On the intensity distribution within Debye-Scherrer rings. What is different in high pressure experiments? Part II: Practical application

2009 ◽  
Vol 2009 (30) ◽  
pp. 147-153 ◽  
Author(s):  
B. Hinrichsen ◽  
R. E. Dinnebier ◽  
M. Jansen
2012 ◽  
Vol 518-523 ◽  
pp. 2376-2379
Author(s):  
Shao Cheng Ge ◽  
Zhen Quan ◽  
De Ji Jing

It concerns about escaped dust issues of Inner Mongolia Datang International Xilinhaote Mining CO, LTD.M102. M103. M106 among three belt drive. It will reform and design for dust comprehensive pollution control in belt drive, introduce practical application of High-pressure micro fog dedusting system in belt drive and capture dust particulate effectively in order to make dust fall in the beginning of producing dust by investigation on the site, current specific situation, local climate and water resource.


2018 ◽  
Vol 51 (3) ◽  
pp. 432-446
Author(s):  
HY Wu ◽  
HB Cheng ◽  
YP Feng ◽  
X Chen

To eliminate axial misalignment-induced measurement errors of discrete light-emitting diode arrays in the far-field condition, a robust and effective method for correcting the measured luminous intensity distribution is proposed. The precision of the correction can be determined beforehand by setting a criterion which can also be used to determine the required test distance. To validate the feasibility and practicability of the proposed approach, numerical simulations of light-emitting diode arrays with three kinds of typical luminous intensity distributions were performed. In addition, the test distances as a function of the light-emitting diode luminous intensity distribution, packing density and dimensions under translational misalignment were analysed. Some beneficial operating methods and rules for practical application are summarised. Finally, physical measurements of several experimental examples were collected. The correction results agreed with the desired data and again proved the utility of the presented method.


1967 ◽  
Vol 89 (3) ◽  
pp. 369-375 ◽  
Author(s):  
I. Berman ◽  
D. H. Pai

Two new processes of cylinder autofrettage (prestress) have been analyzed and compared to the standard high pressure autofrettage. By means of a highly improved stress intensity distribution at design pressure, it was shown that a significant increase in allowable pressure and a reduction of autofrettage pressure may be achieved by the new processes.


2009 ◽  
Vol 106 (4) ◽  
pp. 1453-1458 ◽  
Author(s):  
R. Arieli ◽  
E. Boaron ◽  
A. Abramovich

We previously hypothesized that the number of bubbles emerging on decompression from a dive, and the resultant risk of decompression sickness (DCS), may be reduced by a process whereby effective gas micronuclei that might otherwise have formed bubbles on decompression are shrunk and eliminated. In a procedure defined by us as denucleation, exposure to hyperbaric oxygen (HBO) would result in oxygen replacing the resident gas in the micronuclei, to be subsequently consumed by the mitochondria when the oxygen pressure is reduced. Support for the validity of our hypothesis may be found in our previous studies on the transparent prawn and the reduction of DCS in the rat. In all of these studies, HBO pretreatment was given before supersaturation with inert gas at high pressure. The purpose of the present study was to compare DCS outcome in rats that underwent nitrogen washout (denitrogenation) alone (9 min O2 at 507 kPa) after exposure to air at high pressure (33 min at 1,266 kPa), and rats treated by both procedures (denitrogenation + denucleation; 8 min of O2 breathing followed by 5 min air breathing, both at 507 kPa) after high-pressure air exposure. This was done with the same nitrogen load in both groups before the final decompression (a nitrogen pressure of 467 kPa in fatty and 488 kPa in aqueous tissue). Six of 20 rats in the denitrogenation + denucleation group died, compared with 13 in the denitrogenation group ( P < 0.03). Three rats in the denitrogenation + denucleation group suffered mild DCS, recovering completely within 2 h of decompression. The present study indicates an advantage in considering both denitrogenation and denucleation before decompression. This may have practical application before escape from a disabled submarine, when aborting a technical dive, or in the preparation of aviators for high altitude.


1991 ◽  
Author(s):  
I. Tsuji ◽  
S. Aoki ◽  
S. Miyazaki ◽  
Y. Hara ◽  
Y. Furuse ◽  
...  

The development of uncooled ceramic vanes for a 20MW class gas turbine with the firing temperature of 1300°C is progressing. The 1st stage ceramic vanes were made of sintered SiC or sintered Si3N4, and the 2nd stage ceramic vanes were made of sintered Si3N4. These vanes were tested by means of hot and high pressure cascade testing simulating actual gas turbines operation. After minor modifications, we have succeeded in developing sound ceramic vanes which are durable against high thermal stress which occurs during the transient of trip (emergency shutdowns or fuel tripouts), and obtained great results for the practical application. In this paper, details of the ceramic vanes’ structure and cascade testing are described and the results of the tests are discussed.


Sign in / Sign up

Export Citation Format

Share Document