The issue of excessive wear of shaft journals co-working with a rubber bearing has been unexplained so far. Premature and sometimes very intensive wear of ship sliding bearings in water conditions is the reason for carry out very expensive and more frequent than expected repairs. The authors (E. Piątkowska, W. Litwin) made an attempt to find a case that influences the value of this wear described in the paper “Attempt at Evaluating the Influence of Bending Stress on Shaft Wear Process in Water Lubricated Sliding Bearing with Rubber Bush” (TRIBOLOGY 1/2017). These studies, however, did not explain the dependency of the wear process but showed how to progress further to find the answer to the question about the effect of bending stress on shaft wear. The research is continued on a modified test stand, and their results are presented in this paper. The profilographometer was used to evaluate the wear of the journal shaft. To compare wear intensity, roughness profiles have been 'removed' from the journals both before and after co-operation. They were compared in terms of bending stresses and bending moments.
Consideration of the use of artificial intelligence methods for determining the friction coefficient of lubricated sliding bearings