scholarly journals Development of a gas diffusion probe for the determination of methane concentrations and diffusion characteristics in flooded paddy soil

1994 ◽  
Vol 14 (4) ◽  
pp. 307-318 ◽  
Author(s):  
Franz Rothfuss ◽  
Ralf Conrad
2017 ◽  
Vol 102 (5) ◽  
pp. 1073-1090 ◽  
Author(s):  
Artur Kuligiewicz ◽  
Arkadiusz Derkowski

Abstract Smectites are able to retain molecular tightly bound water (TBW) at temperatures above 100 °C, even after prolonged drying. The presence of TBW affects the stable isotope ratios, the dehydroxylation behavior of smectites and smectite-rich samples and also has implications in measuring various properties of clay-rich rocks. Five reference smectites, in Mg-, Ca-, Na-, and Cs-exchanged forms were subjected to different drying protocols followed by the determination of TBW contents using precise thermogravimetric (TG) analysis. Activation energies (Ea) of the removal of different water fractions at temperatures up to 1000 °C were determined in non-isothermal TG experiments using model-independent methods. Additionally, 4A and 13X zeolites were examined in both cases as apparent OH-free references. After drying at 110 °C, all smectites still contained up to 3 water molecules per interlayer cation. The TBW contents in smectites were found to be primarily dependent on the isothermal drying temperature. For a given temperature, TBW contents decreased with respect to the type of interlayer cation in the following order: Mg > Ca > Na > Cs. The influence of the time of drying and the smectite layer charge were found to be negligible. The Ea of dehydration below 100 °C, as determined by the Friedman method, was quite constant within the 45–60 kJ/mol range. The Ea of TBW removal increased along with the degree of reaction from 90 to 180 kJ/mol, while the Ea of dehydroxylation was found in the 159–249 kJ/mol range, highly depending on the sample’s octahedral sheet structure and the interlayer cation. The Mg2+ cation can hold H2O molecules even beyond 550 °C, making it available during dehydroxylation or—for geologic-scale reactions—pass H2O to metamorphic conditions. High similarities between the TBW contents and the Ea of dehydration for smectites and cationic (low Si/Al-) zeolites lead to the conclusion that TBW in smectites is remarkably similar to zeolitic water in terms of cation bonding and diffusion characteristics. The optimal drying protocol for smectites is to substitute interlayer cations with cations of a low-hydration enthalpy, such as Cs, and to dry a sample at 300 °C, provided that the sample is Fe-poor. Fe-rich smectites should be dried at 200 °C to avoid dehydroxylation that occurs below 300 °C.


2007 ◽  
Vol 38 (3) ◽  
pp. 203-210 ◽  
Author(s):  
G. Fortin ◽  
E. van Bochove ◽  
H.G. Jones ◽  
G. Thériault ◽  
M. Bernier

A coupled air permeameter–gas chamber has been used to measure both the air permeability and diffusion coefficient of an inert gas through natural ice layers. The apparatus was designed to take sequential measurements of both these parameters for the same sample without any intermediate manipulation of the specimen. In avoiding manipulation, errors related to the structural variations between different replicates are eliminated. The apparatus is portable, allowing measurements to be made directly at the study site. The permeability is directly measured in situ by the air permeameter while gas samples used in the diffusion experiments are collected and subsequently analysed at the laboratory. The validation of the apparatus was accomplished by comparing theoretical values for the permeability of beds of spherical beads with known dimensions. Measured permeability values,for different ice samples vary from 0.005 × 10−10 to 12.9 × 10−10 m2. Mean diffusion coefficients ranged from 0.013 to 0.028 cm2 s−1. These values are situated in the range for those found between hard packed snow and loose compacted soil.


2019 ◽  
Vol 674 ◽  
pp. 327-335 ◽  
Author(s):  
Lina Lin ◽  
Zhengguo Song ◽  
Xuewei Liu ◽  
Zulqarnain Haider Khan ◽  
Weiwen Qiu

Chemosphere ◽  
1996 ◽  
Vol 33 (12) ◽  
pp. 2487-2504 ◽  
Author(s):  
F. Rothfuss ◽  
F.G.C. Bijnen ◽  
R. Conrad ◽  
F.J.M. Harren ◽  
J. Reuss

1986 ◽  
Vol 71 ◽  
Author(s):  
I. Suni ◽  
M. Finetti ◽  
K. Grahn

AbstractA computer model based on the finite element method has been applied to evaluate the effect of the parasitic area between contact and diffusion edges on end resistance measurements in four terminal Kelvin resistor structures. The model is then applied to Al/Ti/n+ Si contacts and a value of contact resistivity of Qc = 1.8×10−7.Ωcm2 is derived. For comparison, the use of a self-aligned structure to avoid parasitic effects is presented and the first experimental results obtained on Al/Ti/n+Si and Al/CoSi2/n+Si contacts are shown and discussed.


2013 ◽  
Vol 83-84 ◽  
pp. 217-223 ◽  
Author(s):  
Elke Jacops ◽  
Geert Volckaert ◽  
Norbert Maes ◽  
Eef Weetjens ◽  
Joan Govaerts

Sign in / Sign up

Export Citation Format

Share Document