Role of ultrasonic shot peening on microstructure, hardness and corrosion resistance of nitrogen stabilised stainless steel without nickel

A 3D finite element model is established to simulate the ultrasonic shot peening process by using a finite element software ABAQUS. The residual stress distribution of the AISI 304 stainless steel induced by ultrasonic shot peening (USP) is predicted by finite element analysis. Ultrasonic shot peening (USP) process can cause a compressive residual stress layer on the surface of the material. During the simulation, many factors, e.g., ultrasonic shot peening duration, initial residual stress, hourglass, etc., are taken into consideration for the purpose of optimizing the process. The simulation results show that ultrasonic shot peening can produce a compressive residual stress layer on the surface of the material even if there is initial residual tensile stress (250MPa) and the longer peening duration. The residual stress of simulation were compared with the experiment data which were obtained under the same ultrasonic shot peening parameters and have a good agreement with the measurement values by X-ray diffraction method. In conclusion, ultrasonic shot peening is an effective method for protecting weldments against stress corrosion cracking by introducing the compressive residual stress layer into the surface of stainless steel.

Download Full-text

Effect of shot peening on the surface properties, corrosion and wear performance of 17-4PH steel produced by DMLS additive manufacturing

Archives of Civil and Mechanical Engineering ◽

10.1007/s43452-021-00306-3 ◽

2021 ◽

Vol 21 (4) ◽

Author(s):

Mariusz Walczak ◽

Mirosław Szala

Keyword(s):

Stainless Steel ◽

Wear Resistance ◽

Corrosion Resistance ◽

Additive Manufacturing ◽

Surface Properties ◽

Shot Peening ◽

Surface Defects ◽

Wear Behaviour ◽

Fatigue Wear ◽

Steel Shot

AbstractComponents produced by additive manufacturing (AM) via direct metal laser sintering (DMLS) have typical as-fabricated surface defects. As a result, surface properties of AM products should be modified to increase their strength, anti-wear behaviour, and at the same time to ensure their high corrosion resistance. Surface modification via shot peening is considered suitable for additive manufacturing of medical devices made of 17-4PH stainless steel. The objective of this study was to determine the effect of shot peening pressures (0.3 MPa and 0.6 MPa) and three types of blasting media (CrNi steel shot, nutshell granules and ceramic beads) on the tribological characteristics and corrosion resistance of specimens of DMLS 17-4PH stainless steel. Results demonstrated that shot peening caused steel microstructure refinement and—except for the nutshell shot-peened specimens—induced both martensite (α) formation and retained austenite (γ) reduction. 17-4PH specimens peened with steel and ceramic shots showed the highest increase in surface hardening by approx. ~ 119% (from 247 to 542 HV), which significantly improved their wear resistance. The highest mechanical properties (hardness and wear resistance) and corrosion resistance were obtained for the surfaces modified using the following media: ceramic beads > CrNi steel shot > nutshell granules. Adhesive and fatigue wear were two predominant mechanisms of tribological deterioration. Results demonstrated that the application of shot peening using ceramic beads led to grain size refinement from 22.0 to 14.6 nm and surface roughness reduction, which in turn resulted in higher corrosion resistance of the material. DMLS 17-4PH specimens modified by shot peening using ceramic beads and a pressure of 0.6 MPa exhibited the optimum surface morphology, hardness and microstructure, and thus improved wear and corrosion performance.

Download Full-text