Natural convection flow in an open rectangular cavity with cold sidewalls and constant volumetric heat source

2011 ◽  
Vol 225 (5) ◽  
pp. 1191-1201 ◽  
Author(s):  
M Saleem ◽  
S Asghar ◽  
M A Hossain
Keyword(s):  
Natural Convection ◽  
Rayleigh Number ◽  
Finite Difference ◽  
Heat Source ◽  
Prandtl Number ◽  
Rectangular Cavity ◽  
Maximum Temperature ◽  
Convection Flow ◽  
Natural Convection Flow ◽  
Volumetric Heat Source

The transient two-dimensional natural convection flow of Newtonian fluid in an open rectangular cavity has been studied numerically. The flow is induced due to constant internal heat generation. The alternate direct implicit (ADI) finite difference, together with upwind finite-difference scheme and successive over relaxation method, are used to solve the non-dimensional equations numerically. Effects of Rayleigh number, Ra, Prandtl number, Pr, and cavity aspect ratio, A, on the flow patterns and isotherms as well as on the heat transfer rate are studied graphically. The maximum temperature induced due to the constant volumetric heat source is found with the increase in cavity width, and to decrease with the increase in Prandtl number and Rayleigh number. The numerical model employed here is found to be in good agreement with the previous work.

scholarly journals Effects of Different Boundary Conditions at the Surfaces of the Extended Computational Domain in Computing the Natural Convection Flow in an Open Cavity

2016 ◽  
Vol 64 (1) ◽  
pp. 31-37 ◽  
Author(s):  
Roushanara Begum ◽  
MZI Bangalee
Keyword(s):  
Natural Convection ◽  
Rayleigh Number ◽  
Boundary Conditions ◽  
Open Cavity ◽  
Stream Line ◽  
Convection Flow ◽  
Computational Domain ◽  
Physical Domain ◽  
Natural Convection Flow ◽  
Different Boundary Conditions

Effects of different boundary conditions at the surfaces of the extended computational domain on buoyancy driven natural convection flow in a three dimensional open cavity are studied numerically. This study is carried out for turbulent flow where Rayleigh number is greater than 108. Air is used as working fluid having properties at 25°C temperature and 1atm pressure. To capture the turbulent nature of the flow k - ? model is used. ANSYS CFX software is used to solve the governing equations subject to the corresponding boundary conditions. The methodology is verified through a satisfactory comparison with some published results. Average mass flow, temperature, stream line, contour velocity and velocity profile are studied at different height. An extended computational domain around the physical domain of the cavity at different surrounding conditions is considered to investigate the effect of its existence on the computation. Effects of different surrounding boundary conditions on the physical domain of the cavity are studied and reported.A relation among non-dimensional parameters such as Nusselt number, Rayleigh number, Prandlt number and Reynolds number is also reported.Dhaka Univ. J. Sci. 64(1): 31-37, 2016 (January)

Numerical Simulations of an Unsteady Confined Natural Convection Flow

2009 ◽  
Author(s):  
Gillian Leplat ◽  
Emmanuel Laroche ◽  
Philippe Reulet ◽  
Pierre Millan
Keyword(s):  
Natural Convection ◽  
Rayleigh Number ◽  
Large Scale ◽  
Critical Rayleigh Number ◽  
Three Dimensional ◽  
High Amplitude ◽  
Joint Fluid ◽  
Convection Flow ◽  
Two Dimensional ◽  
Natural Convection Flow

A two-dimensional numerical analysis of a laminar natural convection flow within an air-filled enclosure is proposed in this paper from an unstable configuration previously studied experimentally. The flow is driven by a heated square-section cylinder located at the center of a square-section enclosure. Instabilities are observed for an aspect ratio (height of the cylinder over the height of the cavity) of 0.4 and cause the flow to turn into a three-dimensional and unsteady regime characterized by a symmetry breaking and large scale high amplitude flappings around the cylinder. The multi-physic computational software CEDRE, developed at the ONERA, is used to study this unstable behavior and a time-dependent compressible flow solver is used to perform the two-dimensional simulations under the low Mach number approximation, corresponding to the mid-depth cross-section of the enclosure from the experimental configuration. The first results on the investigation of the first unstable modes confirm the onset of the instabilities at the Rayleigh number of the experiment with asymmetrical motions of the fluid around the cylinder. Further analyses highlight the critical Rayleigh number that defines the instability threshold of the first bifurcation which origin and nature could have been identified. Finally, joint fluid-solid simulations are performed to determine more precisely the role of boundary conditions in the onset of instabilities.

Scaling of the Turbulent Natural Convection Flow in a Heated Square Cavity

1994 ◽  
Vol 116 (2) ◽  
pp. 400-408 ◽  
Author(s):  
R. A. W. M. Henkes ◽  
C. J. Hoogendoorn
Keyword(s):  
Natural Convection ◽  
Rayleigh Number ◽  
Convection Flow ◽  
Convection Boundary Layer ◽  
Square Cavity ◽  
Natural Convection Flow ◽  
Turbulent Natural Convection ◽  
Convection Boundary ◽  
Vertical Walls ◽  
Rayleigh Numbers

By numerically solving the Reynolds equations for air and water in a square cavity, with differentially heated vertical walls, at Rayleigh numbers up to 1020 the scalings of the turbulent natural convection flow are derived. Turbulence is modeled by the standard k–ε model and by the low-Reynolds-number k–ε models of Chien and of Jones and Launder. Both the scalings with respect to the Rayleigh number (based on the cavity size H) and with respect to the local height (y/H) are considered. The scalings are derived for the inner layer, outer layer, and core region. The Rayleigh number scalings are almost the same as the scalings for the natural convection boundary layer along a hot vertical plate. The scalings found are almost independent of the k–ε model used.

scholarly journals Natural Convection Flow Of An Electrically Conducting Fluid In A Rectangular Cavity Having Internal Energy Sources With Linearly Heated Bottom Wall

2013 ◽  
Vol 32 ◽  
pp. 61-73
Author(s):  
M Obayedullah ◽  
M M K Chowdhury
Keyword(s):  
Natural Convection ◽  
Rectangular Cavity ◽  
Conducting Fluid ◽  
Bottom Wall ◽  
Temperature Fields ◽  
Convection Flow ◽  
Natural Convection Flow ◽  
Electrically Conducting ◽  
Electrically Conducting Fluid ◽  
Rayleigh Numbers

Natural convection flow in a rectangular cavity containing internally heated and electrically conducting fluid has been investigated numerically. The bottom wall of the cavity is linearly heated whereas the top wall is well insulated. The left and right vertical walls are maintained at constant hot and cold temperature respectively.Results have been obtained with respect to Rayleigh numbers and Hartmann numbers. Flow and temperature fields for these cases have been studied. Average Nusselt numbers at hot, cold and linearly heated bottom wall have been calculated. It is found that the temperature, fluid flow and heat transfer strongly depend on internal and external Rayleigh numbers and Hartmann numbers. DOI: http://dx.doi.org/10.3329/ganit.v32i0.13648 GANIT J. Bangladesh Math. Soc. (ISSN 1606-3694) 32 (2012) 61-73    

Sign in / Sign up

Export Citation Format

Share Document