scholarly journals Accuracy of VMS data from Norwegian demersal stern trawlers for estimating trawled areas in the Barents Sea

2011 ◽  
Vol 68 (8) ◽  
pp. 1615-1620 ◽  
Author(s):  
K. L. Skaar ◽  
T. Jørgensen ◽  
B. K. H. Ulvestad ◽  
A. Engås
Keyword(s):  
Large Scale ◽  
Barents Sea ◽  
Linear Interpolation ◽  
Fishing Effort ◽  
Small Scale ◽  
Fishing Activity ◽  
Trawl Fishery ◽  
The Barents Sea ◽  
Global Positioning ◽  
Gps Trajectories

Abstract Skaar, K. L., Jørgensen, T., Ulvestad, B. K. H., and Engås, A. 2011. Accuracy of VMS data from Norwegian demersal stern trawlers for estimating trawled areas in the Barents Sea. – ICES Journal of Marine Science, 68: 1615–1620. The accuracy of vessel monitoring system (VMS) data, used to determine fishing activity in the trawl fishery for gadoids in the Barents Sea, was studied by observer notes and Global Positioning System (GPS) data from two Norwegian vessels in October 2007. A speed rule of 2–5 knots correctly classified 75–80% of the fishing activity and 85–90% of the non-fishing activity. Linear interpolation between hourly VMS recordings underestimated trawl trajectories by 15%. The median haulwise difference between the VMS and the GPS trajectories was ∼500 m. The interpolated VMS data are appropriate for mapping the large-scale distribution of fishing effort and the area impacted, but to link fishing activities with small-scale mapping of benthos, more-frequent VMS-update times and more-refined interpolation techniques are required.

Analysis of tidal sea-ice movement using a drifting ice beacon array in the Barents Sea

2020 ◽  
Author(s):  
Amey Vasulkar ◽  
Lars Kaleschke ◽  
Martin Verlaan ◽  
Cornelis Slobbe
Keyword(s):  
Sea Ice ◽  
Barents Sea ◽  
Global Ocean ◽  
Series Data ◽  
Small Scale ◽  
Ice Thickness ◽  
Drag Coefficients ◽  
The Barents Sea ◽  
Ice Drift ◽  
Drifting Ice

<p>In an experiment to validate an ice forecast and route optimization system, an array of 15 ice drift beacons/buoys were deployed between Edgeøya and Kong Karls Land in the east of Svalbard to measure the sea ice movement. These beacons recorded data at a sampling frequency of 15 minutes in the duration from March 2014 to May 2014 with different start and end dates based on their life. The particularly short time step captures the small scale effect of tides on the drifting ice. In this region of the Barents Sea, the frequency of the inertial motion is very close to the M2 tidal frequency. Hence, it is not possible to extract the tidal motion from the time series data of the buoys by using a Fourier analysis. It is also likely that these effects will interact. Instead, we develop a physics-based <em>free drift</em> ice model that can simulate the drift at all tidal and other frequencies.</p><p>The model is forced by winds obtained from the ERA5 Reanalysis dataset of ECMWF and ocean currents obtained from the Global Ocean Analysis product of CMEMS. Due to the effect of tides, the model is also forced by the tides obtained from the Global Tide and Surge Model (GTSM v3.0) which is built upon Delft3D-FM unstructured mesh code. This free drift model is validated against 8 of the 15 beacon trajectories. The model along with the observed data can be then be used to obtain insights on the relationship between the sea ice velocities and the tides. This will be particularly useful to obtain the effect of ice drift on tides in tidal models.</p><p>The model uncertainty is mainly due to oceanic and atmospheric drag coefficients, C<sub>dw</sub> and C<sub>da</sub>, respectively, and the sea ice thickness, h<sub>i</sub>. This study also focuses on optimizing the ratio of drag coefficients (C<sub>dw</sub>/C<sub>da</sub>) for the different beacon trajectories while varying the ice thickness between 0.1 m - 1.5 m and the ice-air drag coefficient between (0.5-2.5)x10<sup>-3</sup>. This ratio facilitates the evaluation of the frictional drag between the ice-water interface and thus, helps in determining the effect of ice on tides in tidal models.</p>

scholarly journals Bycatch reduction in the deep-water shrimp (Pandalus borealis) trawl fishery by increasing codend mesh openness

2021 ◽  
Author(s):  
Nadine Jacques ◽  
Hermann Pettersen ◽  
Kristine Cerbule ◽  
Bent Herrmann ◽  
Ólafur A. Ingólfsson ◽  
...  
Keyword(s):  
Deep Water ◽  
Barents Sea ◽  
Juvenile Fish ◽  
Size Selectivity ◽  
Pandalus Borealis ◽  
Trawl Fishery ◽  
Bycatch Reduction ◽  
Drag Forces ◽  
The Barents Sea ◽  
Trawl Fisheries

In most trawl fisheries, drag forces tend to close the meshes in large areas of diamond mesh codends, negatively affecting their selective potential. In the Barents Sea deep-water shrimp (Pandalus borealis) trawl fishery, selectivity is based on a sorting grid followed by a diamond mesh codend. However, the retention of juvenile fish as well as undersized shrimp is still a problem. In this study, we estimated the effect of applying different codend modifications, each aimed at affecting codend mesh openness and thereby selectivity. Changing from a 4-panel to a 2-panel construction of the codend did not affect size selectivity. Shortening the lastridge ropes of a 4-panel codend by 20% resulted in minor reductions for juvenile fish bycatch, but a 45% reduction of undersized shrimp was observed. Target-size catches of shrimp were nearly unaffected. When the codend mesh circumference was reduced while simultaneously shortening the lastridge ropes, the effect on catch efficiency for shrimp or juvenile fish bycatch was marginal compared to a 4-panel codend design with shortened lastridge ropes.

scholarly journals Effect of gear design on catch damage on cod (Gadus morhua) in the Barents Sea demersal trawl fishery

Food Control ◽  
2021 ◽  
Vol 120 ◽  
pp. 107562 ◽  
Author(s):  
Jesse Brinkhof ◽  
Bent Herrmann ◽  
Manu Sistiaga ◽  
Roger B. Larsen ◽  
Nadine Jacques ◽  
...  
Keyword(s):  
Gadus Morhua ◽  
Barents Sea ◽  
Trawl Fishery ◽  
Gear Design ◽  
The Barents Sea

scholarly journals Effect of a quality-improving cod end on size selectivity and catch patterns of cod in bottom trawl fishery

2019 ◽  
Vol 76 (11) ◽  
pp. 2110-2120 ◽  
Author(s):  
Jesse Brinkhof ◽  
Bent Herrmann ◽  
Roger B. Larsen ◽  
Tiago Veiga-Malta
Keyword(s):  
Gadus Morhua ◽  
Barents Sea ◽  
Relative Size ◽  
Bottom Trawl ◽  
Size Selectivity ◽  
Total Size ◽  
Trawl Fishery ◽  
The Barents Sea ◽  
Sea Bottom ◽  
Significant Difference

A new cod-end concept developed and tested exhibited significantly improved quality of caught cod (Gadus morhua) compared with that of the conventional cod end used in the Barents Sea bottom trawl fishery. However, the design of the new quality-improving cod end raised concerns about its size selectivity and the possibility that higher retention probability could negatively impact the catch pattern by increasing the proportion of undersized cod. Therefore, the goal of this study was to quantify and compare the size selectivity and catch pattern for cod when deploying, respectively, the conventional and new quality-improving cod end in the Barents Sea bottom trawl fishery. The new quality-improving cod end had significantly lower relative size selectivity than the conventional cod end, but no significant difference in the catch patterns was detected in the trawl. Further, estimation of the total size selectivity in the trawl revealed that the increased retention of small cod when using the quality-improving cod end was minor. Hence, despite the reduced selectivity, the quality-improving cod end can be used with low risk of retaining small cod.

scholarly journals Effect of three different codend designs on the size selectivity of juvenile cod in the Barents Sea shrimp trawl fishery

2019 ◽  
Vol 219 ◽  
pp. 105337
Author(s):  
Bent Herrmann ◽  
Manu Sistiaga ◽  
Roger B. Larsen ◽  
Jesse Brinkhof
Keyword(s):  
Barents Sea ◽  
Size Selectivity ◽  
Trawl Fishery ◽  
The Barents Sea ◽  
Shrimp Trawl

scholarly journals Effect of temporal and spatial resolution on identification of fishing activities in small-scale fisheries using pots and traps

2019 ◽  
Vol 76 (6) ◽  
pp. 1601-1609 ◽  
Author(s):  
Tania Mendo ◽  
Sophie Smout ◽  
Tommaso Russo ◽  
Lorenzo D’Andrea ◽  
Mark James
Keyword(s):  
Spatial Distribution ◽  
Spatial Resolution ◽  
Large Scale ◽  
Low Cost ◽  
Grid Cell ◽  
Analysis Data ◽  
Satellite System ◽  
Small Scale ◽  
Fishing Activity ◽  
Small Scale Fisheries

Abstract Analysis of data from vessel monitoring systems and automated identification systems in large-scale fisheries is used to describe the spatial distribution of effort, impact on habitats, and location of fishing grounds. To identify when and where fishing activities occur, analysis needs to take account of different fishing practices in different fleets. Small-scale fisheries (SSFs) vessels have generally been exempted from positional reporting requirements, but recent developments of compact low-cost systems offer the potential to monitor them effectively. To characterize the spatial distribution of fishing activities in SSFs, positions should be collected with sufficient frequency to allow detection of different fishing behaviours, while minimizing demands for data transmission, storage, and analysis. This study sought to suggest optimal rates of data collection to characterize fishing activities at appropriate spatial resolution. In a SSF case study, on-board observers collected Global Navigation Satellite System (GNSS) position and fishing activity every second during each trip. In analysis, data were re-sampled to lower temporal resolutions to evaluate the effect on the identification of number of hauls and area fished. The effect of estimation at different spatial resolutions was also explored. Consistent results were found for polling intervals <60 s in small vessels and <120 in medium and large vessels. Grid cell size of 100 × 100 m resulted in best estimations of area fished. Remote collection and analysis of GNSS or equivalent data at low cost and sufficient resolution to infer small-scale fisheries activities. This has significant implications globally for sustainable management of these fisheries, many of which are currently unregulated.

scholarly journals Fisheries change spawning ground distribution of northeast Arctic cod

2009 ◽  
Vol 6 (2) ◽  
pp. 261-264 ◽  
Author(s):  
Anders Frugård Opdal
Keyword(s):  
Barents Sea ◽  
Size Structure ◽  
Sudden Increase ◽  
Spawning Grounds ◽  
Norwegian Coast ◽  
Trawl Fishery ◽  
Climatic Variations ◽  
The Barents Sea ◽  
Spawning Stock

Prior to the 1920s, the northeast Arctic (NA) cod were caught at spawning grounds ranging from the southernmost to the northernmost parts of the Norwegian coast, but have for the last 50 yr mainly been caught around the Lofoten archipelago and northwards. The NA cod have their feeding and nursery grounds in the Barents Sea, and migrate south towards the Norwegian coast in the winter to spawn. This study uses commercial fisheries' data from landing ports along the entire Norwegian coast during the period 1866–1969 as evidence of long-term truncation and northerly shift of spawning grounds. Nearly all spawning grounds south of Lofoten have been abandoned, while an increasing proportion of the spawning stock only uses the northernmost areas of the Norwegian coast, Troms and Finnmark. The truncation can hardly be attributed to long-term climatic variations, but may result from an intensive size-selective trawl fishery in the Barents Sea causing a sudden increase in fishing mortality, probably altering the size structure and migratory capacity of the stock.

Sign in / Sign up

Export Citation Format

Share Document