Complete protection scheme for active closed-loop distribution systems

Author(s):  
Zhiyuan Pan ◽  
Hongwei Li ◽  
Jing Wang ◽  
Xinyue Si
2021 ◽  
Vol 12 (3) ◽  
pp. 155
Author(s):  
Nevin Fawzy ◽  
Hany F. Habib ◽  
Osama Mohammed

This paper proposes a decentralized control approach using a co-simulation platform to monitor protective elements and provide complete protection scheme for distribution systems. Real time measurements are obtained by interfacing the system model in RSCAD/RTDS with SEL 421 protective relays and publish/subscribe the voltage and current signals of the buses and transmission lines based on IEC 61850 communication protocol to isolate the fault correctly. The proposed technique helps to identify the location of the fault and introduces primary and buck protection for the system. The communication networks assists in facing cyber and physical threats and finding a new path for healthy relays to remove faults from the system. This technique is investigated on an IEEE 14 bus system for all possible fault locations. The proposed scheme can clear the fault by isolating the minimum part of the system and improving the endurance of the power in it. The system shows the smooth information flow between the cyber and physical parts to isolate faults in it in different cases.


Author(s):  
Zhengguang Xiao ◽  
Xiaodong Zheng ◽  
Yangyang He ◽  
Nengling Tai ◽  
Haotian Cheng ◽  
...  

2018 ◽  
Vol 7 (3) ◽  
pp. 223-231
Author(s):  
Saad Muftah Saad ◽  
Naser El Naily ◽  
Faisal A. Mohamed

The environmental and economic features of renewable energy sources have made it possible to be integrated as Distributed Generation (DG) units in distribution networks and to be widely utilized in modern distribution systems. The intermittent nature of renewable energy sources, altering operational conditions, and the complex topology of active distribution networks makes the level of fault currents significantly variable. Thus, the use of distance protection scheme instead of conventional overcurrent schemes offers an appropriate alternative for protection of modern distribution networks. In this study, the effect of integrating multiple DG units on the effective cover of distance protection schemes and the coordination between various relays in the network was studied and investigated in radiology and meshed operational topologies. Also, in cases of islanded and grid-connected modes. An adaptive distance scheme has been proposed for adequate planning of protection schemes to protect complex networks with multiple distribution sources. The simplified simulated network implemented in NEPLAN represents a benchmark IEC microgrid. The comprehensive results show an effective protection measure for secured microgrid operation.Article History: Received October 18th 2017; Received in revised form May 17th 2018; Accepted July 8th 2018; Available onlineHow to Cite This Article: Saad, S.M., Naily, N.E. and Mohamed, F.A. (2018). Investigating the Effect of DG Infeed on the Effective Cover of Distance Protection Scheme in Mixed-MV Distribution Network. International Journal of Renewable Energy Development, 7(3), 223-231.https://doi.org/10.14710/ijred.7.3.223-231


Complexity ◽  
2020 ◽  
Vol 2020 ◽  
pp. 1-21
Author(s):  
Thuan Thanh Nguyen ◽  
Thang Trung Nguyen ◽  
Ngoc Au Nguyen

In this paper, an effective method to determine an initial searching point (ISP) of the network reconfiguration (NR) problem for power loss reduction is proposed for improving the efficiency of the continuous genetic algorithm (CGA) to the NR problem. The idea of the method is to close each initial open switch in turn and solve power flow for the distribution system with the presence of a closed loop to choose a switch with the smallest current in the closed loop for opening. If the radial topology constraint of the distribution system is satisfied, the switch opened is considered as a control variable of the ISP. Then, ISP is attached to the initial population of CGA. The calculated results from the different distribution systems show that the proposed CGA using ISP could reach the optimal radial topology with better successful rate and obtained solution quality than the method based on CGA using the initial population generated randomly and the method based on CGA using the initial radial configuration attached to the initial population. As a result, CGA using ISP can be a favorable method for finding a more effective radial topology in operating distribution systems.


Author(s):  
Juan M. Home-Ortiz ◽  
Leonardo H. Macedo ◽  
Jose R. S. Mantovani ◽  
Ruben Romero ◽  
Renzo Vargas ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document