scholarly journals Seismic noise analysis of broadband stations in the Eastern Ghat Mobile Belt of India using power spectral density

2017 ◽  
Vol 8 (2) ◽  
pp. 1622-1630 ◽  
Author(s):  
Niptika Jana ◽  
Chandrani Singh ◽  
Rahul Biswas ◽  
Nitin Grewal ◽  
Arun Singh
2020 ◽  
Author(s):  
Maria Catania ◽  
Antonino D'Alessandro ◽  
Luca Greco ◽  
Raffaele Martorana ◽  
Salvatore Scudero

<p>The Italian Seismic Network (IV) consists of more than 500 stations located throughout the Italian territory.</p><p>The detection capability of  network is constrained by its location performance that is affected by the seismic noise levels variations depending on the characteristics of the dominant source. Discriminating the noise level in each stations may allow to improve in its performance, in order to reduce noisy stations to detect even the smaller energetic seismic events sometimes hidden by high noise values. The main goal of this research has been to establish the characteristics (frequency content) and origin of seismic noise background at these sites and secondly to assess the effects of performance of the network.</p><p>For this purpose we have estimated the Power Spectral Density (PSD) of seismic noise selecting only a subset of 233 stations equiped with broadband velocimeters (with minimum period of 40 seconds and with a high sensitivity until to 120s) and operating at least three consecutive years of available data (2015-2017).</p><p>The variations of seismic background noise have been investigated using also the relative Probability Density Funcionts (PDF). The data processing of signals carried out with the robust method proposed by McNamara and Buland, (2004). In this study, the analysis was limited in the frequency band from 0.025 to 30 Hz, in accordance with the seismic sensors bandwidth. Four different frequency bands have been identified: 0.025-0.12, 0.12-1.2, 1.2-10 and 10-30 Hz. Each of these has been associated to a main type of source, in agreement with the literature.</p><p>A preliminary data analysis has been carried out to understand the statistical properties of the noise power, in the four class identified, both in space and frequency domains. Extracting  the PDFs  all stations, it was produced a representative seismic noise model that it could be considered as a new reference noise for Italian territory. Histograms have been computed for each band, both for vertical and horizontal components and its ratio. In addition, a spatial-statistical analysis was performed showing a good correlation of noise level with some weather conditions and anthropogenic source. Several clustering techniques were applied to the data to identified group of stations with similar PSD level, attributable to the same noise source. Furthermore, a correlation between the noise found at the different stations and spatial data (maps of rainfall, winds, coastlines, ect…) was carried out for a better characterization of the type of source.</p>


2021 ◽  
Vol 247 ◽  
pp. 09009
Author(s):  
Atsushi Sakon ◽  
Kunihiro Nakajima ◽  
Kazuki Takahashi ◽  
Shin-ya Hohara ◽  
Tadafumi Sano ◽  
...  

In graphite-reflected thermal reactors, even a detector placed far from fuel region may detect a certain degree of the correlation amplitude. This is because mean free path of neutrons in graphite is longer than that in water or polyethylene. The objective of this study is experimentally to confirm a high flexibility of neutron detector placement in graphite reflector for reactor noise analysis. The present reactor noise analysis was carried out in a graphite-moderated and -reflected thermal core in Kyoto University Critical Assembly (KUCA). BF3 proportional neutron counters (1” dia.) were placed in graphite reflector region, where the counters were separated by about 35cm and 30cm -thick graphite from the core, respectively. At a critical state and subcritical states, time-sequence signal data from these counters were acquired and analyzed by a fast Fourier transform (FFT) analyzer, to obtain power spectral density in frequency domain. The auto-power spectral density obtained from the counters far from the core contained a significant degree of correlated component. A least-squares fit of a familiar formula to the auto-power spectral density data was made to determine the prompt-neutron decay constant. The decay constant was 63.3±14.5 [1/s] in critical state. The decay constant determined from the cross-power spectral density and coherence function data between the two counters also had a consistent value. It is confirmed that reactor noise analysis is possible using a detector placed at about 35cm far from the core, as we expected.


Geophysics ◽  
1969 ◽  
Vol 34 (6) ◽  
pp. 988-988
Author(s):  
Robert L. Sax ◽  
Paul R. Lintz

Our comments (Geophysics, October, 1969, p. 793) on the paper of Lacoss et al were not concerned with possible semantic misinterpretation (see authors’ response in same issue) on our part of the authors’ usage of the term ‘phase velocity,’ but with whether or not the formulas given by the authors are correct. The authors explicitly state (p. 21) that [Formula: see text] is the “frequency‐wavenumber power spectral density,” so that [Formula: see text], and [Formula: see text] are components of wavenumber; on page 22, line 3, [Formula: see text] and [Formula: see text] are explicitly described as “phase velocity components.” Then equations (3) and (5) as given by the authors are simply incorrect: Correct equation reads: Equation (3) [Formula: see text] Equation (5) [Formula: see text] Lacoss et al have [Formula: see text].


2009 ◽  
Vol 2 (1) ◽  
pp. 40-47
Author(s):  
Montasser Tahat ◽  
Hussien Al-Wedyan ◽  
Kudret Demirli ◽  
Saad Mutasher

Sign in / Sign up

Export Citation Format

Share Document