The Role of Transport Code Verification and Validation Studies in Licensing Nuclear Waste Repositories in the FR of Germany

1988 ◽  
Vol 44-45 (2) ◽  
Author(s):  
P. BOGORINSKI ◽  
B. BALTES ◽  
J. LARUE ◽  
K.-H. MARTENS
1984 ◽  
Vol 44 ◽  
Author(s):  
Bryan J. Travis ◽  
H. E. Nuttall

AbstractRecently, there is increased concern that radiocolloids may act as a rapid transport mechanism for the release of radionuclides from high-level waste repositories. The role of colloids is, however, controversial because the necessary data and assessment methodology have been limited. To quantitatively assess the role of colloids, the TRACR3D transport code has been enhanced by the addition of the population balance equations. The code was tested against the experimental laboratory column data of Avogadro et al. Next a low-level radioactive waste site was investigated to explore whether colloid migration could account for the unusually rapid transport of plutonium and americium observed. The nature and modeling of radiocolloids are discussed along with site simulation results from the TRACR3D code.


2012 ◽  
Vol 57 (4) ◽  
pp. 951-974 ◽  
Author(s):  
Andrzej Nowakowski ◽  
Mariusz Młynarczuk

Abstract Temperature is one of the basic factors influencing physical and structural properties of rocks. A quantitative and qualitative description of this influence becomes essential in underground construction and, in particular, in the construction of various underground storage facilities, including nuclear waste repositories. The present paper discusses the effects of temperature changes on selected mechanical and structural parameters of the Strzelin granites. Its authors focused on analyzing the changes of granite properties that accompany rapid temperature changes, for temperatures lower than 573ºC, which is the value at which the β - α phase transition in quartz occurs. Some of the criteria for selecting the temperature range were the results of measurements carried out at nuclear waste repositories. It was demonstrated that, as a result of the adopted procedure of heating and cooling of samples, the examined rock starts to reveal measurable structural changes, which, in turn, induces vital changes of its selected mechanical properties. In particular, it was shown that one of the quantities describing the structure of the rock - namely, the fracture network - grew significantly. As a consequence, vital changes could be observed in the following physical quantities characterizing the rock: primary wave velocity (vp), permeability coefficient (k), total porosity (n) and fracture porosity (η), limit of compressive strength (Rσ1) and the accompanying deformation (Rε1), Young’s modulus (E), and Poisson’s ratio (ν).


1983 ◽  
Vol 26 ◽  
Author(s):  
A. Avogadro ◽  
G.De Marsily

ABSTRACTAspects of formation and characterization of a radioactive colloidal fraction released by the waste form or produced by association with microcolloids naturally existing in ground water or produced either by corrosion of container material or by degradation of backfill material are discussed. A filtration model has been developed in order to describe colloidal transport under field conditions. Comparison between data obtained with laboratory column experiments and theoretical evaluations is presented.


2000 ◽  
Vol 88 (9-11) ◽  
Author(s):  
M. Rovira ◽  
F.Z. El Aamrani ◽  
L. Duro ◽  
Ignasi Casas ◽  
Joan de Pablo ◽  
...  

The Lovasjärvi intrusion (SE-Finland) contents a high percentage of ferrous olivine (> 65%). This material has been suggested as a redox-active backfill-additive in deep nuclear waste repositories, due to the large Fe(II) proportion in its mineral composition. In order to understand the processes involved in the redox buffering capacity of this material the transport of uranium (VI) through olivine columns was studied. The results showed considerable retardation factor for the U(VI), particularly in carbonate-free media. The experimental data were simulated by means of reactive transport modeling. The best agreement between the experimental and calculated data was obtained considering that the interaction of U(VI) with the olivine surface occurred at two different types of sorption sites. One type accounts for the sorption capacity of the olivine mineral, and a second type accounts for the sorption on amorphous Fe(OH)


2011 ◽  
Vol 2 (4) ◽  
pp. 343-353 ◽  
Author(s):  
Nathan J. Cassingham ◽  
Martin C. Stennett ◽  
Paul A. Bingham ◽  
Neil C. Hyatt ◽  
Giuliana Aquilanti

Sign in / Sign up

Export Citation Format

Share Document