Method of in situ measuring surface tension of a solid-gas interface

2010 ◽  
Vol 110 (1) ◽  
pp. 102-107 ◽  
Author(s):  
E. I. Gershman ◽  
S. N. Zhevnenko
2021 ◽  
pp. 1-13
Author(s):  
Anna Belcher ◽  
Sophie Fielding ◽  
Andrew Gray ◽  
Lauren Biermann ◽  
Gabriele Stowasser ◽  
...  

Abstract Antarctic krill are the dominant metazoan in the Southern Ocean in terms of biomass; however, their wide and patchy distribution means that estimates of their biomass are still uncertain. Most currently employed methods do not sample the upper surface layers, yet historical records indicate that large surface swarms can change the water colour. Ocean colour satellites are able to measure the surface ocean synoptically and should theoretically provide a means for detecting and measuring surface krill swarms. Before we can assess the feasibility of remote detection, more must be known about the reflectance spectra of krill. Here, we measure the reflectance spectral signature of Antarctic krill collected in situ from the Scotia Sea and compare it to that of in situ water. Using a spectroradiometer, we measure a strong absorption feature between 500 and 550 nm, which corresponds to the pigment astaxanthin, and high reflectance in the 600–700 nm range due to the krill's red colouration. We find that the spectra of seawater containing krill is significantly different from seawater only. We conclude that it is tractable to detect high-density swarms of krill remotely using platforms such as optical satellites and unmanned aerial vehicles, and further steps to carry out ground-truthing campaigns are now warranted.


2009 ◽  
Vol 121 (41) ◽  
pp. 7589-7589
Author(s):  
Laurent Mugherli ◽  
Olga N. Burchak ◽  
Larissa A. Balakireva ◽  
Aline Thomas ◽  
François Chatelain ◽  
...  

2020 ◽  
Vol 21 (9) ◽  
pp. 3271 ◽  
Author(s):  
Takuki Komenami ◽  
Akihiro Yoshimura ◽  
Yasunari Matsuno ◽  
Mari Sato ◽  
Chikara Sato

We developed a liquid-phase synthesis method for Pd-based nanostructure, in which Pd dissolved in dimethyl sulfoxide (DMSO) solutions was precipitated using acid aqueous solution. In the development of the method, in situ monitoring using atmospheric scanning electron microscopy (ASEM) revealed that three-dimensional (3D) Pd-based nanonetworks were deformed to micrometer-size particles possibly by the surface tension of the solutions during the drying process. To avoid surface tension, critical point drying was employed to dry the Pd-based precipitates. By combining ASEM monitoring with critical point drying, the synthesis parameters were optimized, resulting in the formation of lacelike delicate nanonetworks using citric acid aqueous solutions. Precipitation using HCl acid aqueous solutions allowed formation of 500-nm diameter nanorings connected by nanowires. The 3D nanostructure formation was controllable and modifiable into various shapes using different concentrations of the Pd and Cl ions as the parameters.


Author(s):  
Ming Gan ◽  
Yang Zhang ◽  
Vikas Tomar

This research reports in situ creep properties of silicon microcantilevers at temperatures ranging from 25 °C to 100 °C under uniaxial compressive stress. Results reveal that in the stress range of 50–150 MPa, the strain rate of the silicon cantilever increases linearly as a function of applied stress. The strain rate (0.2–2.5 ×10-6s-1) was comparable to literature values for bulk silicon reported in the temperature range of 1100–1300 °C at one tenth of the reported stress level. The experiments quantify the extent of the effect of surface stress on uniaxial creep strain rate by measuring surface stress values during uniaxial temperature dependent creep.


Author(s):  
Caroline E. Liberti ◽  
Nathan B. Crane

Assembly at sub-millimeter dimensions is a challenging process that is often not economically feasible. This limits many systems to in-situ fabrication from compatible materials. If freed from these limitations on processes and materials, it might be possible to improve microsystem performance. One critical application of recent interest is in the assembly of small crystalline photovoltaic cells onto low-cost and possibly flexible modules [1].


Sign in / Sign up

Export Citation Format

Share Document