Multichannel Analog and Digital Signal Transmission with Watt-Class Electrical Power Delivery by Means of Power-over-Fiber Using a Double-Clad Fiber

2018 ◽  
Author(s):  
Daisuke Kamiyama ◽  
Akira Yoneyama ◽  
Motoharu Matsuura
Keyword(s):  
Signal Transmission ◽  
Electrical Power ◽  
Digital Signal ◽  
Power Delivery

scholarly journals Research and Analysis of Digital Baseband Transmission System Based on MATLAB

2018 ◽  
Vol 1 (1) ◽  
Author(s):  
Chai Jianwen
Keyword(s):  
Signal Transmission ◽  
Digital Signal ◽  
Transmission System ◽  
Simulation Software ◽  
Line Pattern ◽  
Matlab Simulation ◽  
Simulation Process ◽  
Transmission Process ◽  
Baseband Signal ◽  
Digital Baseband

This paper mainly studies the basic concept of baseband transmission of digital signal and the transmission processof digital signal baseband transmission and how to design digital baseband transmission system with MATLABsoftware simulation. This paper fi rst introduces the theoretical basis of this subject, including digital communication,the composition of digital baseband transmission system and digital baseband signal transmission process. Then thepaper introduced the characteristics of digital baseband transmission system, including digital PAM signal powerdensity and common line pattern, and by comparing choosing the fi nal bipolar zero return code. Then we introducedthe MATLAB simulation software. The conditions of the best reception of the digital baseband signal are describedand how the waveform of the baseband signal is observed by an oscilloscope. Finally, according to the basic stepsof simulation process, the simulation process of digital baseband transmission system is realized by MATLABsimulation tool, and the system is analyzed.

Power Plant Station Protection System against Voltage Fluctuation

2015 ◽  
Vol 793 ◽  
pp. 65-69 ◽  
Author(s):  
Abadal Salam T. Hussain ◽  
Waleed A. Oraibi ◽  
Fadhel A. Jumaa ◽  
F. Malek ◽  
Syed F. Ahmed ◽  
...  
Keyword(s):  
Power Plant ◽  
Power System ◽  
Short Circuit ◽  
Electrical Power ◽  
Circuit Breaker ◽  
Digital Signal ◽  
Short Circuit Current ◽  
Electrical Power System ◽  
System Protection ◽  
Protective Relay

Electrical Power System protection is required to protectboth the user and the system equipment itself fromany fault, hence electrical power system is not allowed to operate without any protection devices installed. Power System fault is defined as the undesirable condition that occurs in the power system. Some of these undesirable conditions are short circuit, current leakage, ground faultand over-under voltage. With the increasing loads, voltages and short-circuit duty in power plant, over voltage protection has become more important today. Here, the component that had been used is PIC 16F877a microcontroller to control the whole system and especially on the circuit breakers as well as the LCT display unit is used to display the voltage level and type of generator that used to serve the load. Sensors are used to measure both thevoltage and the load. The controlled digital signal from PIC microcontroller is converted by using the digital analog converter to control the whole circuit. Thus a device called protective relay is created to meet this requirement. The protective relay is mostlyoften coupled with circuit breaker in a way that it can isolate the abnormal condition in the system.

Digital Signal Transmission on Power Line Carrier Channels: An Introduction

1987 ◽  
Vol 2 (1) ◽  
pp. 50-56 ◽  
Author(s):  
P. Burrascano ◽  
S. Cristina ◽  
M. D'Amore ◽  
M. Salerno
Keyword(s):  
Signal Transmission ◽  
Digital Signal ◽  
Power Line ◽  
Power Line Carrier
Sign in / Sign up

Export Citation Format

Share Document