Ni0.1Co0.9Fe2O4 spinel ferrite as a promising magneto-dielectric substrate for X-band Microstrip Patch Antenna

2020 ◽  
Vol 1 (2) ◽  

A wideband circular microstrip patch antenna (CMPA) has been presented employing a rectangular metal sheet superstrate. The proposed concept follows a unique, simple, and a flexible design approach to enhance the bandwidth of a circular patch. A simple change in the conventional antenna geometry has been suggested by adding a rectangular metal sheet superstrate, placed symmetrically above the patch. A cylindrical shaped foam spacer has been used to provide mechanical support to the optimized superstrate. The proposed antenna offers about 36% of impedance matching bandwidth ranging between 8.46 GHz to 12.06 GHz with a total bandwidth of 3.6 GHz. Whereas, a conventional circular patch, resonating at 9.96 GHz, hardly shows about 4.8% of impedance bandwidth (480 MHz) only. In addition to the enhanced bandwidth characteristics, the proposed antenna, also reveals a little increase in the gain throughout the operating frequency band. For the experimental validation, a set of antenna prototype has been fabricated using the commercially available dielectric substrate. The measured result is very closely agreed with the simulated predictions.


Author(s):  
Neha Afreen

Abstract: In the present work an attempt has been made to design and simulation of rectangular microstrip patch antenna with triple slot for X band using microstrip feed line techniques. HFSS High frequency simulator is used to analyse the proposed antenna and simulated the result on the return loss, radiation pattern and gain of the proposed antenna. The antenna is able to achieve in the range of 8-12 GHz for return loss of less than -10 dB. The operating frequency of the proposed antenna is 8.4 GHz & 11 GHz with dielectric substrate, ARLON of = 2.5 and h= 1.6mm. Keywords: ARLON substrate material, FEM, Microstrip Feed Line, X band


2018 ◽  
Vol 11 (19) ◽  
pp. 1-4
Author(s):  
V. Keral Shalini ◽  
M. Annakamatchi ◽  
S. Arthireena ◽  
◽  
◽  
...  

2021 ◽  
Author(s):  
Vijaya Mahesh Jangam ◽  
Tadiparthi Vijay Ganesh ◽  
Palivela Venkata Naga Raviteja

2018 ◽  
Vol 7 (2.6) ◽  
pp. 168
Author(s):  
Madhukant Patel ◽  
Veerendra Singh Jadaun ◽  
Kanhiya Lal ◽  
Piyush Kuchhal

This paper presents design a High Gain Small Size Microstrip Patch Antenna for X-Band applications such as Moving target RADAR sensor, Motion detector, Microwave camera, Ground Penetration RADAR sensors, wall penetration scanners and many medical applications. Now we have to selected circular geometry of micro strip patch antenna because circular geometry overcomes edge effect of antenna. The proposed antenna is designed to operate for X-band at the centre frequency of 10 GHz. The proposed Circular patch antenna is compact and easy to body mount with a high efficiency. The compactness makes it a better choice as compare with other antenna in the X-band. The proposed antenna shows a very sharp return loss of -46 dB at 10 GHz having narrow pattern with a good gain of 4.7 dBi. This enables its use in high directional applications. The paper represents the designing steps, and the simulation result obtained. The software used here for this circular shaped microstrip antenna is IE3D. Various parameters such as gain, power, radiation pattern, and S11 of the antenna are mentioned.


2018 ◽  
Vol 7 (2.7) ◽  
pp. 532 ◽  
Author(s):  
R Siri Chandana ◽  
P Sai Deepthi ◽  
D Sriram Teja ◽  
N Veera JayaKrishna ◽  
M Sujatha

This article is about a single band microstrip patch antenna used for the 5G applications. And this antenna is suitable for the millimeter wave frequency. The patch antenna design consists of 2 E shaped slots and 1 H shaped slot. These slots are loaded on the radiating patch with the 50 ohms microstrip feed line. For the simulation purpose, Rogers’s RT5880 dielectric substrate with relative permittivity of 2.2 and loss tangent of 0.0009 is used. The design and simulation of the antenna is done using HFSS (High Frequency Structure Simulator) software. The results are simulated for the parameters Return loss, VSWR, 3D Radiation pattern. The proposed antenna has a return loss of -42.4383 at 59 GHz millimeter wave frequency. 


Sign in / Sign up

Export Citation Format

Share Document