Recombination and Resistive Losses in Amorphous Silicon / Crystalline Silicon Heterojunction Solar Cells

2000 ◽  
Vol 609 ◽  
Author(s):  
Nils Jensen ◽  
Uwe Rau ◽  
Jürgen H. Werner
Keyword(s):  
Solar Cells ◽  
Carrier Transport ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Crystalline Silicon ◽  
Internal Quantum Efficiency ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Absorber Material

ABSTRACTThis contribution investigates the electronic properties of a-Si:H/c-Si solar cells and explains their electrical output parameters open circuit voltage, short circuit current, and fill factor. Our device analysis is based on measurements of the internal quantum efficiency, of current/voltage and capacitance/voltage curves. We find carrier recombination within the crystalline silicon absorber material to be responsible for the limitation of the open circuit voltage. The short circuit current is restricted by collection losses in the absorber material and by absorption in the electrically inactive a-Si:H emitter. Resistive losses affecting the fill factor originate from the transport of minority carriers across the interface. The I/V curves measured at low temperatures reveal a characteristic S-shaped behavior. This effect increases with decrasing temperature and stems from the minority carrier transport, which is hindered by the band offset between a-Si:H and c-Si. We propose a new analytical model to describe this anomalous behavior.

Simulation of InAIN/Si Single-Heterojunction Solar Cells Using wxAMPS

2014 ◽  
Vol 665 ◽  
pp. 111-114 ◽  
Author(s):  
Ying Huang ◽  
Xiao Ming Shen ◽  
Xiao Feng Wei
Keyword(s):  
Solar Cells ◽  
Fill Factor ◽  
High Efficiency ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Indium Content ◽  
Open Circuit ◽  
Heterojunction Solar Cells ◽  
Si Solar Cells

In this paper, InAlN/Si single-heterojunction solar cells have been theoretically simulated based on wxAMPS software. The photovoltaic parameters, such as open circuit voltage, short circuit current, fill factor and conversion efficiency were investigated with changing the indium content and thickness of n-InAlN layer. Simulation results show that the optimum efficiency of InAlN/Si solar cells is 23.1% under AM 1.5G spectral illuminations, with the indium content and thickness of n-InAlN layer are 0.65 and 600nm, respectively. The simulation would contribute to design and fabricate high efficiency InAlN/Si solar cells in experiment.

scholarly journals Features of model thin-film solar cells photoelectric characteristics based on a non-toxic multi-component connection CuZn2AlS4

2021 ◽  
Vol 5 (3) ◽  
pp. 242-250
Author(s):  
D. Sergeyev ◽  
K. Shunkeyev ◽  
B. Kuatov ◽  
N. Zhanturina
Keyword(s):  
Thin Film ◽  
Solar Cells ◽  
Quantum Efficiency ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Thin Film Solar Cells ◽  
Current Voltage

In this paper, the features of the characteristics of model thin-film solar cells based on the non-toxic multicomponent compound CuZn2AlS4 (CZAS) are considered. The main parameters (open-circuit voltage, short-circuit current, fill factor, efficiency) and characteristics (quantum efficiency, current-voltage characteristic) of thin-film solar cells based on CZAS have been determined. The minimum optimal thickness of the CZAS absorber is found (1-1.25 microns). Deterioration of the performance of solar cells with an increase in operating temperature (280-400 K) is shown. It is revealed that in the wavelength range of 390-500 nm CZAS has a high external quantum efficiency, which allows its use in designs of multi-junction solar cells designed to absorb solar radiation in the specified range. It is shown that the combination of CZAS films with a buffer layer of non-toxic ZnS increases the performance of solar cells.

Simultaneous Enhancement of Open-Circuit Voltage, Short-Circuit Current Density, and Fill Factor in Polymer Solar Cells

2011 ◽  
Vol 23 (40) ◽  
pp. 4636-4643 ◽  
Author(s):  
Zhicai He ◽  
Chengmei Zhong ◽  
Xun Huang ◽  
Wai-Yeung Wong ◽  
Hongbin Wu ◽  
...  
Keyword(s):  
Solar Cells ◽  
Current Density ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Polymer Solar Cells ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit

scholarly journals Damp-Heat Induced Performance Degradation for InGaP/GaAs/Ge Triple-Junction Solar Cell

2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Hwen-Fen Hong ◽  
Tsung-Shiew Huang ◽  
Wu-Yih Uen ◽  
Yen-Yeh Chen
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Conversion Efficiency ◽  
Triple Junction ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Energy Conversion Efficiency ◽  
Open Circuit

We performed accelerated tests on sealed and nonsealed InGaP/InGaAs/Ge triple-junction (TJ) solar cells in a complex high temperature and high humidity environment and investigated the electrical properties over time. The degradation of energy conversion efficiency in nonsealed cells was found to be more serious than that in sealed cells. The short-circuit current (ISC), open-circuit voltage (VOC), and fill factor (FF) of sealed cells changed very slightly, though the conversion efficiency decreased 3.6% over 500 h of exposure. This decrease of conversion efficiency was suggested to be due to the deterioration of silicone encapsulant. TheISC,VOC, and FF of nonsealed cells decreased with increasing exposure time. By EL and SEM analysis, the root causes of degradation can be attributed to the damage and cracks near the edge of cells induced by the moisture ingress. It resulted in shunt paths that lead to a deterioration of the conversion efficiency of solar cell by increasing the leakage current, as well as decreasing open-circuit voltage and fill factor of nonsealed solar cells.

Simultaneous improvement of three parameters using a binary processing solvent system approach in as-cast non-fullerene solar cells

2019 ◽  
Vol 7 (45) ◽  
pp. 25978-25984 ◽  
Author(s):  
Guoming Qin ◽  
Lianjie Zhang ◽  
Dong Yuan ◽  
Haiying Jiang ◽  
Wei Tang ◽  
...  
Keyword(s):  
Solar Cells ◽  
System Approach ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Photovoltaic Performance ◽  
Short Circuit Current ◽  
Solvent System ◽  
Open Circuit ◽  
Binary Solvent

A binary solvent approach simultaneously improves the open-circuit voltage, short-circuit current, and fill factor, and finally elevates the as-cast photovoltaic performance.

Simultaneous Improvement in Short Circuit Current, Open Circuit Voltage, and Fill Factor of Polymer Solar Cells through Ternary Strategy

2015 ◽  
Vol 7 (6) ◽  
pp. 3691-3698 ◽  
Author(s):  
Qiaoshi An ◽  
Fujun Zhang ◽  
Lingliang Li ◽  
Jian Wang ◽  
Qianqian Sun ◽  
...  
Keyword(s):  
Solar Cells ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Polymer Solar Cells ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit

Nanostructure Control of Si and Ge Quantum Dots Based Solar Cells Using Plasma Processes

2014 ◽  
Vol 783-786 ◽  
pp. 2022-2027 ◽  
Author(s):  
Masaharu Shiratani ◽  
Giichiro Uchida ◽  
Hyun Woong Seo ◽  
Daiki Ichida ◽  
Kazunori Koga ◽  
...  
Keyword(s):  
Solar Cells ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Electrical Power ◽  
Chemical Vapor ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Si Nanoparticles ◽  
Sensitized Solar Cells

We report characteristics of quantum dot (QD) sensitized solar cells using Si nanoparticles and Ge nanoparticles. Si nanoparticles were synthesized by multi-hollow discharge plasma chemical vapor deposition, whereas Ge nanoparticles were done by a radio frequency magnetron sputtering using Ar+H2under high pressure conditions. The electrical power generation from Si QDs and Ge QDs was confirmed. Si QD sensitized solar cells show an efficiency of 0.024%, fill factor of 0.32, short-circuit current of 0.75 mA/cm2and open-circuit voltage of 0.10 V, while Ge QD sensitized solar cells show an efficiency of 0.036%, fill factor of 0.38, short-circuit current of 0.64 mA/cm2and open-circuit voltage of 0.15 V.

scholarly journals The absorber and buffer layer thicknesses for CdTe/CdS based thin film solar cell efficiency at various operational temperatures

2021 ◽  
Vol 24 (1) ◽  
pp. 70
Author(s):  
Omar Ghanim Ghazal ◽  
Ahmed Waleed Kasim ◽  
Nabeel Zuhair Tawfeeq
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Structural Parameters ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Window Layer ◽  
The Impact

Cadmium telluride (CdTe)/cadmium sulfide (CdS) solar cell is a promising candidate for photovoltaic (PV) energy production, as fabrication costs are compared by silicon wafers. We include an analysis of CdTe/CdS solar cells while optimizing structural parameters. Solar cell capacitance simulator (SCAPS)-1D 3.3 software is used to analyze and develop energy-efficient. The impact of operating thermal efficiency on solar cells is highlighted in this article to explore the temperature dependence. PV parameters were calculated in the different absorber, buffer, and window layer thicknesses (CdTe, CdS, and SnO2). The effect of the thicknesses of the layers, and the fundamental characteristics of open-circuit voltage, fill factor, short circuit current, and solar energy conversion efficiency were studied. The results showed the thickness of the absorber and buffer layers could be optimized. The temperature had a major impact on the CdTe/CdS solar cells as well. The optimized solar cell has an efficiency performance of >14% when exposed to the AM1.5 G spectrum. CdTe 3000 nm, CdS 50 nm, SnO2 500 nm, and (at) T 300k were the I-V characteristics gave the best conversion open circuit voltage (Voc)=0.8317 volts, short circuit current density (Jsc)=23.15 mA/cm2, fill factor (FF)%=77.48, and efficiency (η)%=14.73. The results can be used to provide important guidance for future work on multi-junction solar cell design.

scholarly journals Precise fluorination of polymeric donors towards efficient non-fullerene organic solar cells with enhanced open circuit voltage, short circuit current and fill factor

2021 ◽  
Author(s):  
Xiaosha Wang ◽  
Honggang Chen ◽  
Jun Yuan ◽  
Qingya Wei ◽  
Jing Li ◽  
...  
Keyword(s):  
Solar Cells ◽  
Energy Level ◽  
Organic Solar Cells ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Chemical Structures ◽  
Similar Chemical

Three polymer donors named Qx-8F, Qx-10F, and Qx-12F, with similar chemical structures, was synthesized. The energy level of these donors is manipulated by precisely controlling the fluorination sites. We demonstrate...

Solar Cells from Mixed SiCi2H2 and SiH4 Plasmas

1997 ◽  
Vol 467 ◽  
Author(s):  
A. M. Payne ◽  
B. K. Crone ◽  
S. Wagner
Keyword(s):  
Solar Cells ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Boron Doped ◽  
Phosphorus Doped ◽  
Defect Densities

ABSTRACTWe have deposited and analyzed solar cells from mixed SiCI2H2/SiH4 plasmas. Intrinsic and doped films were also grown to explain the cell results. The SiCI2H2 cells have lower fill factor and short circuit current density than the SiH4 cells due to the higher defect densities and lower photoconductivities of SiCI2H2/SiH4 material. Cell results showed low VQC if the n-layer was in contact with an i-layer deposited from SiCI2H2/SiH4. A pure silane buffer layer between the i- and n-layers was needed to attain the standard open circuit voltage. The reduced Voc results from a reduced conductivity of phosphorus-doped SiCI2H2/SiH4 material. However, comparison of doped films showed higher conductivities for boron-doped material grown from the SiCI2H2/SiH4 mixture than from pure silane.

Sign in / Sign up

Export Citation Format

Share Document