The cost and availability of rare earth-based corrosion inhibitors

Author(s):  
A.E. Hughes ◽  
J.M.C. Mol ◽  
I.S. Cole
Minerals ◽  
2020 ◽  
Vol 10 (6) ◽  
pp. 495
Author(s):  
Shang Liu ◽  
Lin Ding ◽  
Hong-Rui Fan

Hydrothermal processes have played a significant role in rare earth element (REE) precipitation in the Bayan Obo REE-Nb-Fe deposit. The poor preservation of primary fluid inclusions and superposition or modification by multiphase hydrothermal activities have made identification of physico-chemical conditions of ore-forming fluids extremely difficult. Fortunately, with more and more reliable thermodynamic properties of aqueous REE species and REE minerals reported in recent years, a series of thermodynamic calculations are conducted in this study to provide constraints on REE precipitation in hydrothermal solutions, and provide an explanation of typical paragenesis of REE and gangue minerals at Bayan Obo. During the competition between fluocerite and monazite for LREE in the modelled solution (0.1 M HCl, 0.1 M HF and 0.1 M trichloride of light rare earth elements (LREE) from La to Sm), all LREE would eventually be hosted by monazite at a temperature over 300 °C, with continuous introduction of H3PO4. Additionally, monazite of heavier LREE would precipitate earlier, indicating that the Ce- and La-enriched monazite at Bayan Obo was crystallized from Ce and La pre-enriched hydrothermal fluids. The fractionation among LREE occurred before the ore-forming fluids infiltrating ore-hosting dolomite. When CO2 (aq) was introduced to the aqueous system (model 1), bastnaesite would eventually and completely replace monazite-(Ce). Cooling of hot hydrothermal fluids (>400 °C) would significantly promote this replacement, with only about one third the cost of CO2 for the entire replacement when temperature dropped from 430 °C to 400 °C. Sole dolomite addition (model 2) would make bastnaesite replace monazite and then be replaced by parisite. The monazite-(Ce) replaced by associated bastnaesite and apatite is an indicator of very hot hydrothermal fluids (>400 °C) and specific dolomite/fluid ratios (e.g., initial dolomite at 1 kbar: 0.049–0.068 M and 0.083–0.105 M at 400 °C and 430 °C). In hot solution (>430 °C) that continuously interacts with dolomite, apatite precipitates predating the bastnaesite, but it behaves oppositely at <400 °C. The former paragenesis is in accord with petrography observed in this study. Some mineral pairs, such as monazite-(Ce)-fluorite and monazite-(Ce)-parisite would never co-precipitate at any calculated temperature or pressure. Therefore, their association implies multiphase hydrothermal activities. Pressure variation would have rather limited influence on the paragenesis of REE minerals. However, temperature and fluid composition variation (e.g., CO2 (aq), dolomite, H3PO4) would cause significantly different associations between REE and gangue minerals.


CORROSION ◽  
2002 ◽  
Vol 58 (11) ◽  
pp. 953-960 ◽  
Author(s):  
M. Forsyth ◽  
K. Wilson ◽  
T. Behrsing ◽  
C. Forsyth ◽  
G. B. Deacon ◽  
...  

Author(s):  
T. Markley ◽  
F. Blin ◽  
M. Forsyth ◽  
B. Hinton

2020 ◽  
Vol 55 (4) ◽  
pp. 311-321 ◽  
Author(s):  
A. E. Somers ◽  
Y. Peng ◽  
A. L. Chong ◽  
M. Forsyth ◽  
D. R. MacFarlane ◽  
...  

2014 ◽  
Vol 161 (12) ◽  
pp. C527-C534 ◽  
Author(s):  
Nguyen Dang Nam ◽  
Motilal Mathesh ◽  
Bruce Hinton ◽  
Mike J. Y. Tan ◽  
Maria Forsyth

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Jimin Lee ◽  
Eun Jae Lee ◽  
Tae-Yeon Hwang ◽  
Jongryoul Kim ◽  
Yong-Ho Choa

Abstract Recent studies on next-generation permanent magnets have focused on filling in the gap between rare-earth magnets and rare-earth-free magnets, taking into account both the cost-effectiveness and magnetic performance of the magnetic materials. As an improved rare-earth-free magnet candidate, here, Ca-substituted M-type Sr-lean hexaferrite particles within a nano- to micro-scale regime, produced using an ultrasonic spray pyrolysis method, are investigated. Theoretically, the maximum coercivity (Hc) can be achieved in submicron Sr-ferrite crystals (i.e., 0.89 μm). The plate-like resultants showed a significant enhancement in Hc, up to a record high of 7880.4 Oe, with no deterioration in magnetization (M: 71–72 emu/g). This resulted in more favorable magnetic properties than those of the traditional Sr–La–Co ferrites. On the basis of microstructural analysis and fitting results based on the law of approach to saturation method, the Ca-substitution effects on the change in size and anisotropic characteristics of the ferrite particles, including pronounced lateral crystal growth and a strong increase in magnetocrystalline anisotropy, are clearly demonstrated. The cost-effective, submicron, and Ca-substituted Sr-ferrite is an excellent potential magnet and moreover may overcome the limitations of traditional hard magnetic materials.


2008 ◽  
Vol 55 (3) ◽  
pp. 135-143 ◽  
Author(s):  
A. Amadeh ◽  
S.R. Allahkaram ◽  
S.R. Hosseini ◽  
H. Moradi ◽  
A. Abdolhosseini

Sign in / Sign up

Export Citation Format

Share Document