Study of Liquid Pool Fire Suppression with Water Mists by Cone Calorimeter

2002 ◽  
Vol 20 (6) ◽  
pp. 465-477 ◽  
Author(s):  
Liu Jianghong ◽  
Liao Guangxuan ◽  
Fan Weicheng ◽  
Yao Bin ◽  
Lu Xiyun
Energies ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 5850
Author(s):  
Hassan Raza Shah ◽  
Kun Wang ◽  
Xu Qing Lang ◽  
Jing Wu Wang ◽  
Jing Jun Wang ◽  
...  

Recently, water has been employed as a supportive agent for the preparation of multiple suppressing agents including aqueous film forming foams (AFFF), which is combined with different kinds of gases for its various applications. In this study, the water mist is chosen for the gas-suppressing agent such as carbon dioxide. Our work investigated the suppression effects of water droplets on the n-heptane pool fire, and its mixture with carbon dioxide, respectively. The size and frequency of droplets with their effect on temperature and suppression was compared to observe the difference in the suppression. Initially, it was found that the droplets having a larger droplet size were found to be more efficient as compared to the smaller droplets with respect to the heat release rate, temperature, and radiation. Afterwards, a mixture of water droplets and carbon dioxide was simultaneously discharged to compare the difference between these two suppressing agents. It was found that the synergistic effect of the mixture has higher advantages over the use of only water suppression. It helps reduce the hot gases that surround the pool fire and allows the water mist to travel efficiently towards the fuel. Both suppression mechanisms were set to similar initial parameters that lead to different outcomes.


2017 ◽  
Vol 89 ◽  
pp. 16-21 ◽  
Author(s):  
Liang Zhou ◽  
Dong Zeng ◽  
Dongyang Li ◽  
Marcos Chaos

2007 ◽  
Vol 42 (4) ◽  
pp. 295-309 ◽  
Author(s):  
Jy-Cheng Chang ◽  
Chih-Ming Lin ◽  
Sheng-Lung Huang

2015 ◽  
Vol 123 (1) ◽  
pp. 329-337 ◽  
Author(s):  
Xin Ma ◽  
Ran Tu ◽  
Qiyuan Xie ◽  
Yong Jiang ◽  
Yanli Zhao ◽  
...  

2002 ◽  
Vol 29 (1) ◽  
pp. 377-384 ◽  
Author(s):  
J. Richard ◽  
J.P. Garo ◽  
J.M. Souil ◽  
J.P. Vantelon ◽  
D. Lemonnier

2017 ◽  
Vol 31 (4) ◽  
pp. 59-64
Author(s):  
Chan Seok Jeong ◽  
◽  
Chi Young Lee ◽  

Author(s):  
Nathaniel Sauer ◽  
Xiaoyue Pi ◽  
Kemal Arsava ◽  
Ali Rangwala

ABSTRACT The focus of this study is to quantify the controlling mechanisms, which increases the burning rate of a pool fire using a Flame RefluxerTM. Part of the Flame RefluxerTM, is exposed to the fire and is heated up transferring heat to the fuel pool layer to which it extends. This enhances the conventional heat transfer that occurs only through the pool surface by transferring the heat from a fire to an in-depth layer of the liquid. Both sensible heat and heat of vaporization are supplied at increased rates by the submerged material. As an additional important effect, nucleate boiling onsets at the surface of the inserted material that generates bubbles of fuel vapor. These bubbles are transported to the surface of the pool, where they burst and release the v0061por to the gas-phase. While doing so, additional processes such as formation of micron-sized droplets or small jets of liquid fuel from the break point occur. This phenomenon causes additional fuel in liquid phase transported to the gas-phase, where they vaporize, ignite and burn in heterogeneous mode. Therefore, the processes involved in FR occur in three steps; enhancement of heat transfer to the liquid causing nucleate boiling, formation of bubbles and their transport, and dynamics of bubble breakage at the pool surface causing transfer of liquid fuel in the form of tiny droplets or jets towards the gas-phase. This study analyzes the influence of bubbles on the burning behavior of a pool fire using a simple experiment involving burning ethanol as a fuel. Ethanol is used due to its transparency and hence bubble behavior is easily observable on the heater surface. A 5cm x 5cm glass enclosure constantly replenished with ethanol serves as the burning pool. A solid aluminum block (8.8 cm tall x 3.6 cm wide x 1.2 cm thick) is placed in the flame to act as the Flame RefluxerTM. Bubble counts and burning rate measurements indicate the influence of the bubbles on the overall burning rate of the liquid pool.


2019 ◽  
Vol 108 ◽  
pp. 102826 ◽  
Author(s):  
Konstantinos E. Chotzoglou ◽  
Eleni K. Asimakopoulou ◽  
Jianping Zhang ◽  
Michael A. Delichatsios

Sign in / Sign up

Export Citation Format

Share Document