scholarly journals Gas–liquid mass transfer using advanced optical probe in a mimicked FT slurry bubble column

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Lu Han ◽  
Premkumar Kamalanathan ◽  
Muthanna H. Al-Dahhan
Keyword(s):  
Mass Transfer ◽  
Transfer Coefficient ◽  
Mass Transfer Coefficient ◽  
Bubble Column ◽  
Operating Pressure ◽  
Gas Velocity ◽  
Liquid Phase Mass Transfer ◽  
Solids Loading ◽  
Superficial Gas Velocity ◽  
Reactor Models

AbstractGas-liquid volumetric liquid-phase mass transfer coefficient (kLa) was studied in a slurry bubble column at the conditions mimicking Fischer–Tropsch synthesis. To avoid the hydrodynamic disturbances due to the gas switching, oxygen enriched air dynamic absorption method was used. Influence of reactor models (CSTR, ADM and RCFD) on the volumetric mass transfer coefficient was investigated. Effect of operating pressure, superficial gas velocity and solids loading were investigated. From the reactor models investigated, it is recommended to use ADM model for kLa study. If the CSTR model is used, applicability of the model should be checked. With increase in the superficial gas velocity and operating pressure, volumetric liquid-phase mass transfer coefficient increases, while it decreases with the solids loading corroborating with the literature.

scholarly journals Hydrodynamics and Mass Transfer in a Concentric Internal Jet-Loop Airlift Bioreactor Equipped with a Deflector

Energies ◽  
2021 ◽  
Vol 14 (14) ◽  
pp. 4329
Author(s):  
Radek Šulc ◽  
Jan Dymák
Keyword(s):  
Mass Transfer ◽  
Transfer Coefficient ◽  
Mass Transfer Coefficient ◽  
Liquid System ◽  
Gas Holdup ◽  
Gas Velocity ◽  
Liquid Phase Mass Transfer ◽  
Homogenization Time ◽  
Standard Design ◽  
Superficial Gas Velocity

The gas–liquid hydrodynamics and mass transfer were studied in a concentric tube internal jet-loop airlift reactor with a conical bottom. Comparing with a standard design, the gas separator was equipped with an adjustable deflector placed above the riser. The effect of riser superficial gas velocity uSGR on the total gas holdup εGT, homogenization time tH, and overall volumetric liquid-phase mass transfer coefficient kLa was investigated in a laboratory bioreactor, of 300 mm in inner diameter, in a two-phase air–water system and three-phase air–water–PVC–particle system with the volumetric solid fraction of 1% for various deflector clearances. The airlift was operated in the range of riser superficial gas velocity from 0.011 to 0.045 m/s. For the gas–liquid system, when reducing the deflector clearance, the total gas holdup decreased, the homogenization time increased twice compared to the highest deflector clearance tested, and the overall volumetric mass transfer coefficient slightly increased by 10–17%. The presence of a solid phase shortened the homogenization time, especially for lower uSGR and deflector clearance, and reduced the mass transfer coefficient by 15–35%. Compared to the gas–liquid system, the noticeable effect of deflector clearance was found for the kLa coefficient, which was found approx. 20–29% higher for the lowest tested deflector clearance.

Effect of Vibrating Sparger on Mass Transfer, Gas Holdup, and Bubble Size in a Bubble Column Reactor

2013 ◽  
Vol 11 (1) ◽  
pp. 47-56 ◽  
Author(s):  
Laleh Hadavand ◽  
Ali Fadavi
Keyword(s):  
Mass Transfer ◽  
Transfer Coefficient ◽  
Mass Transfer Coefficient ◽  
Vibration Frequency ◽  
Bubble Size ◽  
Bubble Column ◽  
Gas Holdup ◽  
Bubble Column Reactor ◽  
Gas Velocity ◽  
Superficial Gas Velocity

Abstract Bubble size has a key role in gas holdup and mass transfer in bubble column reactors. In order to have small and uniform bubbles, a new structure was designed; the reactor operates in two modes, with vibrating sparger and conventional bubble column in which sparger is fixed. In vibrating mode, the sparger vibrates gently during gas entering. The vibrating sparger performs like a paddle, resulting in a forced recirculation of gas–liquid inside the reactor; moreover, the bubble detachment is accelerated. The superficial gas velocity was between 0.003 and 0.013 ms− 1, and the vibration frequency was changed between 0 and 10.3 Hz. The bubble size was measured at three various positions of the reactor height by photographic method and using MATLAB 7.0.1 software. The mass transfer coefficient was determined by means of the dynamic gassing-out method. The results show that the bubbles were bigger in vibrating mode than those working without vibration. The bubble size decreases with increase in height from sparger. Gas holdup increased with increase in superficial gas velocity and vibration frequency. The effect of vibration increased the gas holdup with an average of 70% for all superficial gas velocities. Volumetric mass transfer coefficient was almost stable as vibration frequency increased.

Influence of Particles and Electrolyte on Gas Hold-Up and Mass Transfer in a Slurry Bubble Column

2006 ◽  
Vol 4 (1) ◽  
Author(s):  
Keshav C Ruthiya ◽  
John van der Schaaf ◽  
Ben F.M. Kuster ◽  
Jaap C Schouten
Keyword(s):  
Mass Transfer ◽  
Transfer Coefficient ◽  
Mass Transfer Coefficient ◽  
Bubble Column ◽  
Bubble Diameter ◽  
Interfacial Area ◽  
Large Bubble ◽  
Volumetric Mass Transfer Coefficient ◽  
Gas Velocity ◽  
Slurry Concentration

In this paper, the influence of carbon and silica particle slurry concentration up to 20 g/l (4 vol%) on regime transition, gas hold-up, and volumetric mass transfer coefficient is studied in a 2-dimensional slurry bubble column. From high speed video image analysis, the average large bubble diameter, the frequency of occurrence of large bubbles, the gas-liquid interfacial area, and the large bubble hold-up are obtained. The liquid side mass transfer coefficient is calculated from the volumetric mass transfer coefficient and the gas-liquid interfacial area. The lyophilic silica particles are rendered lyophobic by a methylation process to study the influence of particle wettability. The influence of organic electrolyte (sodium gluconate) and the combination of electrolyte and particles is also studied. It is found that lyophilic silica, lyophobic silica, and lyophobic carbon particles at concentrations larger than 2 g/l (0.4 vol%) decrease the gas hold-up and shift the regime transition point (where the first large bubbles appear) to a lower gas velocity. The volumetric mass transfer coefficient increases with gas velocity, increases with electrolyte concentration, decreases with slurry concentration, and is higher for lyophobic particles. The liquid side mass transfer coefficient increases with gas velocity, bubble diameter, and is higher for lyophobic particles. A correlation for the mass transfer coefficient based on dimensionless numbers is proposed for the heterogeneous regime.

Experimental and Computational Studies of Aerated Stirred Tank with Dual Impeller

2020 ◽  
Vol 18 (3) ◽  
Author(s):  
Shivanand M. Teli ◽  
Viraj S. Pawar ◽  
Channamallikarjun Mathpati
Keyword(s):  
Mass Transfer ◽  
Transfer Coefficient ◽  
Mass Transfer Coefficient ◽  
Large Scale ◽  
Interfacial Area ◽  
Gas Velocity ◽  
Stirred Tanks ◽  
Mixing Performance ◽  
Liquid Systems ◽  
Superficial Gas Velocity

AbstractStirred tanks are commonly used in chemical and allied industries for reaction and separation. In order to improve the mixing performance, large scale reactors are often equipped with multiple impellers. In the case of gas-liquid systems, the gas hold-up, mass transfer coefficient, and interfacial area strongly depend on the size and type of impellers, clearance between impellers and superficial gas velocity. In the present work, the effect of the impeller speed, superficial gas velocity, and top impeller position has been investigated on gas hold-up, interfacial area, and mass transfer coefficient. Computational fluid dynamics have been carried out for the multiphase multi-impeller system and the model predictions have been compared with the experimental data.

Sign in / Sign up

Export Citation Format

Share Document