scholarly journals White pine weevil (Pissodes strobi) biological performance is unaffected by the jasmonic acid or wound-induced defense response in Norway spruce (Picea abies)

2006 ◽  
Vol 26 (11) ◽  
pp. 1377-1389 ◽  
Author(s):  
M.-C. Nicole ◽  
G. Zeneli ◽  
R. Lavallee ◽  
D. Rioux ◽  
E Bauce ◽  
...  
2006 ◽  
Vol 82 (4) ◽  
pp. 538-549 ◽  
Author(s):  
Gaëtan Daoust ◽  
Marie-Josée Mottet

A study to assess the effects that major deformations in merchantable stems of Norway spruce (Picea abies [L.] Karst.), caused by the white pine weevil (Pissodes strobi [Peck]), have on lumber productivity and quality was performed on logs obtained from the second commercial thinning operation in three weevil-affected plantations. Deformed stems were found to be 6.3% shorter than undeformed stems and their lumber characteristics — merchantable volume, number of board feet and lumber monetary value — were 14.7%, 20.6% and 23.7% lower, respectively. However, when the respective proportions of deformed and undeformed stems were analyzed for a given plantation over a time horizon of a complete rotation, these shortfalls almost disappeared, with a loss of less than 3% being noted for total merchantable volume. The presence/absence of major deformations had no effect on visual grading of the lumber, which considers defects such as wane, knots and compression wood. For two of the three sites studied, almost 75% of the lumber was graded as Select Structural, No. 1 or No. 2. The plantation site and its characteristics (spacing and level of thinning) were found to have a more significant effect than deformations on productivity, lumber quality and monetary value. Furthermore, using the same methodology, one of the Norway spruce sites was compared with a white spruce (Picea glauca [Moench] Voss) plantation containing trees of similar quality and height but no weevil problems. The Norway spruce stems, including those with deformations, were found to yield higher merchantable and usable log volumes, a larger number of board feet and a higher monetary value than the white spruce. On average, for the diameter-at-breast-height values tested — 14 to 23 cm — the monetary value of the lumber was 26% higher for Norway spruce. These findings are largely attributable to the less pronounced taper of Norway spruce. In conclusion, in spite of weevil attacks and its negative impact, Norway spruce trees growing on sites of moderate to very good quality maintain lumber potential, in terms of both quantity and quality for second thinning logs. The negative impact should gradually diminish at the time of next thinnings and final harvest. Key words: white pine weevil, Pissodes strobi (Peck), Norway spruce, Picea abies (L.) Karst., wood quality, plantation, productivity


2006 ◽  
Vol 82 (5) ◽  
pp. 745-756 ◽  
Author(s):  
Gaëtan Daoust ◽  
Marie-Josée Mottet

A study to assess the effects that major deformations in merchantable stems of Norway spruce (Picea abies [L.] Karst.), caused by the white pine weevil (Pissodes strobi [Peck]), have on lumber productivity and quality was performed on logs obtained from a second commercial thinning operation in three weevil-affected plantations. Deformed stems were found to be 6.3% shorter than non-deformed stems and their lumber characteristics, i.e., merchantable volume, number of board feet and lumber monetary value, were 14.7%, 20.6% and 23.7% lower, respectively. However, when the respective proportions of deformed and non-deformed stems were analyzed for a given plantation over the time horizon of a complete rotation, these shortfalls almost disappeared, with a loss of less than 3% being noted for total merchantable volume. The presence/absence of major deformations had no effect on visual grading of the lumber, which takes defects such as wane, knots and compression wood into account. For two of the three sites studied, almost 75% of the lumber was graded as Select Structural, No. 1 or No. 2. The plantation site and its characteristics (spacing and level of thinning) were found to have a more significant effect than deformations on productivity, lumber quality and monetary value. Furthermore, using the same methodology, one of the Norway spruce sites was compared with a white spruce (Picea glauca [Moench] Voss) plantation containing trees of similar quality and height, but with no weevil problems. The Norway spruce stems, including those with deformations, were found to yield higher merchantable and usable log volumes, a larger number of board feet and a higher monetary value than white spruce. On average, for the diameter at breast height values tested — 14 to 23 cm — the monetary value of the lumber was 26% higher for Norway spruce. These findings are largely attributable to the less pronounced taper of Norway spruce. In conclusion, in spite of weevil attacks and their negative impact, Norway spruce trees growing on sites of moderate to very good quality maintain lumber potential, in terms of both quantity and quality, for second thinning logs. The negative impact should gradually decrease at the time of next thinnings and final harvest. Key words: white pine weevil, Pissodes strobi (Peck), Norway spruce, Picea abies (L.) Karst., wood quality, plantation, productivity


2006 ◽  
Vol 82 (5) ◽  
pp. 712-722
Author(s):  
Marie-Josée Mottet ◽  
Gaëtan Daoust ◽  
S Y Zhang

We studied the lumber characteristics of 148 trees taken for that purpose during commercial thinning operations in three Norway spruce (Picea abies [L.] Karst.) plantations, aged from 32 to 34 years, which had been attacked by the white pine weevil (Pissodes strobi [Peck]). The trees, with diameters ranging from 14 to 23 cm, were grouped into three quality classes according to the number of major deformations caused by the weevil. The effects of the deformations on rigidity, bending strength, wood density and lumber defects were examined. Results show that in general the deformations caused by the weevil do not affect the lumber properties of Norway spruce on sites of medium- to high-quality. For the three Norway spruce plantations, the mean values of the modulus of elasticity (MOE) of the lumber vary from 8510 to 9357 MPa, and for the modulus of rupture (MOR) range from 36.0 to 42.5 MPa, whereas wood density varies from 324 to 343 kg·m-3. For comparison purposes, the same measurements were taken on lumber from 38 trees in a white spruce (P. glauca [Moench] Voss) plantation that was unaffected by the weevil, but otherwise comparable to the Norway spruce plantation on one of the sites studied. The lumber properties from the Norway spruce taken from deformed or undeformed stems are 34% superior to the white spruce for the MOE, 20% for the MOR and 8% for wood density. The smaller knots in the Norway spruce could explain this difference. On the other hand, a visual classification of this type of wood reveals few differences in the lumber's bending strength or rigidity. Key words: Norway spruce, Picea abies, wood characteristics, MOE, MOR, wood density, lumber, white pine weevil, Pissodes strobi, white spruce, Picea glauca


2006 ◽  
Vol 82 (6) ◽  
pp. 834-843 ◽  
Author(s):  
Marie-Josée Mottet ◽  
Gaëtan Daoust ◽  
S Y Zhang

We studied the lumber characteristics of 148 trees acquired for that purpose during commercial thinning operations in three Norway spruce (Picea abies [L.] Karst.) plantations, aged from 32 to 34 years, which had been attacked repeatedly by the white pine weevil (Pissodes strobi [Peck]). The trees, with diameters ranging from 14 to 23 cm, were grouped into three quality classes according to the number of major deformations caused by the weevil. The effects of the deformations on bending strength and stiffness, wood density and lumber defects were examined. Results show that in general deformations caused by the weevil do not affect the lumber properties of Norway spruce on sites of medium to high quality. For the three Norway spruce plantations, the mean values of the modulus of elasticity (MOE) of the lumber varied between 8510 and 9357 MPa, and for the modulus of rupture (MOR) they ranged from 36.0 to 42.5 MPa, whereas wood density varied from 324 and 343 kg·m-3. For comparison purposes, the same measurements were taken on lumber from 38 trees in a white spruce (P. glauca [Moench] Voss) plantation that was unaffected by the weevil, but comparable to the Norway spruce plantation on one of the sites studied. The lumber properties from Norway spruce taken from deformed or undeformed stems were 34% superior to white spruce for MOE, 20% for MOR and 8% for wood density. The smaller knots in Norway spruce could explain this difference. On the other hand, a visual grading of this type of wood reveals few differences in lumber strength and stiffness. Key words: Norway spruce, Picea abies, wood characteristics, MOE, MOR, wood density, lumber, white pine weevil, Pissodes strobi, white spruce, Picea glauca


2010 ◽  
Vol 86 (6) ◽  
pp. 775-779 ◽  
Author(s):  
Alice Verrez ◽  
Dan Quiring ◽  
Thibaut Leinekugel Le Cocq ◽  
Greg Adams ◽  
Yill Sung Park

White pine weevil (Pissodes strobi Peck) damage was evaluated in one white pine (Pinus strobus L.) and four jack pine(Pinus banksiana Lamb) half-sib family test sites to determine the role of tree genotype in resistance to the weevil. Halfsibfamily explained a significant proportion of the variation in weevil attack at all sites. Estimates of family (0.16-0.54)and individual (0.09-0.24) heritabilities of jack pine resistance to white pine weevil were moderate. Estimates of family(0.37) and individual (0.22) heritability of resistance of white pine to the weevil were also moderate when the percentageof test trees damaged by the weevil was relatively low, but were insignificant four years later when more than three-quartersof trees were damaged. Significant positive correlations between mean tree height and mean incidence of trees damagedby the weevil were observed for four of seven site-years but relationships were weak, suggesting that any cost, withrespect to height growth, to breeding weevil resistant trees may be small.Key words: Pinus, Pissodes strobi, trade-offs, tree improvement, tree resistance, white pine weevil.


1982 ◽  
Vol 11 (3) ◽  
pp. 555-564 ◽  
Author(s):  
Wayne N. Dixon ◽  
Mark W. Houseweart

1996 ◽  
Vol 74 (4) ◽  
pp. 599-606 ◽  
Author(s):  
Elizabeth S. Tomlin ◽  
John H. Borden ◽  
Harold D. Pierce Jr.

Cortical resin acids were analyzed both quantitatively and qualitatively among 10 provenances and 11 genotypes of Sitka spruce, Picea sitchensis Bong (Carr.), putatively resistant to the white pine weevil, Pissodes strobi (Peck), and compared with susceptible trees. Trees in 5 of the 11 resistant genotypes had significantly greater amounts of cortical resin acid than susceptible trees. Of seven individual acids analyzed, pimaric, isopimaric, levopimaric, dehydroabietic, abietic, and neoabietic acid, but not palustric acid, were found in significantly greater amounts in trees from resistant than susceptible provenances. Eighteen percent of the variation in resin acid content could be accounted for by variation in the capacity of cortical resin ducts, indicating that the other 82% of variation is a result of differences in resin acid concentration in the resin. Trees with very high resin acid levels may have a greater capacity for resinosis than susceptible trees, may deter feeding, or may produce resin that is toxic to eggs and larvae. Canonical discriminant analysis revealed that several resistant clones, particularly two from the Kitwanga provenance, could be distinguished from others on the basis of their resin acid profiles. Because it separated trees on the basis of genotype, but not according to degree of resistance, canonical discriminant analysis may be more useful in "chemotyping" trees than in screening for resistance. Keywords: Picea, cortex, resin acids, Pissodes strobi, resistance.


Sign in / Sign up

Export Citation Format

Share Document