Variation of Size and Alignment in Carbon Nanotubes by Changes of Growth Condition

2001 ◽  
Vol 7 (S2) ◽  
pp. 428-429
Author(s):  
Paula P. Provencio ◽  
Michael P. Siegal ◽  
Donald L. Overmyer

Carbon nanotubes have previously been grown on Ni coated glass, aligned vertical to the substrate over a multi-centimeter square area1. Under vacuum, the aligned nanotubes were grown below 666° C (strain point of the best display glass) by plasma-enhanced hot filament, chemical vapor deposition. It was found, the size and alignment of the nanotubes could be varied by changing the dwell time and the thickness of the catalytic Ni layer by plasma etching. in more recent, ongoing studies, the size of carbon nanotubes is varied by changing the growth temperature and dwell time under acetylene/nitrogen atmosphere using chemical vapor deposition onto W and Ni coated Si.Multiwall carbon nanotube films are grown using a thermally-activated chemical vapor deposition process. Thin Ni catalyst layers are sputtered onto W-coated Si(100) and reduced in a 600°C CO anneal. Nanotubes then grow at temperatures ranging from 630 - 790°C in an acetylene/nitrogen mixture.

Author(s):  
K. P. Yung ◽  
J. Wei ◽  
B. K. Tay

Due to their extraordinary electrical, thermal and mechanical properties, carbon nanotubes have been foreseen as potential materials for electronics devices in the future. To integrate carbon nanotubes in electronic applications, carbon nanotubes would need to be grown on different metal layer. In this study, carbon nanotubes growth with Ni as catalyst on three different support layers, Cu, Al and Cr, by hot filament chemical vapor deposition (HFCVD) is reported. The nanotubes were grown using C2H2 acetylene as carbon feedstock, in a hydrogen and nitrogen atmosphere. The catalyst layers and their support layers were deposited by magnetron sputtering technique. Deposited films were annealed at 600 °C for 10 minutes before exposing to C2H2 for the growth of nanotubes at same temperature for another 10 minutes. The effects of the support layer have been investigated with reference to nanotubes formation. The morphology and microstructure of the films were measured and analyzed by scanning electron microscopy (SEM) and Raman spectrometer. It was found that reaction of the catalyst with its supporting layer has significant effects on the growth of nanotubes. For Cu or Cr as support layer, its effect on the nanotubes growth was minimal. However Al support layer prevented the growth of carbon nanotubes. The possible mechanisms for the observed results are proposed.


2008 ◽  
Vol 55-57 ◽  
pp. 533-536
Author(s):  
P. Saiprasert ◽  
D. Koolpiruck ◽  
S. Chiangga

The optimization of chemical vapor deposition synthesis conditions for multiwall carbon nanotubes (MWCNTs) was experimentally investigated. Carbon nanotubes were grown on cobalt substrate thicknesses of 20, 100 and 1000 nm at 700 and 900 0C with 2 replications. The configuration and morphology of the carbon nanotubes were investigated by scanning electron microscope and Fourier transform raman spectrometer, respectively. The tendency of the parameters was evaluated by statistical design of experiment. Observations on samples produced under our optimised production process, showed that a large number of MWCNTs bundles were produced. Diameter of MWCNTs bundles ranges between 30 and 100 nm throughout the samples. From the variance analysis of the Raman spectra we observe that the thickness of cobalt and temperature of synthesis are highly significant in which the coherence length and innermost diameter increase for either the thickness increases or the temperature decreases.


Sign in / Sign up

Export Citation Format

Share Document