scholarly journals Conversion of Methane with Oxygen to Produce Hydrogen Catalyzed by Triatomic Rh3– Cluster Anion

JACS Au ◽  
2021 ◽  
Author(s):  
Yi Ren ◽  
Yuan Yang ◽  
Yan-Xia Zhao ◽  
Sheng-Gui He
2020 ◽  
pp. 73-83
Author(s):  
L. V. Morozova ◽  
◽  
I. A. Drozdova ◽  

The xerogels in the system 0.88 mol.% ZrO2 − 0.12 mol.% CeO2 were obtained by the method of coprecipitation in a neutral (pH = 7) and slightly alkaline (pH = 9) medium under the influence of ultrasound with the size of the agglomerates 70 – 230 nm. It is shown that the coprecipitation of hydroxides of zirconium and cerium at pH = 9 with the use of ultrasonic treatment facilitates the formation of a primary crystal is symbolic of the particles in the xerogel, whose size is ~ 5 nm, whereas the xerogel synthesized in a neutral environment consists only of the x-ray amorphous phase. The effect of pH-precipitation on deposition processes of dehydration of the xerogels and crystallization solid solution based on zirconia oxide in the metastable pseudocubic modification (с′-ZrO2) was discovered. It was found that in the temperature range 500 – 800 °C there is a phase transition с′-ZrO2 → t-ZrO2, the size of the crystallites of the formed tetragonal solid solutions is 8 and 11 nm. The method of low-temperature nitrogen adsorption were investigated dispersion properties and characteristics of the pore structure of the powders of the solid solution Zr0.88Ce0.12O2. It is determined that the specific surface area of t-ZrO2 samples obtained after firing at 800 °C is 117 and 178 m2/g, the total pore volume reaches 0.300 − 0.325 cm3/g, the pore size distribution is monomodal and is in the range of 2 − 8 nm. The effect of thermal “aging” at a temperature of 800 °C (40 h) on the structure and dispersion of the solid solution t-ZrO2 powders was studied.


2019 ◽  
pp. 96-105
Author(s):  
M. L. Shishkova ◽  
N. V. Yakovleva

The paper considers science and engineering aspects of catalytically active compositions creation as regards immobilized catalysts for reforming hydrocarbon raw materials into hydrogen fuel. The authors investigate synthesis of catalytic powder mixtures and manufacturing of functional coatings by supersonic cold gas dynamic spraying. Research results in the field of creation of catalysts for steam conversion of methane to hydrogenous fuel on the metal support (Cr15Al15 tape support) are given. Composite powder mixtures (Ni–Al–Al(OH)3– Ca(OH)2–Mg(OH)2) were used as starting materials.


2021 ◽  
Author(s):  
Qi Li ◽  
Yuxing Ouyang ◽  
Hongliang Li ◽  
Liangbing Wang ◽  
Jie Zeng

2020 ◽  
Author(s):  
O. A. Kazakova ◽  
N. V. Vinichenko ◽  
A. E. Fedorov ◽  
A. S. Belyi

Author(s):  
Xiaojiao Cai ◽  
Siyuan Fang ◽  
Yun Hang Hu

Direct and highly efficient methane conversion to methanol under mild conditions is achieved via photocatalysis over Au–Pd/TiO2.


ACS Catalysis ◽  
2021 ◽  
pp. 7719-7734
Author(s):  
Florian Göltl ◽  
Saurabh Bhandari ◽  
Manos Mavrikakis

2021 ◽  
Author(s):  
Yu dong Tian ◽  
Lingyu Piao ◽  
Xiaobo Chen

The conversion of methane (CH4) to methanol (CH3OH) has attracted much attention in catalysis. However, the traditional thermocatalytic conversion of CH4 to CH3OH is largely restricted by the thermodynamic equilibrium...


Sign in / Sign up

Export Citation Format

Share Document