scholarly journals P-wave and S-wave velocity structure of northern Cascadia margin gas hydrates

2011 ◽  
Vol 187 (3) ◽  
pp. 1363-1377 ◽  
Author(s):  
Ranjan Dash ◽  
George Spence
1967 ◽  
Vol 4 (5) ◽  
pp. 961-975 ◽  
Author(s):  
K. G. Barr

Long-range seismic observations at the standard Canadian seismic stations, from chemical explosions in Hudson Bay and Lake Superior, are used to derive a P-wave velocity structure for the upper mantle. The coordinates of observed cusps are used to define the structural discontinuities. These discontinuities are at depths of 126 and 366 km, which agree closely with the depths of the S-wave velocity discontinuities deduced from surface-wave observations. The observations do not require a low velocity layer in the upper mantle.


2014 ◽  
Vol 57 (4) ◽  
Author(s):  
Gaddale Suresh ◽  
Satbir S. Teotia ◽  
Sankar N. Bhattacharya

<p>Through inversion of fundamental mode group velocities of Love and Rayleigh waves, we study the crustal and subcrustal structure across the central Deccan Volcanic Province (DVP), which is one of the world’s largest terrestrial flood basalts. Our analysis is based on broadband seismograms recorded at seismological station Bhopal (BHPL) in the central India from earthquakes located near west coast of India, with an average epicentral distance about 768 km. The recording station and epicentral zone are situated respectively on the northern and southern edges of DVP with wave paths across central DVP. The period of group velocity data ranges from 5 to 60 s for Rayleigh waves and 5 to 45 s for Love waves. Using the genetic algorithm, the observed data have been inverted to obtain the crust and subcrustal velocity structure along the wavepaths. Using this procedure, a similar velocity structure was also obtained earlier for the northwestern DVP, which is in the west of the present study region. Comparison of results show that the crustal thickness decreases westward from central DVP (39.6 km) to northwestern DVP (37.8 km) along with the decrease of thickness of upper crust; while the thickness of lower crust remains nearly same. From east to west S-wave velocity in the upper crust decreases by 2 to 3 per cent, while P-wave velocity in the whole crust and subcrust decreases by 3 to 6 per cent. The P- and S-wave velocities are positively correlated with crustal thickness and negatively correlated with earth’s heat flow. It appears that the elevated crustal and subcrustal temperature in the western side is the main factor for low velocities on this side.</p>


2019 ◽  
Vol 109 (5) ◽  
pp. 1922-1934 ◽  
Author(s):  
Liam D. Toney ◽  
Robert E. Abbott ◽  
Leiph A. Preston ◽  
David G. Tang ◽  
Tori Finlay ◽  
...  

Abstract In preparation for the next phase of the Source Physics Experiments, we acquired an active‐source seismic dataset along two transects totaling more than 30 km in length at Yucca Flat, Nevada, on the Nevada National Security Site. Yucca Flat is a sedimentary basin which has hosted more than 650 underground nuclear tests (UGTs). The survey source was a novel 13,000 kg modified industrial pile driver. This weight drop source proved to be broadband and repeatable, richer in low frequencies (1–3 Hz) than traditional vibrator sources and capable of producing peak particle velocities similar to those produced by a 50 kg explosive charge. In this study, we performed a joint inversion of P‐wave refraction travel times and Rayleigh‐wave phase‐velocity dispersion curves for the P‐ and S‐wave velocity structure of Yucca Flat. Phase‐velocity surface‐wave dispersion measurements were obtained via the refraction microtremor method on 1 km arrays, with 80% overlap. Our P‐wave velocity models verify and expand the current understanding of Yucca Flat’s subsurface geometry and bulk properties such as depth to Paleozoic basement and shallow alluvium velocity. Areas of disagreement between this study and the current geologic model of Yucca Flat (derived from borehole studies) generally correlate with areas of widely spaced borehole control points. This provides an opportunity to update the existing model, which is used for modeling groundwater flow and radionuclide transport. Scattering caused by UGT‐related high‐contrast velocity anomalies substantially reduced the number and frequency bandwidth of usable dispersion picks. The S‐wave velocity models presented in this study agree with existing basin‐wide studies of Yucca Flat, but are compromised by diminished surface‐wave coherence as a product of this scattering. As nuclear nonproliferation monitoring moves from teleseismic to regional or even local distances, such high‐frequency (>5  Hz) scattering could prove challenging when attempting to discriminate events in areas of previous testing.


2021 ◽  
pp. 228973
Author(s):  
Junhao Qu ◽  
Stephen S. Gao ◽  
Changzai Wang ◽  
Kelly H. Liu ◽  
Shaohui Zhou ◽  
...  

2021 ◽  
Author(s):  
Wanbo Xiao ◽  
Siqi Lu ◽  
Yanbin Wang

&lt;p&gt;Despite the popularity of the horizontal to vertical spectral ratio (HVSR) method in site effect studies, the origin of the H/V peaks has been controversial since this method was proposed. Many previous studies mainly focused on the explanation of the first or single peak of the H/V ratio, trying to distinguish between the two hypotheses &amp;#8212; the S-wave resonance and ellipticity of Rayleigh wave. However, it is common both in numerical simulations and practical experiments that the H/V ratio exhibits multiple peaks, which is essential to explore the origin of the H/V peaks.&lt;/p&gt;&lt;p&gt;The cause for the multiple H/V peaks has not been clearly figured out, and once was simply explained as the result of multi subsurface layers. Therefore, we adopted numerical method to simulate the ambient noise in various layered half-space models and calculated the H/V ratio curves for further comparisons. The peak frequencies of the H/V curves accord well with the theoretical frequencies of S-wave resonance in two-layer models, whose frequencies only depend on the S wave velocity and the thickness of the subsurface layer. The same is true for models with varying model parameters. Besides, the theoretical formula of the S-wave resonance in multiple-layer models is proposed and then supported by numerical investigations as in the cases of two-layer models. We also extended the S-wave resonance to P-wave resonance and found that its theoretical frequencies fit well with the V/H peaks, which could be an evidence to support the S-wave resonance theory from a new perspective. By contrast, there are obvious differences between the higher orders of the H/V ratio peaks and the higher orders of Rayleigh wave ellipticity curves both in two-layer and multiple-layer models. The Rayleigh wave ellipticity curves are found to be sensitive to the Poisson&amp;#8217;s ratio and the thickness of the subsurface layer, so the variation of the P wave velocity can affect the peak frequencies of the Rayleigh wave ellipticity curves while the H/V peaks show slight change. The Rayleigh wave ellipticity theory is thus proved to be inappropriate for the explanation of the multiple H/V peaks, while the possible effects of the Rayleigh wave on the fundamental H/V peak still cannot be excluded.&lt;/p&gt;&lt;p&gt;Based on the analyses above, we proposed a new evidence to support the claim that the peak frequencies of the H/V ratio curve, except the fundamental peaks, are caused by S-wave resonance. The relationship between the P-wave resonance and the V/H peaks may also find further application.&lt;/p&gt;


2021 ◽  
Author(s):  
Sheng Chen ◽  
Qingcai Zeng ◽  
Xiujiao Wang ◽  
Qing Yang ◽  
Chunmeng Dai ◽  
...  

Abstract Practices of marine shale gas exploration and development in south China have proved that formation overpressure is the main controlling factor of shale gas enrichment and an indicator of good preservation condition. Accurate prediction of formation pressure before drilling is necessary for drilling safety and important for sweet spots predicting and horizontal wells deploying. However, the existing prediction methods of formation pore pressures all have defects, the prediction accuracy unsatisfactory for shale gas development. By means of rock mechanics analysis and related formulas, we derived a formula for calculating formation pore pressures. Through regional rock physical analysis, we determined and optimized the relevant parameters in the formula, and established a new formation pressure prediction model considering P-wave velocity, S-wave velocity and density. Based on regional exploration wells and 3D seismic data, we carried out pre-stack seismic inversion to obtain high-precision P-wave velocity, S-wave velocity and density data volumes. We utilized the new formation pressure prediction model to predict the pressure and the spatial distribution of overpressure sweet spots. Then, we applied the measured pressure data of three new wells to verify the predicted formation pressure by seismic data. The result shows that the new method has a higher accuracy. This method is qualified for safe drilling and prediction of overpressure sweet spots for shale gas development, so it is worthy of promotion.


2005 ◽  
Vol 42 (6) ◽  
pp. 1205-1222 ◽  
Author(s):  
Gabriela Fernández-Viejo ◽  
Ron M Clowes ◽  
J Kim Welford

Shear-wave seismic data recorded along four profiles during the SNoRE 97 (1997 Slave – Northern Cordillera Refraction Experiment) refraction – wide-angle reflection experiment in northwestern Canada are analyzed to provide S-wave velocity (Vs) models. These are combined with previous P-wave velocity (Vp) models to produce cross sections of the ratio Vp/Vs for the crust and upper mantle. The Vp/Vs values are related to rock types through comparisons with published laboratory data. The Slave craton has low Vp/Vs values of 1.68–1.72, indicating a predominantly silicic crustal composition. Higher values (1.78) for the Great Bear and eastern Hottah domains of the Wopmay orogen imply a more mafic than average crustal composition. In the western Hottah and Fort Simpson arc, values of Vp/Vs drop to ∼1.69. These low values continue westward for 700 km into the Foreland and Omineca belts of the Cordillera, providing support for the interpretation from coincident seismic reflection studies that much of the crust from east of the Cordilleran deformation front to the Stikinia terrane of the Intermontane Belt consists of quartzose metasedimentary rocks. Stikinia shows values of 1.78–1.73, consistent with its derivation as a volcanic arc terrane. Upper mantle velocity and ratio values beneath the Slave craton indicate an ultramafic peridotitic composition. In the Wopmay orogen, the presence of low Vp/Vs ratios beneath the Hottah – Fort Simpson transition indicates the presence of pyroxenite in the upper mantle. Across the northern Cordillera, low Vp values and a moderate-to-high ratio in the uppermost mantle are consistent with the region's high heat flow and the possible presence of partial melt.


Sign in / Sign up

Export Citation Format

Share Document