Compact, low insertion loss, sharp rejection wideband bandpass filters using dual-mode ring resonators with tuning stubs

2001 ◽  
Vol 37 (22) ◽  
pp. 1345 ◽  
Author(s):  
L.-H. Hsieh ◽  
K. Chang
2008 ◽  
Vol E91-C (1) ◽  
pp. 117-119 ◽  
Author(s):  
S.-B. JHONG ◽  
M.-H. WENG ◽  
S. WU ◽  
C.-Y. HUNG ◽  
M.-S. LEE

Frequenz ◽  
2016 ◽  
Vol 70 (9-10) ◽  
Author(s):  
Chuanming Zhu ◽  
Jin Xu ◽  
Wei Kang ◽  
Zhenxin Hu ◽  
Wen Wu

AbstractIn this paper, a miniaturized dual-band bandpass filter (DB-BPF) using embedded dual-mode resonator (DMR) with controllable bandwidths is proposed. Two passbands are generated by two sets of resonators operating at two different frequencies. One set of resonators is utilized not only as the resonant elements that yield the lower passband, but also as the feeding structures with source-load coupling to excite the other to produce the upper passband. Sufficient degrees of freedom are achieved to control the center frequencies and bandwidths of two passbands. Moreover, multiple transmission zeros (TZs) are created to improve the passband selectivity of the filter. The design of the filter has been demonstrated by the measurement. The filter features not only miniaturized circuit sizes, low insertion loss, independently controllable central frequencies, but also controllable bandwidths and TZs.


2013 ◽  
Vol 3 (6) ◽  
pp. 832-837 ◽  
Author(s):  
Zhihua Zhu ◽  
Xueqian Zhang ◽  
Jianqiang Gu ◽  
Ranjan Singh ◽  
Zhen Tian ◽  
...  

Frequenz ◽  
2017 ◽  
Vol 71 (5-6) ◽  
Author(s):  
Yu-Xue Ji ◽  
Jin Xu ◽  
Zhao-Zhao Li ◽  
Huan Wang ◽  
Jin-Jie Huang

AbstractThis paper proposes a quasi-elliptic bandpass filter-integrated single-pole double-throw (SPDT) switch. The series-parallel configuration of p-i-n diodes embedded into the impedance matching circuit is proposed to combine two quasi-elliptic response bandpass filters to constitute the proposed SPDT switch. To validate our design approach, a proposed quasi-elliptic bandpass filter-integrated SPDT switch is designed and fabricated with a central frequency of 1.25 GHz and a 3 dB fractional bandwidth of 16 %. Low insertion loss in the on state and good isolation in the off state are achieved. The switch size including bias circuits but excluding feeding lines is 0.447λ


Sign in / Sign up

Export Citation Format

Share Document