scholarly journals The Impacts of Warning Release Time and Speed Limit on Driving Behaviour and Pedestrian-Vehicle Collision Rate on Side-parking Road

2021 ◽  
Vol 638 (1) ◽  
pp. 012034
Author(s):  
Yiming Miao ◽  
Xuedong Yan
Author(s):  
Curt B. Haselton ◽  
A. Reed Gibby ◽  
Thomas C. Ferrara

Three methodologies are used and compared to determine whether there has been a statistically significant change in traffic collisions (total, fatal, fatal plus injury, wet pavement, and nighttime) due to recent speed limit increases on California state highways. The three methods compared were simple regression, analysis of variance (ANOVA), and an observational before–after study developed by Ezra Hauer. Both collision counts and rates were studied for early 1996 speed limit increases from 55 to 65 mph, and from 65 to 70 mph. A comparison group of highways that remained at 55 mph was also studied. The simple regression methodology did not detect nearly as many statistically significant increases as did the ANOVA and Hauer observational before–after methodologies. The latter two methods revealed very similar results, especially for statistically significant increases in total and fatal collision rates and counts. These methodologies also revealed a significant increase in nighttime collisions for the 55–65 mph group. The difference was that the observational method detected only a marginally significant increase with total collisions for the 65–70 mph group. Also, the ANOVA indicated that the fatality collision rate increase for the 65–70 mph group was marginally significant.


2015 ◽  
Vol 56 (11) ◽  
pp. 6326 ◽  
Author(s):  
Bradley E. Dougherty ◽  
Roanne E. Flom ◽  
Mark A. Bullimore ◽  
Thomas W. Raasch

2007 ◽  
Vol 12 (3) ◽  
pp. 4-7
Author(s):  
Charles N. Brooks ◽  
Christopher R. Brigham

Abstract Multiple factors determine the likelihood, type, and severity of bodily injury following a motor vehicle collision and, in turn, influence the need for treatment, extent of disability, and likelihood of permanent impairment. Among the most important factors is the change in velocity due to an impact (Δv). Other factors include the individual's strength and elasticity, body position at the time of impact, awareness of the impending impact (ie, opportunity to brace, guard, or contract muscles before an impact), and effects of braking. Because Δv is the area under the acceleration vs time curve, it combines force and duration and is a useful way to quantify impact severity. The article includes a table showing the results of a literature review that concluded, “the consensus of human subject research conducted to date is that a single exposure to a rear-end impact with a Δv of 5 mph or less is unlikely to result in injury” in most healthy, restrained occupants. Because velocity incorporates direction as well as speed, a vehicular occupant is less likely to be injured in a rear impact than when struck from the side. Evaluators must consider multiple factors, including the occupant's pre-existing physical and psychosocial status, the mechanism and magnitude of the collision, and a variety of biomechanical variables. Recommendations based solely on patient history and physical findings (and, perhaps, imaging studies) may be ill-informed.


In this study, once-daily porosity osmotic pump tablets (POPTs) of Glimepiride were prepared using HPMC K100M (61%), osmotic agent (30% NaCl) coated using two different coating techniques spraying and dipping methods. The coating solution composed of ethyl cellulose (7.5%) w\w in ethanol (90%), castor oil (2%) as water-insoluble plasticizer and Gingo red color (0.5% w\w). In both techniques, the coating level was adjusted to give a 10% increase in the weight of the tablets. The effect of the coating by dipping technique with an increase in the weight of tablet (10 %, 20% & 50%) was also investigated to see the effect coating level on the percentage of drug release from POPTs. The results of the in vitro release of Glimepiride from tablets coated by the spraying method showed longer release time (24 hrs) than those coated with dipping method. On the other hand, increasing the coating level by dipping method retarded the release of the drug from tablets. However, the same retardation effect on release as shown with the spraying technique was only obtained by increasing the coating level with a 50% increase in the weight of the tablet. Thus, coating by spraying is more efficient to prepare POPTs to give a continuous release of Glimepiride from once daily table with the lowest increase in the total weight of the tablet.


Sign in / Sign up

Export Citation Format

Share Document