2.2kW Single-Phase Passive Voltage Doubler Rectifier for North American Use that Meets IEEE Std. 519

2019 ◽  
Vol 139 (1) ◽  
pp. 102-103
Author(s):  
Kan Terazawa ◽  
Yuki Oku ◽  
Shin-ichi Motegi ◽  
Yasuyuki Nishida
2001 ◽  
Vol 121 (9) ◽  
pp. 964-970 ◽  
Author(s):  
Hirofumi Kiyotake ◽  
Hidehiko Okada ◽  
Kouichi Ishizaka ◽  
Ryozo Itoh

1998 ◽  
Vol 118 (4) ◽  
pp. 552-553
Author(s):  
Hirofumi Kiyotake ◽  
Hidehiko Okada ◽  
Kouichi Ishizaka ◽  
Ryozo Itoh

1995 ◽  
Vol 115 (6) ◽  
pp. 814-815
Author(s):  
Hayato Oishi ◽  
Hidehiko Okada ◽  
Kouichi Ishizaka ◽  
Ryozo Itoh

2012 ◽  
Vol 12 (4) ◽  
pp. 623-631 ◽  
Author(s):  
Young-Hoon Cho ◽  
Hyung-Soo Mok ◽  
Jun-Keun Ji ◽  
Jih-Sheng Lai

Author(s):  
Dae-Kwan Ku ◽  
Jun-Keun Ji ◽  
Guee-Soo Cha ◽  
Seung-Beom Lim ◽  
Soon-Chan Hong

1995 ◽  
Vol 05 (04) ◽  
pp. 777-788
Author(s):  
J. RODRÍGUEZ ◽  
A. SUÁREZ ◽  
J. HERNÁNDEZ ◽  
H. ANDRADE ◽  
E. WIECHMANN

This paper presents the use of a single-phase voltage-doubler Boost rectifier, to generate a controlled DC voltage, which is applied to a four-quadrant chopper. The transistor chopper controls the speed of a separately excited DC machine. The Boost rectifier permits the regeneration of energy from the motor to the single-phase mains, maintaining in all operating points a practically sinusoidal input current, with a THD of 2.5%. The balancing of the two filter capacitors is achieved by using and additional control loop. A low cost microcontroller is used to control the DC voltage and the motor speed.


2009 ◽  
Vol 57 (4) ◽  
pp. 355-361 ◽  
Author(s):  
Y. Jiang ◽  
J. Pan

Single phase full bridge inverter with coupled filter inductors and voltage doubler for PV module integrated converter systemThis paper presents a single phase full bridge inverter with coupled filter inductors and voltage doubler for PV module integrated converter (MIC) system. In DC/DC stage, full bridge circuit with high frequency sinusoidal pulse width modulation control is used, and high frequency transformer with voltage doubler rectifier circuit to increase conversional ratio is adopted. Finally, at the conversion end the rectified sinusoidal waveforms is generated. The coupled filter inductors, which are placed in voltage doubler, not only reduce circulating current, which increases efficiency but also make the rectified output sinusoidal waveforms of DC/DC stage as smooth voltage source. In DC/AC stage, the full bridge circuit with line frequency square wave control is adopted to reduce switching losses and control cost. To verify the presented analysis a 100 W prototype single phase 220 VAC 50 Hz inverter output has been constructed and the experimental results are given.


Sign in / Sign up

Export Citation Format

Share Document