Positronium in aSrF2single crystal: Temperature-induced transition from the localized to the delocalized state

2005 ◽  
Vol 71 (13) ◽  
Author(s):  
K. Inoue ◽  
N. Suzuki ◽  
T. Hyodo
2018 ◽  
pp. 155-162 ◽  
Author(s):  
Sergei S. Kapitonov ◽  
Anastasia V. Kapitonova ◽  
Sergei Yu. Grigorovich ◽  
Sergei A. Medvedev ◽  
Taher Sobhy

In the article, the electrical and thermal processes in the LED lamp with varied parameters are investigated. Voltage and current measurements on all LEDs of the luminaire are carried out in the nominal operating mode. The power allocated to each LED is determined. The calculation of the LED crystal temperature was carried out using the developed thermal LED model based on the results of the measurements and by using “Multisim” program. It has been established that the temperature of the crystals of individual LEDs in the luminaire differ significantly, which leads to unfavourable thermal conditions for them and an increased likelihood of premature failure.


Author(s):  
Seongsoo Kang ◽  
Taeyeon Kim ◽  
Yongseok Hong ◽  
Frank Würthner ◽  
Dongho Kim

1996 ◽  
Vol 82 (5) ◽  
pp. 1102-1104 ◽  
Author(s):  
M. Lou Marsh ◽  
Daniel I. Sessler

Applied laser ◽  
2011 ◽  
Vol 31 (5) ◽  
pp. 428-432
Author(s):  
吉选芒 Ji Xuanmang ◽  
姚纪欢 Yao Jihuan ◽  
刘劲松 Liu Jinsong

2014 ◽  
Vol 26 (12) ◽  
pp. 121010
Author(s):  
张爱华 Zhang Aihua ◽  
温廷敦 Wen Tingdun ◽  
许丽萍 Xu Liping ◽  
王志斌 Wang Zhibin ◽  
丰春芳 Feng Chunfang

Optik ◽  
2019 ◽  
Vol 183 ◽  
pp. 423-432 ◽  
Author(s):  
Zi-wen Dou ◽  
Jun-chao Zhu ◽  
Bao-feng Zhang ◽  
Fang-fang Han ◽  
Ya Wang

2013 ◽  
Vol 750-752 ◽  
pp. 562-565
Author(s):  
Biao Qian ◽  
Jian Jun Yang ◽  
Jie Yu ◽  
Wen Hui Ma ◽  
Bo Yu ◽  
...  

The CaO-SiO2-B2O3-Al2O3-La2O3 sealants with different alumina contents were fabricated by high-temperature melting method for intermediate temperature solid oxide fuel cell (ITSOFC). The glass transition temperature (Tg) and crystal temperature (Ts) of the sealant with different alumina content was characterized by TG-DSC. And the composition phase of the sealant was detected by XRD. The resistivity of sealant tested by electrochemical workstation was higher than 22 kΩ·cm2, which met the requirement for ITSOFC. Through the detecting of the wetting angle, the adhesion of sealant and anode materials was very good, and the single cell sealed with alumina tube successfully.


Sign in / Sign up

Export Citation Format

Share Document