Mitigating fluctuation of wind turbine power generation system by introduction of electrical energy storage with combined use of EDLC and Lead Acid Storage Battery

Author(s):  
Yutaka Yoshida ◽  
Guohong Wu ◽  
Tamotsu Minakawa
2016 ◽  
Vol 708 ◽  
pp. 110-117
Author(s):  
Imam Djunaedi ◽  
Haifa Wahyu ◽  
Sugiyatno

The paper presents an architecture and engineering of hydrogen fuel cell electric power generation system based on renewable energy that already installed in Tenjolaya village, Wanassalam sub-district, Lebak - Banten Province. It also discloses some important information as well as some valuable experiences from the pilot plant operation. The renewable electric power generation system combines wind turbine, photovoltaic, hydrogen electrolysis and fuel cell. The basic design of this system is focused on energy storage in the form of hydrogen gas that can be converted back into electricity by using fuel cell units. The engineering development was done to address the issues on limited energy storage in the battery unit which has several drawbacks i.e. short battery lifetime, limited storage capacity and rigorous and continuous maintenance schedule. To enable remote control and monitoring, a web based monitoring system was developed. From the monitoring system the following information are obtained: the amount of electrical power produced by the wind turbine that was intermittent and depends on time that reached 3000 W; similar pattern is observed from the output power of solar PVs and a maximum point of the solar cell power generation was 640 Watt; the time of electricity production by the wind turbine and the solar cell is complementary to each other in every one day cycle. Two valuable experiences have been gained those are: the location near sea shore has a very corrosive air that damages the wind turbine component, and the use of fuel cell requires high investment cost.


2009 ◽  
Vol 45 (6) ◽  
pp. 2109-2115 ◽  
Author(s):  
Ming-Shun Lu ◽  
Chung-Liang Chang ◽  
Wei-Jen Lee ◽  
Li Wang

2013 ◽  
Vol 284-287 ◽  
pp. 518-522
Author(s):  
Hua Wei Chi ◽  
Pey Shey Wu ◽  
Kami Ru Chen ◽  
Yue Hua Jhuo ◽  
Hung Yun Wu

A wind-power generation system uses wind turbine blades to convert the kinetic energy of wind to drive a generator which in turn yields electricity, the aerodynamic performance of the wind turbine blades has decisive effect on the cost benefit of the whole system. The aerodynamic analysis and the optimization of design parameters for the wind turbine blades are key techniques in the early stage of the development of a wind-power generation system. It influences the size selection of connecting mechanisms and the specification of parts in the design steps that follows. A computational procedure and method for aerodynamics optimization was established in this study for three-dimensional blades and the rotor design of a wind turbine. The procedure was applied to improving a previously studied 25kW wind turbine rotor design. Results show that the aerodynamic performance of the new three-dimensional blades has remarkable improvement after optimization.


Sign in / Sign up

Export Citation Format

Share Document