Mechanically exfoliated g-C3N4 thin nanosheets by ball milling as high performance photocatalysts

RSC Advances ◽  
2015 ◽  
Vol 5 (69) ◽  
pp. 56239-56243 ◽  
Author(s):  
Kaixing Zhu ◽  
Wenjun Wang ◽  
Alan Meng ◽  
Meng Zhao ◽  
Junhu Wang ◽  
...  

Here, a simple one-step ball milling method is presented for synthesis of mechanically exfoliated g-C3N4 (MECN) thin nanosheets at large scales for the first time.

RSC Advances ◽  
2015 ◽  
Vol 5 (48) ◽  
pp. 38527-38532 ◽  
Author(s):  
Di Guo ◽  
Hongxu Guo ◽  
Yingchang Ke ◽  
Dongfang Wang ◽  
Jianhua Chen ◽  
...  

A facile one-step mechanochemical process from CuCl2·2H2O and thiourea to fabricate novel [Cu(tu)]Cl·1/2H2O nanobelts has been observed for the first time, and the nanobelts were used as an electrode material for a supercapacitor.


2015 ◽  
Vol 3 (21) ◽  
pp. 11199-11202 ◽  
Author(s):  
Ning Lin ◽  
Liangbiao Wang ◽  
Jianbin Zhou ◽  
Jie Zhou ◽  
Ying Han ◽  
...  

High-performance Si/Ge anodes are prepared through a one-step solid-state metathesis reaction between Mg2Si and GeO2 for the first time.


2020 ◽  
Vol 9 (3) ◽  
pp. 1389-1394

The one-step synthesis of high-quality graphene derivatives via CVD process has gained considerable importance nowadays for high-performance electronics and sensors. However, the use of harsh chemicals, high temperature, sensitivity, and the problem of separation of graphene from the substrate, motivated the one-step synthesis of graphene from a non-graphitic precursor, bypassing the use of graphite. In this paper, we have reported for the first time, the synthesis of graphene nanosheets from sugarcane bagasse at the normal atmospheric condition in a single step, avoiding the formation of GO. Here, the pyrolysis of sugarcane bagasse was carried out in the temperature range of 250-450o C in the presence of sodium hydroxide. The results suggested that even the low temperature (250–450o C) facilitated the development of graphitic planes via condensation and aromatization of the glucose monomers present in the precursor. The XRD pattern showed 2θ at around 25o in each case, which confirmed the formation of graphene instead of GO. The FESEM, TEM, and EDX analysis proved the formation of few-layer nanosheets of graphene from carbon-rich waste precursors in a single step.


RSC Advances ◽  
2016 ◽  
Vol 6 (104) ◽  
pp. 102155-102158 ◽  
Author(s):  
Yuchen Hao ◽  
Xiaoli Dong ◽  
Xiuying Wang ◽  
Hongchao Ma ◽  
Xiufang Zhang

A Bi2MoO6 mesoporous hollow framework composed of atomically-thin nanosheets was fabricated for the first time using a one-step solvothermal route and exhibited improved photocatalytic performance for water oxidation.


2016 ◽  
Vol 4 (9) ◽  
pp. 3228-3232 ◽  
Author(s):  
D. Duveau ◽  
S. Sananes Israel ◽  
J. Fullenwarth ◽  
F. Cunin ◽  
L. Monconduit

For the first time it is demonstrated that a dense SiP2 pyrite-type obtained by a very simple ball milling method delivers outstanding capacity in both lithium and sodium batteries with up to 1000 mA h g−1 and 572 mA h g−1 sustained after 30 and 15 cycles respectively.


RSC Advances ◽  
2016 ◽  
Vol 6 (55) ◽  
pp. 49625-49632 ◽  
Author(s):  
Hongwei Liu ◽  
Lu Zhang ◽  
Muhammad Asif ◽  
Fei Xiao ◽  
Junwu Xiao ◽  
...  

CdS-modified mesoporous titanate nanobelts (CTNS) were prepared successfully by one step, using TiO2 nanobelts and CdS quantum dots, and applied as an adsorbent for the first time for the removal of typical cationic dyes.


2019 ◽  
Vol 4 (7) ◽  
pp. 1565-1571 ◽  
Author(s):  
Hongming Yi ◽  
Le Lin ◽  
Moxiang Ling ◽  
Zhiqiang Lv ◽  
Rui Li ◽  
...  

Author(s):  
Ming-yuan Cao ◽  
Ju-wu Hu ◽  
Zhen Gu ◽  
Wei Xiong ◽  
Lei Wu ◽  
...  

Abstract Four caffeoylquinic acid derivatives from the Gunura procumbens flowers (GPF) were successfully isolated and purified by high-speed counter-current chromatography (HSCCC). Ethyl acetate–methanol–water (3:1:3, v/v/v) was the optimum biphasic solvent system, which was selected by high-performance liquid chromatography (HPLC) and run on a preparative scale where the lower aqueous phase was used as the mobile phase with a head-to-tail elution mode. Chlorogenic acid (3.83 mg), Isochlorogenic acid A (6.51 mg), Isochlorogenic acid B (4.38 mg) and Isochlorogenic acid C (4.47 mg) were obtained for the first time in an one-step HSCCC separation from 800 mg of the crude extracts. The purities of four compounds were determined to be >95% by HPLC. Chemical structures of each isolated compounds were identified by nuclear magnetic resonance and electrospray ionization mass spectrometry methods. It is worth noting that all the four compounds were isolated here for the first time from GPF and this work confirms the effectiveness of HSCCC for the separation of compounds contained in complex samples, and provides a foundation for further exploitation of G. procumbens.


Sign in / Sign up

Export Citation Format

Share Document