Dwell time, Hartman effect and transport properties in a ferromagnetic phosphorene monolayer

The effects of conversion parameters on transport properties of YBa2Cu3O7-δ (YBCO) films on rolling assisted biaxially textured substrates (RABiTS) in the BaF2 ex situ process were investigated for total pressures Ptotal between 0.1 and 1.3 atm, water vapor pressures PH2O between approximately 7 and 70 Torr and processing temperatures TS between 700 and 790 °C. For this study, a 0.3-μm-thick Y–BaF2–Cu–O precursor film was deposited on a 1-cm-wide Ni=3 at.% W RABiTS with a buffer layer architecture of CeO2/YSZ/Y2O3/Ni deposited in single passes in various reel-to-reel systems for each layer. Under the conditions of Ptotal = 0.1 atm, TS = 740 °C and PO2 approximately 150 mTorr, JC > 2 MA/cm2 was obtained at 77 K and self field for PH2O ≤ 20 Torr. At higher PH2O (=70 Torr), however, the maximum attainable JC decreased. In addition, the JC at these higher PH2O dropped rapidly with increased dwell time. The highest JC, 2.5 MA/cm2, was achieved at 730 °C with Ptotal = 0.1 atm and PH2O approximately 7 Torr. Finally, the variation of IC with wet conversion time was performed at each processing temperature.

Download Full-text

Spectroscopic Diagnostics of Tokamaks

International Astronomical Union Colloquium ◽

10.1017/s0252921100107638 ◽

1988 ◽

Vol 102 ◽

pp. 165-174

Author(s):

C. de Michelis

Keyword(s):

Transport Properties ◽

Power Losses ◽

Spectroscopic Diagnostics ◽

Important Concern

AbstractImpurities being an important concern in tokamaks, spectroscopy plays a key role in their understanding. Techniques for the evaluation of concentrations, power losses and transport properties are surveyed, and a few developments are outlined.

Download Full-text

Structure and Orientation of As Precipitates in LT-MBE Grown GaAs

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100088816 ◽

1991 ◽

Vol 49 ◽

pp. 900-901 ◽

Cited By ~ 1

Author(s):

Alain Claverie ◽

Zuzanna Liliental-Weber

Keyword(s):

Transport Properties ◽

Layer Thickness ◽

Growth Temperature ◽

Low Temperatures ◽

Lattice Parameter ◽

Crystalline Quality ◽

Insulating Properties ◽

Lt Gaas

GaAs layers grown by MBE at low temperatures (in the 200°C range, LT-GaAs) have been reported to have very interesting electronic and transport properties. Previous studies have shown that, before annealing, the crystalline quality of the layers is related to the growth temperature. Lowering the temperature or increasing the layer thickness generally results in some columnar polycrystalline growth. For the best “temperature-thickness” combinations, the layers may be very As rich (up to 1.25%) resulting in an up to 0.15% increase of the lattice parameter, consistent with the excess As. Only after annealing are the technologically important semi-insulating properties of these layers observed. When annealed in As atmosphere at about 600°C a decrease of the lattice parameter to the substrate value is observed. TEM studies show formation of precipitates which are supposed to be As related since the average As concentration remains almost unchanged upon annealing.

Download Full-text