Monte Carlo Study of Phonon Transport in Solid Thin Films Including Dispersion and Polarization

2001 ◽  
Vol 123 (4) ◽  
pp. 749-759 ◽  
Author(s):  
Sandip Mazumder ◽  
Arunava Majumdar

The Boltzmann Transport Equation (BTE) for phonons best describes the heat flow in solid nonmetallic thin films. The BTE, in its most general form, however, is difficult to solve analytically or even numerically using deterministic approaches. Past research has enabled its solution by neglecting important effects such as dispersion and interactions between the longitudinal and transverse polarizations of phonon propagation. In this article, a comprehensive Monte Carlo solution technique of the BTE is presented. The method accounts for dual polarizations of phonon propagation, and non-linear dispersion relationships. Scattering by various mechanisms is treated individually. Transition between the two polarization branches, and creation and destruction of phonons due to scattering is taken into account. The code has been verified and evaluated by close examination of its ability or failure to capture various regimes of phonon transport ranging from diffusive to the ballistic limit. Validation results show close agreement with experimental data for silicon thin films with and without doping. Simulation results show that above 100 K, transverse acoustic phonons are the primary carriers of energy in silicon.

2012 ◽  
Vol 134 (5) ◽  
Author(s):  
Mitsuhiro Matsumoto ◽  
Masaya Okano ◽  
Yusuke Masao

Analysis of phonon dynamics based on a linearized Boltzmann transport equation is widely used for thermal analysis of solid thin films, but couplings among various phonon modes appear in some situations. We propose a direct simulation Monte Carlo (DSMC) scheme to simulate the phonon gas starting without the conventional linearization approximation. This requires no relaxation time as an input parameter, and we can investigate the couplings among phonons with different modes. A prototype code based on a simple phonon model was developed, and energy flux was evaluated for thin films of various thickness as a test calculation.


Author(s):  
Arpit Mittal ◽  
Sandip Mazumder

The Monte Carlo (MC) method has found prolific use in the solution of the Boltzmann Transport Equation (BTE) for phonons for the prediction of non-equilibrium heat conduction in crystalline thin films. This paper contributes to the state-of-the-art by performing a systematic study of the role of the various phonon modes on thermal conductivity predictions—in particular, optical phonons. A procedure to calculate scattering time-scales with the inclusion of optical phonons is described and implemented. The roles of various phonon modes are assessed. It is found that Transverse acoustic (TA) phonons are the primary carriers of energy at low temperatures. At high temperatures (T > 200K), longitudinal acoustic (LA) phonons carry more energy than TA phonons. When optical phonons are included, there is a significant change in the amount of energy carried by various phonons modes. At room temperature, optical modes are found to carry about 25% of the energy at steady state in Silicon thin films. Most importantly, inclusion of optical phonons results in better match with experimental observations for Silicon thin-film thermal conductivity.


2012 ◽  
Vol 26 (17) ◽  
pp. 1250104 ◽  
Author(s):  
B. S. YILBAS ◽  
S. BIN MANSOOR

Phonon transport in two-dimensional silicon and aluminum films is investigated. The frequency dependent solution of Boltzmann transport equation is obtained numerically to account for the acoustic and optical phonon branches. The influence of film size on equivalent equilibrium temperature distribution in silicon and aluminum films is presented. It is found that increasing film width influences phonon transport in the film; in which case, the difference between the equivalent equilibrium temperature due to silicon and diamond films becomes smaller for wider films than that of the thinner films.


2010 ◽  
Vol 132 (5) ◽  
Author(s):  
Arpit Mittal ◽  
Sandip Mazumder

Abstract The Monte Carlo method has found prolific use in the solution of the Boltzmann transport equation for phonons for the prediction of nonequilibrium heat conduction in crystalline thin films. This paper contributes to the state-of-the-art by performing a systematic study of the role of the various phonon modes on thermal conductivity predictions, in particular, optical phonons. A procedure to calculate three-phonon scattering time-scales with the inclusion of optical phonons is described and implemented. The roles of various phonon modes are assessed. It is found that transverse acoustic (TA) phonons are the primary carriers of energy at low temperatures. At high temperatures (T>200 K), longitudinal acoustic (LA) phonons carry more energy than TA phonons. When optical phonons are included, there is a significant change in the amount of energy carried by various phonons modes, especially at room temperature, where optical modes are found to carry about 25% of the energy at steady state in silicon thin films. Most importantly, it is found that inclusion of optical phonons results in better match with experimental observations for silicon thin-film thermal conductivity. The inclusion of optical phonons is found to decrease the thermal conductivity at intermediate temperatures (50–200 K) and to increase it at high temperature (>200 K), especially when the film is thin. The effect of number of stochastic samples, the dimensionality of the computational domain (two-dimensional versus three-dimensional), and the lateral (in-plane) dimension of the film on the statistical accuracy and computational efficiency is systematically studied and elucidated for all temperatures.


2016 ◽  
Vol 403 ◽  
pp. 167-171 ◽  
Author(s):  
R. Masrour ◽  
A. Jabar ◽  
A. Benyoussef ◽  
M. Hamedoun

Sign in / Sign up

Export Citation Format

Share Document