scholarly journals Analysis of millimetre-wave polarization diverse multiple-input multiple-output capacity

2015 ◽  
Vol 2 (12) ◽  
pp. 150322 ◽  
Author(s):  
Nicholas P. Lawrence ◽  
Brian W.-H. Ng ◽  
Hedley J. Hansen ◽  
Derek Abbott

Millimetre-waves offer the possibility of wide bandwidth and consequently high data rate for wireless communications. For both uni- and dual-polarized systems, signals sent over a link may suffer severe degradation due to antenna misalignment. Orientation robustness may be enhanced by the use of mutual orthogonality in three dimensions. Multiple-input multiple-output polarization diversity offers a way of improving signal reception without the limitations associated with spatial diversity. Scattering effects often assist propagation through multipath. However, high path loss at millimetre-wave frequencies may limit any reception enhancement through scattering. We show that the inclusion of a third orthogonal dipole provides orientation robustness in this setting, as well as in a rich scattering environment, by means of a Rician fading channel model covering all orientations for a millimetre-wave, tri-orthogonal, half-wave dipole transmitter and receiver employing polarization diversity. Our simulation extends the analysis into three dimensions, fully exploiting individual sub-channel paths. In both the presence and absence of multipath effects, capacity is observed to be higher than that of a dual-polarized system over the majority of a field of view.

2017 ◽  
Vol 2017 ◽  
pp. 1-15 ◽  
Author(s):  
Yoshio Karasawa ◽  
Katsuhiro Nakada ◽  
Guijiang Sun ◽  
Rikako Kotani

We present four new developments for a multiple-input multiple-output (MIMO) over-the-air measurement system based on our previous studies. The first two developments relate to the channel model for multipath environment generation. One is a further simplification of the circuit configuration without performance degradation by reducing the number of delay generation units, which dominate the performance limit when implementing the circuit on a field-programmable gate array (FPGA). The other is to realize spatial correlation characteristics among the input ports on the transmission side, whereas the previously proposed channel model did not consider this correlation. The third development involves the details of implementing the MIMO fading emulator on an FPGA as a two-stage scheme. The fourth is the demonstration of application examples of the developed system.


2015 ◽  
Vol 58 (1) ◽  
pp. 163-166 ◽  
Author(s):  
Muhammad Saeed Khan ◽  
Antonio-Daniele Capobianco ◽  
Adnan Iftikhar ◽  
Sajid Asif ◽  
Benjamin D. Braaten

2020 ◽  
Vol 71 (3) ◽  
pp. 222-226
Author(s):  
Zouhair Al-qudah

AbstractThe Gaussian multiple-input multiple-output (MIMO) orthogonal relay channel (ORC) is investigated. The transmission from source to relay is done over a channel that is orthogonal to source-destination and relay-destination channels. Practically, this assumption is made such that many communication devices from different technologies are exploited in relaying the source’s signal into its destination. For this channel model, the capacity is initially derived. Thereafter, we propose a transmission algorithm to achieve the derived capacity. Further, to support our theoretical results, many numerical examples are presented.


Author(s):  
Muhsin Muhsin ◽  
Afina Lina Nurlaili ◽  
Aulia Saharani ◽  
Indah Rahmawti Utami

<span>Massive internet of things (IoT) in 5G has many advantages as a future technology. It brings some challenges such as a lot of devices need massive connection. In this case, multiple-input multiple-output (MIMO) systems offer high performance and capacity of communications. There is a challenge of correlation between antennas in MIMO. This paper proposes three-sectors MIMO base station antenna for 5G-New Radio (5G-NR) band N77 with dual polarized configuration to reduce the correlation. The proposed antenna has a maximum coupling of -16.90 dB and correlation below 0.01. The obtained bit error rate (BER) performance is very close to non-correlated antennas with bandwidth of 1.87 GHz. It means that the proposed antenna has been well designed.</span>


Sign in / Sign up

Export Citation Format

Share Document