Wind Tunnel Test Study on Pipeline Suspension Bridge via Aeroelastic Model with π Connection

2019 ◽  
Vol 10 (1) ◽  
pp. 04018025 ◽  
Author(s):  
G. H. Li ◽  
W. J. Wang ◽  
X. C. Ma ◽  
L. B. Zuo ◽  
F. B. Wang ◽  
...  
Keyword(s):  
Wind Tunnel ◽  
Wind Tunnel Test ◽  
Suspension Bridge ◽  
Test Study ◽  
Aeroelastic Model

Experimental Study of the Nonlinear Torsional Flutter of a Long-Span Suspension Bridge with a Double-Deck Truss Girder

2021 ◽  
pp. 2150102
Author(s):  
Ming Li ◽  
Yanguo Sun ◽  
Yongfu Lei ◽  
Haili Liao ◽  
Mingshui Li
Keyword(s):  
Wind Tunnel ◽  
Model Test ◽  
Wind Tunnel Test ◽  
Suspension Bridge ◽  
Suspension Bridges ◽  
Nonlinear Flutter ◽  
Long Span ◽  
Aeroelastic Model ◽  
Flutter Analysis ◽  
Section Model

The purpose of this study is to investigate the nonlinear torsional flutter of a long-span suspension bridge with a double-deck truss girder. First, the characteristics of nonlinear flutter are studied using the section model in the wind tunnel test. Different aerodynamic measures, e.g. upper and lower stabilizers and horizontal flaps, are applied to improve the flutter performance of the double-deck truss girder. Then, the full bridge aeroelastic model is tested in the wind tunnel to further examine the flutter performance of the bridge with the optimal truss girder. Finally, three-dimensional (3D) flutter analysis is performed to study the static wind-induced effects on the nonlinear flutter of the long-span suspension bridge. The results show that single-degree-of-freedom torsional limit cycle oscillations occur at large amplitudes for the double-deck truss section at the attack angles of [Formula: see text] and [Formula: see text]. The upper and lower stabilizers installed on the upper and lower decks, respectively, and the flaps installed near the bottoms of the sidewalks can all effectively alleviate the torsional flutter responses. Meanwhile, it is found that the torsional flutter responses of the truss girder in the aeroelastic model test are much smaller than those in the section model test. The 3D flutter analysis demonstrates that the large discrepancies between the flutter responses of the two model experiments can be attributed to the additional attack angle caused by the static wind-induced displacements. This finding highlights the importance and necessity of considering the static wind-induced effects in the flutter design of long-span suspension bridges.

Wind Tunnel Experimental Research on Flutter Stability of Liujiaxia Bridge

2013 ◽  
Vol 361-363 ◽  
pp. 1105-1109
Author(s):  
Chun Sheng Shu
Keyword(s):  
Wind Tunnel ◽  
Critical Velocity ◽  
Experimental Research ◽  
Wind Tunnel Test ◽  
Suspension Bridge ◽  
Wind Tunnel Tests

Liujiaxia Bridge is a truss stiffening girder suspension bridge which span is 536m, and it is the narrowest suspension bridge with the same scale, so the problems of flutter stability are prominent. Results of wind tunnel test show that its critical velocity cannot meet the requirements without any aerodynamic measures. Based on above considerations, seven kinds of aerodynamic measures are proposed, respectively wind tunnel tests are conducted. The results show that the program, in which the upper central stable board is 1.12m high and the under central stable board is 1.28m high, can meet the requirements. The results of this study provide some references to solving the problem of wind-resistant stability of narrow deck suspension bridge.

Wind Tunnel Test and the Analysis of Buffeting Performance of Free-Standing Tower of Cable-Stayed Bridge under Yaw Wind

2012 ◽  
Vol 532-533 ◽  
pp. 215-219
Author(s):  
Guo Hui Zhao ◽  
Yu Li ◽  
Hua Bai
Keyword(s):  
Wind Speed ◽  
Wind Tunnel ◽  
Wind Tunnel Test ◽  
Free Standing ◽  
Buffeting Response ◽  
Cable Stayed Bridge ◽  
Aeroelastic Model ◽  
Navigation Channel ◽  
Yaw Angle

The buffeting performance of free-standing tower of JiangHai Navigation Channel Bridge, a cable-stayed bridge, under yaw wind is investigated by means of wind tunnel test of aeroelastic model. It is found that the variation of buffeting response of free-standing tower with wind yaw angle is not monotonous. The lateral buffeting response on the top of the free-standing tower reach their minimal values and maximal values at around 150°and 180°of wind yaw angle respectively and the longitudinal buffeting response attain their maximal values at around 90°of wind yaw angle. Also, at the 2/3 height of the tower the lateral buffeting response and torsional buffeting response get their minimal values at around 150°of wind yaw angle, and at around 180°achieve the maximal values. It is also seen that, the buffeting response changes with the wind speed at a conic curve approximately.

scholarly journals Aerodynamic study of a suspension bridge deck by CFD simulations, wind tunnel tests and full-scale observations

2021 ◽  
Vol 1201 (1) ◽  
pp. 012007
Author(s):  
I. Kusano ◽  
E. Cheynet ◽  
J. B. Jakobsen ◽  
J. Snæbjörnsson
Keyword(s):  
Wind Tunnel ◽  
Wind Tunnel Test ◽  
Suspension Bridge ◽  
Aerodynamic Characteristics ◽  
Full Scale ◽  
Navier Stokes ◽  
Cfd Simulations ◽  
Wind Tunnel Tests ◽  
Long Span Bridges ◽  
Wide Range

Abstract Assessing the aerodynamic characteristics of long-span bridges is fundamental for their design. Depending on the terrain complexity and local wind conditions, episodes of large angles of attack (AoA) of 15° may be observed. However, such large AoAs ( above 10°) are often overlooked in the design process. This paper studies the aerodynamics properties of a flow around a single-box girder for a wide range of AoAs, from –20° to 20°, using numerical simulations. The simulations are based on a 2D unsteady Reynolds-averaged Navier–Stokes (URANS) approach using the k − ω SST turbulence model with a Reynolds number of 1.6 × 105. Numerically obtained aerodynamic static coefficients were compared to wind tunnel test data. The CFD results were generally in good agreement with the wind tunnel tests, especially for small AoAs and positive AoAs. More discrepancies were observed for large negative AoA, likely due to the limitation of modelling 3D railings with 2D simulations. The simulated velocity deficit downstream of the deck was consistent with the one measured in full-scale using short-range Doppler wind lidar instruments. Finally, the Strouhal number from the CFD simulations were in agreement with the value obtained from the full-scale data.

scholarly journals Design and Optimization of an Aeroservoelastic Wind Tunnel Model

Fluids ◽  
2020 ◽  
Vol 5 (1) ◽  
pp. 35 ◽  
Author(s):  
Johannes K. S. Dillinger ◽  
Yasser M. Meddaikar ◽  
Jannis Lübker ◽  
Manuel Pusch ◽  
Thiemo Kier
Keyword(s):  
Finite Element ◽  
Wind Tunnel ◽  
Wind Tunnel Test ◽  
Objective Functions ◽  
Dynamic Identification ◽  
Wind Tunnel Model ◽  
Design And Optimization ◽  
Aeroelastic Model ◽  
Tunnel Model ◽  
Gust Load Alleviation

Through the combination of passive and active load alleviation techniques, this paper presents the design, optimization, manufacturing, and update of a flexible composite wind tunnel model. In a first step, starting from the specification of an adequate wing and trailing edge flap geometry, passive, static aeroelastic stiffness optimizations for various objective functions have been performed. The second optimization step comprised a discretization of the continuous stiffness distributions, resulting in manufacturable stacking sequences. In order to determine which of the objective functions investigated in the passive structural optimization most efficiently complemented the projected active control schemes, the condensed modal finite element models were integrated in an aeroelastic model, involving a dedicated gust load alleviation controller. The most promising design was selected for manufacturing. The finite element representation could be updated to conform to the measured eigenfrequencies, based on the dynamic identification of the model. Eventually, a wind tunnel test campaign was conducted in November 2018 and results have been examined in separate reports.

Study on Static Wind Loading Coefficients of Suspension Bridge Based on CFD Simulation and Wind Tunnel Test

2011 ◽  
Vol 66-68 ◽  
pp. 334-339
Author(s):  
Mei Yu ◽  
Hai Li Liao ◽  
Ming Shui Li ◽  
Cun Ming Ma ◽  
Nan Luo ◽  
...  
Keyword(s):  
Wind Tunnel ◽  
Cfd Simulation ◽  
Wind Tunnel Test ◽  
Suspension Bridge ◽  
Wind Load ◽  
Dynamics Simulation ◽  
Wind Loading ◽  
Suspension Bridges ◽  
Long Span ◽  
Section Model

Long-span suspension bridges, due to their flexibility and lightness, are much prone to the wind loads, aerodynamics performance has become an important aspect of the design of long-span suspension bridges. In this study, the static wind load acting on the suspension bridge during erection has been investigated through wind tunnel test and numerical analysis. The wind tunnel test was performed using a 1:50 scale section model of the bridge, the static wind load acting on the section model was measured with varying attack angles. Numerical method used here was computational fluid dynamics simulation, a two-dimensional model is adopted in the first stage of the analysis, then the SIMPLE algorithm was employed to solve the governing equations. The analytical results were compared with the wind tunnel test data, it was shown from the study that the results of CFD simulation was good agreement with that of the wind tunnel test.

Sign in / Sign up

Export Citation Format

Share Document