DNA-intercalator interactions: structural and physical analysis using atomic force microscopy in solution

Soft Matter ◽  
2013 ◽  
Vol 9 (47) ◽  
pp. 11233 ◽  
Author(s):  
M. Maaloum ◽  
P. Muller ◽  
S. Harlepp
2004 ◽  
Vol 811 ◽  
Author(s):  
J. Pétry ◽  
W. Vandervorst ◽  
O. Richard ◽  
T. Conard ◽  
P. DeWolf ◽  
...  

ABSTRACTIn the path to the introduction of high-k dielectric into IC components, a large number of challenges have still to be solved. Some of the major issues concern the low mobility of carriers and the reliability of the devices. Trapped charges in the stack have been identified as being the cause of these issues. With this in mind, we used Conducting Atomic Force Microscopy, combined with physical analysis to understand the nature of these charges. In this contribution, we have studied the uniformity of thin HfO2 layers, with and without anneal. The Conducting Atomic Force microscopy measurements show spots of higher conductivity. Recording local IV's in those ‘weak’ spots suggests that they consist of positive charge. On the other hand, XPS and ToFSIMS analysis show a diffusion of the interfacial SiO2 upwards into the high-k layer. Finally, the comparison of samples with differing high-k material and crystallinity indicates a strong correlation between the weak spots and the presence of silicon in the film.


2000 ◽  
Vol 10 (1-2) ◽  
pp. 15
Author(s):  
Eugene Sprague ◽  
Julio C. Palmaz ◽  
Cristina Simon ◽  
Aaron Watson

2020 ◽  
Author(s):  
Mitsunori Kitta

This manuscript propose the operando detection technique of the physical properties change of electrolyte during Li-metal battery operation.The physical properties of electrolyte solution such as viscosity (η) and mass densities (ρ) highly affect the feature of electrochemical Li-metal deposition on the Li-metal electrode surface. Therefore, the operando technique for detection these properties change near the electrode surface is highly needed to investigate the true reaction of Li-metal electrode. Here, this study proved that one of the atomic force microscopy based analysis, energy dissipation analysis of cantilever during force curve motion, was really promising for the direct investigation of that. The solution drag of electrolyte, which is controlled by the physical properties, is directly concern the energy dissipation of cantilever motion. In the experiment, increasing the energy dissipation was really observed during the Li-metal dissolution (discharge) reaction, understanding as the increment of η and ρ of electrolyte via increasing of Li-ion concentration. Further, the dissipation energy change was well synchronized to the charge-discharge reaction of Li-metal electrode.This study is the first report for direct observation of the physical properties change of electrolyte on Li-metal electrode reaction, and proposed technique should be widely interesting to the basic interfacial electrochemistry, fundamental researches of solid-liquid interface, as well as the battery researches.


2020 ◽  
Author(s):  
Benjamin P. A. Gabriele ◽  
Craig J. Williams ◽  
Douglas Stauffer ◽  
Brian Derby ◽  
Aurora J. Cruz-Cabeza

<div> <div> <div> <p>Single crystals of aspirin form I were cleaved and indented on their dominant face. Upon inspection, it was possible to observe strongly anisotropic shallow lateral cracks due to the extreme low surface roughness after cleavage. Atomic Force Microscopy (AFM) imaging showed spalling fractures nucleating from the indent corners, forming terraces with a height of one or two interplanar spacings d100. The formation of such spalling fractures in aspirin was rationalised using basic calculations of attachment energies, showing how (100) layers are poorly bonded when compared to their relatively higher intralayer bonding. An attempt at explaining the preferential propagation of these fractures along the [010] direction is discussed. </p> </div> </div> </div>


Sign in / Sign up

Export Citation Format

Share Document