Magnetron Sputtering Preparation of Nitrogen-Incorporated Lithium–Aluminum–Titanium Phosphate Based Thin Film Electrolytes for All-Solid-State Lithium Ion Batteries

2012 ◽  
Vol 116 (5) ◽  
pp. 3817-3826 ◽  
Author(s):  
Guoqiang Tan ◽  
Feng Wu ◽  
Li Li ◽  
Yadong Liu ◽  
Renjie Chen
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Magnetron Sputtering ◽  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Titanium Phosphate ◽  
Lithium Aluminum

Thin-Film Solid State Lithium-Ion Batteries of the LiCoC2/LiPON/Si@O@Al System

2021 ◽  
Vol 50 (5) ◽  
pp. 333-338
Author(s):  
A. S. Rudy ◽  
A. A. Mironenko ◽  
V. V. Naumov ◽  
I. S. Fedorov ◽  
A. M. Skundin ◽  
...  
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Lithium Ion Batteries ◽  
Lithium Ion

PROPERTIES OF ALL-SOLID-STATE LITHIUM-ION RECHARGEABLE BATTERIES DEPOSITED BY RF MAGNETRON SPUTTERING

2013 ◽  
Vol 27 (22) ◽  
pp. 1350156 ◽  
Author(s):  
R. J. ZHU ◽  
Y. REN ◽  
L. Q. GENG ◽  
T. CHEN ◽  
L. X. LI ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Solid State ◽  
Magnetron Sputtering ◽  
Coulombic Efficiency ◽  
Electronic Conductivity ◽  
Lithium Ion ◽  
Rf Magnetron Sputtering ◽  
Rechargeable Batteries ◽  
Voltage Range

Amorphous V 2 O 5, LiPON and Li 2 Mn 2 O 4 thin films were fabricated by RF magnetron sputtering methods and the morphology of thin films were characterized by scanning electron microscopy. Then with these three materials deposited as the anode, solid electrolyte, cathode, and vanadium as current collector, a rocking-chair type of all-solid-state thin-film-type Lithium-ion rechargeable battery was prepared by using the same sputtering parameters on stainless steel substrates. Electrochemical studies show that the thin film battery has a good charge–discharge characteristic in the voltage range of 0.3–3.5 V, and after 30 cycles the cell performance turned to become stabilized with the charge capacity of 9 μAh/cm2, and capacity loss of single-cycle of about 0.2%. At the same time, due to electronic conductivity of the electrolyte film, self-discharge may exist, resulting in approximately 96.6% Coulombic efficiency.

Developments of high-voltage all-solid-state thin-film lithium ion batteries

2006 ◽  
Vol 154 (1) ◽  
pp. 232-238 ◽  
Author(s):  
J. Schwenzel ◽  
V. Thangadurai ◽  
W. Weppner
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Lithium Ion Batteries ◽  
High Voltage ◽  
Lithium Ion

Transparent Thin Film Solid-State Lithium Ion Batteries

2018 ◽  
Vol 11 (1) ◽  
pp. 683-690 ◽  
Author(s):  
Sami Oukassi ◽  
Loic Baggetto ◽  
Christophe Dubarry ◽  
Lucie Le Van-Jodin ◽  
Séverine Poncet ◽  
...  
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Lithium Ion Batteries ◽  
Lithium Ion

VCuxOy Thin Film by Magnetron Sputtering as Cathode Material for Thin Film Lithium-Ion Microbatteries

2015 ◽  
Vol 645-646 ◽  
pp. 1145-1149
Author(s):  
Jie Lin ◽  
Jian Lai Guo ◽  
Chang Liu ◽  
Hang Guo
Keyword(s):  
Thin Film ◽  
Magnetron Sputtering ◽  
Cathode Material ◽  
Electrochemical Properties ◽  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Cycle Performance ◽  
Electrochemical Tests ◽  
Effect Of Doping

A Cu doped V2O5film for lithium-ion batteries is prepared by magnetron sputtered using a vanadium target. Coppers are doped in varying proportions to investigate the effect of doping on the electrochemical properties. In comparison, the surface of doped samples is smooth and uniform. And the results of electrochemical tests indicate that the proper doped films (V: Cu=8: 1 by area) exhibit better cycle performance, wider voltage plateaus and higher capacity than other samples.

scholarly journals Dual Cation- and Anion-Based Redox Process in Lithium Titanium Oxysulfide Thin Film Cathodes for All-Solid-State Lithium-Ion Batteries

2017 ◽  
Vol 9 (3) ◽  
pp. 2275-2284 ◽  
Author(s):  
Vincent Dubois ◽  
Brigitte Pecquenard ◽  
Samantha Soulé ◽  
Hervé Martinez ◽  
Frédéric Le Cras
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Redox Process ◽  
Lithium Titanium

scholarly journals Твердотельный литий-ионный аккумулятор: структура, технология и характеристики

2020 ◽  
Vol 46 (5) ◽  
pp. 15
Author(s):  
А.С. Рудый ◽  
А.А. Мироненко ◽  
В.В. Наумов ◽  
А.М. Скундин ◽  
Т.Л. Кулова ◽  
...  
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Fermi Level ◽  
Lithium Ion Batteries ◽  
Lithium Ion Battery ◽  
Lithium Ion ◽  
Test Results ◽  
Lithium Ions ◽  
Discharge Characteristics ◽  
Charge Discharge

The design description and test results of an all solid-state thin-film lithium-ion battery are provided. It is shown that the features of its charge-discharge characteristics are associated with a change in the Fermi level of the electrodes and are caused by a change in the concentration of lithium ions in the course of the charge-discharge. The specific capacitive characteristics of the layout are determined, which are comparable with the characteristics of industrial solid-state lithium-ion batteries.

NASICON type ordered mesoporous lithium-aluminum-titanium-phosphate as electrode materials for lithium-ion batteries

2017 ◽  
Vol 240 ◽  
pp. 57-64 ◽  
Author(s):  
Piyali Bhanja ◽  
Chenrayan Senthil ◽  
Astam Kumar Patra ◽  
Manickam Sasidharan ◽  
Asim Bhaumik
Keyword(s):  
Lithium Ion Batteries ◽  
Electrode Materials ◽  
Lithium Ion ◽  
Titanium Phosphate ◽  
Lithium Aluminum ◽  
Nasicon Type ◽  
Ordered Mesoporous

scholarly journals Deposition and performance of all solid-state thin-film lithium-ion batteries composed of amorphous Si/LiPON/VO-LiPO multilayers

2020 ◽  
Vol 697 ◽  
pp. 137840
Author(s):  
Shogo Kanazawa ◽  
Tomoaki Baba ◽  
Kotaro Yoneda ◽  
Minoru Mizuhata ◽  
Isaku Kanno
Keyword(s):  
Thin Film ◽  
Solid State ◽  
Lithium Ion Batteries ◽  
Lithium Ion ◽  
Amorphous Si ◽  
And Performance
Sign in / Sign up

Export Citation Format

Share Document