One advantage of the Tsypkin method, which is applicable primarily to relay systems, is that the exact stability of the limit cycle solution can be found. It is shown how this may be helpful in indicating the possibility of chaotic motion. Several examples are given to show the advantages and limitations of the software implementations of the methods.


1994 ◽  
Vol 196 (3-4) ◽  
pp. 191-194 ◽  
Author(s):  
P.R. Sasi Kumar ◽  
V.P.N. Nampoori ◽  
C.P.G. Vallabhan

Author(s):  
Nuntaphong Koondilogpiboon ◽  
Tsuyoshi Inoue

Abstract In this paper, an efficient numerical method consisting of the real mode component mode synthesis (CMS) model reduction, shooting method with parallel computing, and Floquet analysis was developed for nonlinear rotordynamics analysis of a flexible rotor supported by a 4-lobe flexure pivot tilting pad journal bearing (FPTPJB) in load-on-pad (LOP) and load-between-pad (LBP) orientations in comparison to a fixed profile journal bearing (JB) of the same pad geometry. The method used the rotor's finite elements and bearing forces obtained from directly solving the Reynolds equation to determine the limit cycles and Hopf bifurcation types. For the investigated rotor and bearing parameters, the numerical results indicated that the onset speed of instability (OSI) of FPTPJB is considerably higher than that of JB of the same orientation. Also, FPTPJB in LOP orientation yielded higher OSI than the LBP one, whereas the OSI of JB in LOP orientation was substantially higher than the LBP counterpart. Nonlinear calculation results indicated that all bearing types and orientations gave subcritical Hopf bifurcation. The FPTPJB in LOP orientation produced the largest stable operating region, whereas the JB in LBP configuration yield the smallest one. The experiment showed subcritical Hopf bifurcation occurred at speed close to the calculated OSI in all cases except FPTPJB in LOP orientation that the OSI is higher than the maximum test rig speed. The whirling orbit had the same frequency as the first critical speed and precessed in the direction of shaft rotation.


Sign in / Sign up

Export Citation Format

Share Document