Vascular Injuries following Knee Dislocation

2020 ◽  
Vol 33 (04) ◽  
pp. 351-356 ◽  
Author(s):  
James P. Stannard ◽  
Anna J. Schreiner

AbstractKnee dislocations (KDs) are frequently found in high-energy impact injuries, ranging from automobile accidents to contact sports. KDs require careful examination due to the limb-threatening nature of these injuries. A key examination in any KD comprises a proper assessment of the vascular status. The risk of popliteal artery injury with a KD has varied from 7 to 40%, with more contemporary studies reporting injury in the range of 7 to 15%. The notion of mandatory emergent arteriography was challenged in the trauma literature as several small retrospective studies suggested that selective arteriography was a safe and effective treatment protocol. New imaging modalities have evolved and have found their way into trauma surgery. Computed tomography angiography and magnetic resonance angiography are two contemporary imaging modalities that have different characteristics as well as availability. Arteriography has been the gold standard and is a reliable and proven method of evaluation. However, it has a number of negative aspects that must be considered when determining the ideal imaging for a patient following KD. Besides cost savings of about more than US$500,000, conventional arteriography, which comprises the use of X-ray, arterial puncture and cannulation, and the use of contrast agents containing iodine, has got a complication rate as high as 9% and more patient discomfort compared with the new imaging modalities. This clinical practice review documents that our algorithm of clinical examination first combined with advanced imaging in cases with abnormalities documented on examination is a safe and prudent policy in treating patients following KD.

1998 ◽  
Vol 555 ◽  
Author(s):  
H. Fritze ◽  
A. Schnittker ◽  
T. Witke ◽  
C. Rüscher ◽  
S. Weber ◽  
...  

AbstractPulsed Laser Deposition (PLD) allows the ablation of nonconductive and high melting point target materials and the preparation of films with complex composition. High energy impact leads to melting and evaporation of the target material in a single step. In case of mullite ablation, the flux of the metal components is stoichiometric. Under reduced pressure the oxygen content in the layers decreases. However, after a short oxidation treatment, the formation of mullite in the coating is completed, as confirmed by IR spectroscopy and XRD investigations. For a commercial Si-SiC precoated C/C material, the effectiveness of additional PLD mullite layers as outer oxidation protection is tested in the temperature range 773 K < T < 1873 K. Mullite coatings with a thickness of 2.5 pm improve the oxidation behaviour significantly. Because of SiO2 formation at the mullite-SiC interface, all samples exhibited a mass increase upon oxidation. For oxidation durations of three days, only amorphous SiO2 is formed at the mullite-SiC interface. The inward diffusion of oxygen across the outer mullite-containing layer controls the kinetics of the reaction, as was deduced from 18O diffusivity measurements in PLD mullite layers. At temperatures close to the eutectic temperature (1860 K), mullite can seal defects. The calculated oxidation rates resulting from the diffusion parameters in SiO2 and mullite are close to the thermogravimetric data.


2008 ◽  
Vol 43 (13) ◽  
pp. 4658-4665 ◽  
Author(s):  
Li-feng Hou ◽  
Ying-hui Wei ◽  
Bao-sheng Liu ◽  
Bing-she Xu

2013 ◽  
Vol 57 (5) ◽  
pp. 1196-1203 ◽  
Author(s):  
Andrew G. Georgiadis ◽  
Farah H. Mohammad ◽  
Kristin T. Mizerik ◽  
Timothy J. Nypaver ◽  
Alexander D. Shepard

1979 ◽  
Vol 105 (8) ◽  
pp. 957-967
Author(s):  
Salem D. Ramaswamy ◽  
Seng-Lip Lee ◽  
M.H. Abdul Khader ◽  
Raja V. Subrahmanyam ◽  
Mohamed A. Aziz
Keyword(s):  

Author(s):  
Mohamed Houssein Ghandour ◽  
Annie-Claude Bayeul-Lainé ◽  
Olivier Coutier-Delgosha
Keyword(s):  

2019 ◽  
Vol 2019 ◽  
pp. 1-6 ◽  
Author(s):  
Rita Henriques ◽  
Diogo Ramalho ◽  
Joaquim Soares do Brito ◽  
Pedro Rocha ◽  
André Spranger ◽  
...  

Introduction. Pipkin fractures are rare events and usually occur as a consequence for high-energy trauma. Surgery to obtain anatomical reduction and fixation is the mainstay treatment for the majority of these injuries; nonetheless, controversy exists regarding the best surgical approach. Description of the Case. We present the case of a 41-year-old male, which sustained a type II Pipkin fracture following a motorcycle accident. In the emergency department, an emergent closed reduction was performed, followed by surgery five days later. Using a surgical hip dislocation, a successful anatomical reduction and fixation was performed. After three years of follow-up, the patient presented with a normal range of motion, absent signs for avascular necrosis or posttraumatic arthritis, but with a grade II heterotopic ossification. Discussion. Safe surgical hip dislocation allows full access to the femoral head and acetabulum, without increasing the risk for a femoral head avascular necrosis or posttraumatic arthritis. Simultaneously, this surgical approach gives the opportunity to repair associated acetabular or labral lesions, which explains the growing popularity with this technique. Conclusion. Although technically demanding, safe surgical hip dislocation represents an excellent option in the reduction and fixation for Pipkin fractures.


2019 ◽  
Vol 9 (4) ◽  
pp. e0258-e0258
Author(s):  
Elise Britt ◽  
D.C. Covey

Sign in / Sign up

Export Citation Format

Share Document