Acid-catalyzed hydrolysis of 1,1-bis(methylthio)ethene. Buffer- and thiol-dependent changes in the rate-determining step

1983 ◽  
Vol 105 (10) ◽  
pp. 3220-3226 ◽  
Author(s):  
Tadashi Okuyama ◽  
Shoji Kawao ◽  
Takayuki Fueno
Keyword(s):  
Rate Determining Step ◽  
Acid Catalyzed ◽  
Hydrolysis Of

ChemInform Abstract: An ab initio Calculation of the Acid-Catalyzed Hydrolysis of N-Nitrosoamines. A Hypothesis on the Rate-Determining Step.

ChemInform ◽  
1987 ◽  
Vol 18 (28) ◽  
Author(s):  
NGUYEN MINH THO NGUYEN MINH THO ◽  
A. F. HEGARTY
Keyword(s):  
Ab Initio ◽  
Ab Initio Calculation ◽  
Rate Determining Step ◽  
Acid Catalyzed ◽  
Hydrolysis Of

scholarly journals The mechanism of the hydrolysis of acylimidazoles in aqueous mineral acids. The excess acidity method for reactions that are not acid catalyzed

1997 ◽  
Vol 75 (8) ◽  
pp. 1093-1098 ◽  
Author(s):  
Robin A. Cox
Keyword(s):  
Imidazole Ring ◽  
Carbonyl Oxygen ◽  
Pseudo First Order Reaction ◽  
Acid Media ◽  
Tetrahedral Intermediate ◽  
Reaction Rate Constants ◽  
Rate Determining Step ◽  
Reversible Addition ◽  
Acid Catalyzed ◽  
Hydrolysis Of

The mechanism of the hydrolysis of acetylimidazole in aqueous perchloric, sulfuric, and hydrochloric acid mixtures has been determined. Benzoylimidazole was also studied in the latter two acids. The method of analyzing the available data, pseudo-first-order reaction rate constants as a function of acid concentration and, in one case, temperature, is the excess acidity method, here applied to the same reaction in the three different acid media, allowing their comparison. The reaction is not acid catalyzed; the rates decrease with increasing acidity. The substrate reacts in the form that is monoprotonated on the imidazole ring; it is 100% protonated at acidities much lower than those used here. Acetylimidazole is shown to become diprotonated at high acidity [Formula: see text], protonating on the carbonyl oxygen, but the diprotonated form is not reactive. The hydrolysis involves the reversible addition of one water molecule to the substrate to give a tetrahedral intermediate; at low acidities the decomposition of this hydrate is the rate-determining step, but as the acidity increases and the water activity decreases its formation becomes rate limiting. Hydroxide catalysis was also observed in dilute perchloric acid, but this is swamped by nucleophilic catalysis by the acid anion in HCl and H2SO4. Keywords: acylimidazoles, excess acidity, hydrolysis, protonation, tetrahedral intermediate.

Acid-catalyzed hydrolysis of 4-diazo-isothiochroman-3-one. Comparison with the acyclic analog and the corresponding oxygen system

1997 ◽  
Vol 75 (1) ◽  
pp. 56-59 ◽  
Author(s):  
E.A. Jefferson ◽  
A.J. Kresge ◽  
S.W. Paine
Keyword(s):  
Carbon Atom ◽  
Negative Charge ◽  
Molecular Orbital Calculations ◽  
Am1 Calculations ◽  
Charge Delocalization ◽  
Rate Determining Step ◽  
Hydronium Ion ◽  
Acid Catalyzed ◽  
Group Migration ◽  
Hydrolysis Of

The acid-catalyzed hydrolysis of the cyclic diazothiolactone, 4-diazoisochroman-3-one (3) was found to occur with the hydronium-ion isotope effect, [Formula: see text] and to give the ring-contracted product, 1,3-dihydrobenzo[c]thiophene-1-carboxylic acid (4). This shows that protonation of the diazo carbon atom occurs in the rate-determining step and that the reaction also involves migration of the thio group. The hydronium-ion catalytic coefficient for this reaction, [Formula: see text], is 45 times less than that for hydrolysis of its acyclic thio ester analog, S-methyl phenyldiazothioacetate (5). Semiempirical AM1 molecular orbital calculations support the idea that this difference in reactivity is the result of increased delocalization of negative charge into the aromatic ring in the case of the cyclic substrate, which reduces the negative charge on the diazo carbon atom and makes it less susceptible to protonation. Key words: hydrolysis, diazoalkanes, charge delocalization, AM1 calculations, thio group migration.

Hydrolysis of trioxaadamantane ortho esters. II. Kinetic analysis and the nature of the rate-determining step

1984 ◽  
Vol 62 (6) ◽  
pp. 1074-1080 ◽  
Author(s):  
Robert A. McClelland ◽  
Patrick W. K. Lam
Keyword(s):  
Rate Constants ◽  
Product Formation ◽  
Low Ph ◽  
Acid Solutions ◽  
Ortho Ester ◽  
Rate Determining Step ◽  
Acid Catalyzed ◽  
Cation Hydration ◽  
Ortho Esters ◽  
Hydrolysis Of

A detailed kinetic study of the hydrolysis of a series of 3-aryl-2,4,10-trioxaadamantanes is reported. These ortho esters equilibrate with the ring-opened dialkoxycarbocation, in a very rapid process which could be studied using temperature-jump spectroscopy for aryl = 2,4-dimethylphenyl. Relaxation rate constants are of the order of 104 s−1; these could be analyzed to provide the rate constants for both the ring opening and the ring closing. Product formation from this equilibrating mixture is much slower. In acid solutions (0.01 M H+ −50% H2SO4), first-order rate constants for product formation initially increase with increasing acidity, but a maximum is reached at 20–35% H2SO4 and the rate then falls. This behavior is explained by a counterbalancing of two factors. Increasing acidity increases the amount of the dialkoxycarbocation in the initial equilibrium, but, outside the pH region, it decreases the rate of hydrolysis of this cation through a medium effect. Rate constants over a range of pH have been measured for two trioxaadamantanes and for the cation DEt+ derived by treatment of the ortho ester with triethyloxonium tetraafluoroborate. The latter models the cation formed in the ortho ester hydrolysis but it cannot ring close. Rate–pH profiles obtained in these systems are more complex than expected on the basis of rate-determining cation hydration. An interpretation is proposed with a change in rate-determining step between high pH and low pH. Cation hydration is rate determining at high pH but at low pH hemiorthoester decomposition becomes rate determining. Under these conditions the hemiorthoester equilibrates with both the dialkoxycarbocation and with the trioxaadamantane. The change in rate-determining step occurs because acid-catalyzed reversion of the hemiorthoester to dialkoxycarbocation is a faster process than acid-catalyzed hemiorthoester decomposition. This makes the latter rate-determining in acid solutions. Additional pathways available to the decomposition, however, make it the faster process at higher pH. A kinetic analysis furnishes all of the rate and equilibrium constants for the system, and provides support for the mechanistic interpretation. A comparison of these numbers with those obtained for the three stages in the hydrolysis of a simple monocyclic ortho ester underlines the novelty of the trioxaadamantane system.

Evidence for a change in rate-determining step in the acid-catalyzed hydrolysis of a vinyl ether

1971 ◽  
Vol 93 (23) ◽  
pp. 6294-6296 ◽  
Author(s):  
J. D. Cooper ◽  
V. P. Vitullo ◽  
D. L. Whalen
Keyword(s):  
Vinyl Ether ◽  
Rate Determining Step ◽  
Acid Catalyzed ◽  
Hydrolysis Of

The effect of polymeric and model imidazolium halides on the rate of hydrolysis of 4-acetoxy-3-nitrobenzoic acid

1985 ◽  
Vol 50 (4) ◽  
pp. 845-853 ◽  
Author(s):  
Miloslav Šorm ◽  
Miloslav Procházka ◽  
Jaroslav Kálal
Keyword(s):  
Catalyst Concentration ◽  
Low Molecular Weight ◽  
Imidazolium Chloride ◽  
First Order ◽  
Nitrobenzoic Acid ◽  
Rate Of Hydrolysis ◽  
Acid Catalyzed ◽  
Hydrolysis Of ◽  
Ethanol In Water ◽  
Direct Attack

The course of hydrolysis of an ester, 4-acetoxy-3-nitrobenzoic acid catalyzed with poly(1-methyl-3-allylimidazolium bromide) (IIa), poly[l-methyl-3-(2-propinyl)imidazolium chloride] (IIb) and poly[l-methyl-3-(2-methacryloyloxyethyl)imidazolium bromide] (IIc) in a 28.5% aqueous ethanol was investigated as a function of pH and compared with low-molecular weight models, viz., l-methyl-3-alkylimidazolium bromides (the alkyl group being methyl, propyl, and hexyl, resp). Polymers IIb, IIc possessed a higher activity at pH above 9, while the models were more active at a lower pH with a maximum at pH 7.67. The catalytic activity at the higher pH is attributed to an attack by the OH- group, while at the lower pH it is assigned to a direct attack of water on the substrate. The rate of hydrolysis of 4-acetoxy-3-nitrobenzoic acid is proportional to the catalyst concentration [IIc] and proceeds as a first-order reaction. The hydrolysis depends on the composition of the solvent and was highest at 28.5% (vol.) of ethanol in water. The hydrolysis of a neutral ester, 4-nitrophenyl acetate, was not accelerated by IIc.

Benzyl ethers of methyl α-D-glucopyranoside

1980 ◽  
Vol 45 (7) ◽  
pp. 1959-1963 ◽  
Author(s):  
Dušan Joniak ◽  
Božena Košíková ◽  
Ludmila Kosáková
Keyword(s):  
Kinetic Study ◽  
Spectrophotometric Determination ◽  
Reductive Cleavage ◽  
Ether Bond ◽  
Benzyl Ethers ◽  
Acid Catalyzed ◽  
Model Substances ◽  
Hydrolysis Of

Methyl 4-O-(3-methoxy-4-hydroxybenzyl) and methyl 4-O-(3,5-dimethoxy-4-hydroxybenzyl)-α-D-glucopyranoside and their 6-O-isomers were prepared as model substances for the ether lignin-saccharide bond by reductive cleavage of corresponding 4,6-O-benzylidene derivatives. Kinetic study of acid-catalyzed hydrolysis of the compounds prepared was carried out by spectrophotometric determination of the benzyl alcoholic groups set free, after their reaction with quinonemonochloroimide, and it showed the low stability of the p-hydroxybenzyl ether bond.

Sign in / Sign up

Export Citation Format

Share Document