A SiGe BiCMOS burst-mode transimpedance amplifier using fast and accurate automatic offset compensation technique for 1G/10G dual-rate transceiver

Author(s):  
S. Nishihara ◽  
M. Nakamura ◽  
T. Ito ◽  
T. Kurosaki ◽  
Y. Ohtomo ◽  
...  
2006 ◽  
Vol 15 (04) ◽  
pp. 467-490
Author(s):  
ANDRÉ BOYOGUÉNO ◽  
MOHAMAD SAWAN ◽  
MUSTAPHA SLAMANI

We present a new low-noise, low-power SiGe transimpedance amplifier (TIA) by combining an automatic DC photo-current cancellation, an on-chip DC offset compensation circuit and a single-ended to differential conversion scheme. The conversion method is based of the replica biasing technique in order to provide balanced output signals to the subsequent stages. The chip was fabricated in a 0.18 μm SiGe BiCMOS technology. Experimental results show excellent performances such as 11 GHz bandwidth, 75-dBΩ transimpedance, -19.2 dBm sensitivity measured at 10 Gb/s at a Bit Error Rate (BER) of 10-12, [Formula: see text] input referred noise, and 9.5 ps peak-to-peak jitter which are the best overall performances reported in its category. The photoreceiver chip is expected to dissipate only 120 mW from a single 3.3 V power supply.


Author(s):  
Urvashi Bansal ◽  
Maneesha Gupta ◽  
Niranjan Raj

The importance of a transimpedance amplifier in an optical transceiver is very well known. In this paper, a novel CMOS design of the bulk-driven transimpedance amplifier (BD-TIA) is given where the bridge-shunt peaking-based frequency compensation technique is exploited to improve frequency response. A pre-existing active inductor has been used for the same. The electrical characteristics and functioning of this inductor simulator make it a suitable alternative to both floating and grounded spiral inductors. In order to verify the workability of the proposed circuit, it has been simulated with TSMC CMOS 0.18[Formula: see text][Formula: see text]m process parameters. The proposed circuit is useful in low-voltage low-power VLSI applications as it uses a single supply of 0.75[Formula: see text]V. The power consumption of BD-TIA is very low, being 0.37[Formula: see text]mW, because a standard MOSFET has been replaced by a bulk-driven MOSFET (BDMOS), while the 3-dB bandwidth is observed to be 4.5[Formula: see text]GHz. The mathematical investigation and small signal analysis show that the simulation results are in good agreement.


2018 ◽  
Vol 71 ◽  
pp. 37-46 ◽  
Author(s):  
Behnam Abdollahi ◽  
Baset Mesgari ◽  
Saeed Saeedi ◽  
Abdolreza Nabavi

2010 ◽  
Vol 58 (10) ◽  
pp. 2538-2548 ◽  
Author(s):  
Christian Knochenhauer ◽  
Stefan Hauptmann ◽  
J. Christoph Scheytt ◽  
Frank Ellinger

Sign in / Sign up

Export Citation Format

Share Document