Thermoelectric Properties and Magnetic Anisotropies of Magnetically Grain-Oriented Sr- or Bi-doped Ca3Co4O9 Thick Films

2007 ◽  
Vol 1044 ◽  
Author(s):  
Shigeru Horii ◽  
Yuhya Yamasaki ◽  
Masayuki Sakurai ◽  
Ryoji Funahashi ◽  
Tetsuo Uchikoshi ◽  
...  

AbstractWe report magnetic properties of [Ca2CoO3-δ]0.62CoO2 (Ca349) powders with various average size and the Bi- and Sr-doping effects on thermoelectric properties for the magnetically grain-aligned and densified Ca349 thick films. Magnetic anisotropy at 300 K depended on the initial average size of Ca349 powders and decreased with the decrease in the size. This presumably suggests that distortion of crystal structure was induced by a ball-milling process and led to the change of magnetic anisotropy. On the Bi- and Sr-doping effects, an obvious enhancement of thermoelectric properties did not emerge in the case of the Sr-doping, whereas the enhancement was observed for the Bi-doped Ca349 thick films. However, a drastic decrease of magnetic anisotropy was caused by the Bi-doping. For usage of the p-type layer in multilayered thermoelectric module, tuning of the Bi-doping levels in which both enhancement of thermoelectric properties and a certain level of magnetic anisotropy are achieved is required.

Electronics ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 140
Author(s):  
Lichen Liu ◽  
Ziping Cao ◽  
Min Chen ◽  
Jun Jiang

This paper reports the fabrication and characterization of (Bi0.48Sb1.52)Te3 thick films using a tape casting process on glass substrates. A slurry of thermoelectric (Bi0.48Sb1.52)Te3 was developed and cured thick films were annealed in a vacuum chamber at 500–600 °C. The microstructure of these films was analyzed, and the Seebeck coefficient and electric conductivity were tested. It was found that the subsequent annealing process must be carefully designed to achieve good thermoelectric properties of these samples. Conductive films were obtained after annealing and led to acceptable thermoelectric performance. While the properties of these initial materials are not at the level of bulk materials, this work demonstrates that the low-cost tape casting technology is promising for fabricating thermoelectric modules for energy conversion.


2015 ◽  
Vol 628 ◽  
pp. 347-351 ◽  
Author(s):  
Rezaul Kabir ◽  
Ruoming Tian ◽  
Tianshu Zhang ◽  
Richard Donelson ◽  
Thiam Teck Tan ◽  
...  

2017 ◽  
Vol 17 (5) ◽  
pp. 744-750 ◽  
Author(s):  
So-Hyun Kang ◽  
Venkatraju Jella ◽  
S.V.N. Pammi ◽  
Ji-Ho Eom ◽  
Jin-Seok Choi ◽  
...  

Nanomaterials ◽  
2018 ◽  
Vol 8 (7) ◽  
pp. 474 ◽  
Author(s):  
Baoli Du ◽  
Ming Liu ◽  
Jian Xu ◽  
Baofu Hu ◽  
Bingguo Liu ◽  
...  

2017 ◽  
Vol 4 (5) ◽  
pp. 6289-6295 ◽  
Author(s):  
Supasit Paengson ◽  
Panida Pilasuta ◽  
Kunchit Singsoog ◽  
Wanatchaporn Namhongsa ◽  
Wairut Impho ◽  
...  

2017 ◽  
Vol 4 (9) ◽  
pp. 1458-1464 ◽  
Author(s):  
M.-Y. Lee ◽  
D. I. Bilc ◽  
E. Symeou ◽  
Y.-C. Lin ◽  
I.-C. Liang ◽  
...  

A new p-type semiconductor Ba3Ag3InTe6 with transport properties dominated by the layer [Ag3Te4]5− distributed in the valence band.


2009 ◽  
Vol 57 (17) ◽  
pp. 5036-5045 ◽  
Author(s):  
Norihiko L. Okamoto ◽  
Tatsuya Koyama ◽  
Kyosuke Kishida ◽  
Katsushi Tanaka ◽  
Haruyuki Inui

2015 ◽  
Vol 91 (23) ◽  
Author(s):  
K. Yoshida ◽  
R. Okubo ◽  
H. Tanida ◽  
T. Matsumura ◽  
M. Sera ◽  
...  

2021 ◽  
pp. 103061
Author(s):  
Mohammed Alaa Bousahla ◽  
Muhammad Faizan ◽  
Taieb Seddik ◽  
Saad Bin Omran ◽  
Houari Khachai ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document