An implication of multi-objective optimization in test case generation

Author(s):  
Kavita Choudhary ◽  
Ankit Nahata ◽  
Shilpa
2013 ◽  
Vol 21 (2) ◽  
pp. 261-291 ◽  
Author(s):  
Matjaž Depolli ◽  
Roman Trobec ◽  
Bogdan Filipič

In this paper, we present AMS-DEMO, an asynchronous master-slave implementation of DEMO, an evolutionary algorithm for multi-objective optimization. AMS-DEMO was designed for solving time-intensive problems efficiently on both homogeneous and heterogeneous parallel computer architectures. The algorithm is used as a test case for the asynchronous master-slave parallelization of multi-objective optimization that has not yet been thoroughly investigated. Selection lag is identified as the key property of the parallelization method, which explains how its behavior depends on the type of computer architecture and the number of processors. It is arrived at analytically and from the empirical results. AMS-DEMO is tested on a benchmark problem and a time-intensive industrial optimization problem, on homogeneous and heterogeneous parallel setups, providing performance results for the algorithm and an insight into the parallelization method. A comparison is also performed between AMS-DEMO and generational master-slave DEMO to demonstrate how the asynchronous parallelization method enhances the algorithm and what benefits it brings compared to the synchronous method.


2012 ◽  
Vol 43 (4) ◽  
pp. 430-444 ◽  
Author(s):  
Annette K. Hansen ◽  
Henrik Madsen ◽  
Peter Bauer-Gottwein ◽  
Anne Katrine V. Falk ◽  
Dan Rosbjerg

This study uses multi-objective optimization of an integrated well field model to improve the management of a waterworks. The well field model, called WELLNES (WELL field Numerical Engine Shell) is a dynamic coupling of a groundwater model, a pipe network model, and a well model. WELLNES is capable of predicting the water level and the energy consumption of the individual production wells. The model has been applied to Søndersø waterworks in Denmark, where it predicts the energy consumption within 1.8% of the observed. The objectives of the optimization problem are to minimize the specific energy of the waterworks and to avoid inflow of contaminated water from a nearby contaminated site. The decision variables are the pump status (on/off), and the constraint is that the waterworks has to provide a certain amount of drinking water. The advantage of multi-objective optimization is that the Pareto curve provides the decision-makers with compromise solutions between the two competing objectives. In the test case the Pareto optimal solutions are compared with an exhaustive benchmark solution. It is shown that the energy consumption can be reduced by 4% by changing the pumping configuration without violating the protection against contamination.


2015 ◽  
Author(s):  
Matteo Diez ◽  
Andrea Serani ◽  
Emilio F. Campana ◽  
Omer Goren ◽  
Kadir Sarioz ◽  
...  

The paper presents recent research conducted within the NATO RTO Task Group AVT-204 “Assess the Ability to Optimize Hull Forms of Sea Vehicles for Best Performance in a Sea Environment.” The objective is the improvement of the hydrodynamic performances (resistance/powering requirements, seakeeping, etc.) of naval vessels, by integration of computational methods used to generate, evaluate, and optimize hull-form variants. Several optimization approaches are brought together and compared. A multi-objective optimization of the DTMB 5415 (specifically the MARIN variant 5415M) is used as a test case and results obtained so far using low-fidelity solvers show an average improvement for resistance and seakeeping performances of nearly 10 and 9%, respectively.


Sign in / Sign up

Export Citation Format

Share Document